1、AEROSPACE MATERIAL SPECIFICATIONAMS3898/2 REV. BIssued 1975-06Revised 1994-02Reaffirmed 2014-08Superseding AMS3898/2AInterleaf Carrier Material, Composite TapePolyethylene Film,0.0018 inch (0.046 mm), UnperforatedRATIONALEAMS3898/2B has been reaffirmed to comply with the SAE five year review policy.
2、SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising theref
3、rom, is the sole responsibility of the user.”SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions.Copyright 2014 SAE InternationalAll rights reserved. No part of this publi
4、cation may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE.TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada)Tel: +1 724-776-4970 (out
5、side USA)Fax: 724-776-0790Email: CustomerServicesae.orgSAE WEB ADDRESS: http:/www.sae.orgSAE values your input. To provide feedbackon this Technical Report, please visithttp:/www.sae.org/technical/standards/AMS3898/2B1. SCOPE:1.1 Form:This specification covers one type of polyethylene film in the fo
6、rm of rollsof sheeting or reels of unperforated tape of the width specified.2. APPLICABLE DOCUMENTS:See AMS 3898.3. TECHNICAL REQUIREMENTS:3.1 Basic Specification:The complete requirements for procuring the product described herein shallconsist of this document and the latest issue of the basic spec
7、ification,AMS 3898.3.2 Material:The carrier material shall be polyethylene film.3.2.1 Thickness:Shall be 0.0018 inch 0.0003 (0.046 mm 0.008).3.2.2 Width: Shall be as ordered.3.3 Properties:Shall be as shown in Table 1.SAE INTERNATIONAL AMS3898/2B Page 2 of 2 TABLE 1 PropertiesParagraph Property Requ
8、irement Test Method3.3.1 Tensile Strength, minimum 25 pounds forceper inch(4.38 kN/m) of widthASTM D 882,Method A3.3.2 Tear Strength, minimum 0.5 ounce force(139 mN)ASTM D 827-714. QUALITY ASSURANCE PROVISIONS:See AMS 3898.5. PREPARATION FOR DELIVERY:See AMS 3898.6. ACKNOWLEDGEMENT:See AMS 3898.7. REJECTIONS:See AMS 3898.8. NOTES:See AMS 3898.
