1、 AEROSPACE STANDARD PLUG, MACHINE THREAD AMS 5646, METAL GASKET, REDUCED DIAMETER THREAD AS3000Copyright 2015 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photoc
2、opying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1963-06REAFFIRMED2015-04THIR
3、D ANGLE PROJECTION CUSTODIAN: E-25 FEDERAL SUPPLY CLASS AS3000 SHEET 1 OF 3 SAE Technical Standards Board Rules provide that: “This report ispublished by SAE toadvance thestate of technicalandengineering sciences. Theuse ofthisreport is entirelyvoluntary, andits applicability and suitability forany
4、particularuse,including any patent infringement arising therefrom, isthe soleresponsibilityofthe user.”SAE reviews eachtechnicalreport at least every five years at which time itmay berevised,reaffirmed, stabilized, orcancelled. SAE invites yourwrittencomments andsuggestions. SAE values your input. T
5、o provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS3000 RATIONALE AS3000 HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY. AEROSPACE STANDARD AS3000 SHEET 2 OF 3 PLUG, MACHINE THREAD AMS 5646, METAL GASKET, REDUCED DIAMETER THREAD TABLE
6、 1AEROSPACE STANDARD AS3000 SHEET 3 OF 3 PLUG, MACHINE THREAD AMS 5646, METAL GASKET, REDUCED DIAMETER THREAD NOTES:1. 1.HEXAGON SHALL BE CONCENTRIC WITH THREAD PD WITHIN J FIR.2. 2.DIAMETER H SHALL BE CONCENTRIC WITH THREAD PD WITHIN .005 FIR.3. 3.MATERIAL: CORROSION AND HEAT RESISTANT STEEL AMS 56
7、46.4. 4.SURFACE ROUGHNESS: AS291. UNLESS OTHERWISE SPECIFIED SURFACES TO BE 125 MICROINCHES.5. 5.PARTS SUBJECT TO FLUORESCENT PENETRANT INSPECTION PER AMS 2645.6. 6.BREAK SHARP EDGES .003-.015 UNLESS OTHERWISE SPECIFIED.7. 7.DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: LINEAR DIMENSIONS .010, ANGULAR DIMENSIONS 5.8. 8.DO NOT USE UNASSIGNED PART NUMBERS.
