1、 AEROSPACE STANDARD FITTING, TEE, FLARED TO PIPE ON RUN AS5198Copyright 2015 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
2、without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 1999-04REVISED 2005-01 REAFFIRMED 2015-04THIRD ANGLE PROJECTI
3、ON CUSTODIAN: G-3/G-3B REV.C FEDERAL SUPPLY CLASS 4730AS5198 SHEET 1 OF 4 REV. C PROCUREMENT SPECIFICATION: /4/ AS4842/1SAE Technical Standards Board Rules provide that: “This report ispublishedby SAE toadvance thestate of technicalandengineering sciences. Theuse ofthisreportis entirelyvoluntary, an
4、dits applicability and suitability forany particular use,including any patent infringement arising therefrom, is thesole responsibilityoftheuser.”SAE reviews eachtechnicalreport at least every five years at which time itmay berevised,reaffirmed, stabilized, orcancelled. SAE invites yourwrittencommen
5、ts andsuggestions. SAE values your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS5198C RATIONALE AS5198C HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE FIVE-YEAR REVIEW POLICY. FIGURE 1 FITTING, TEE TABLE 1 DIMENSIONS BASIC NO. AS5198 /17/ SIZE
6、CODE (NOMINAL TUBE SIZE) PORT #1 REQUIREMENTS PER ASME B46.1. UNLESS OTHERWISE SPECIFIED, MACHINED SURFACES TO BE 125 in Ra. FORGED SURFACES MAY BE 250 in Ra. 13. BREAK EDGES .003 TO .015 UNLESS OTHERWISE SPECIFIED. AEROSPACE STANDARD AS5198 SHEET 4 OF 4 REV. C FITTING, TEE, FLARED TO PIPE ON RUN 14
7、 DIMENSIONING AND TOLERANCING: ASME Y14.5M-1994. 15. DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: LINEAR DIMENSIONS .023, ANGULAR DIMENSIONS 030. /16/ THIS DOCUMENT INCLUDES CADMIUM AS A PLATING MATERIAL. THE USE OF CADMIUM HAS BEEN RESTRICTED AND/OR BANNED FOR USE IN MANY COUNTRIE
8、S DUE TO ENVIRONMENTAL AND HEALTH CONCERNS. THE USER SHOULD CONSULT WITH LOCAL OFFICIALS ON APPLICABLE HEALTH AND ENVIRONMENTAL REGULATIONS REGARDING ITS USE. /17/ EXAMPLE OF PART NUMBER: AS5198 W 08 06 08 VTHE FINISH CODE LETTER “V” WILL BE PLACED BASIC PART NUMBER HERE ONLY FOR MATERIAL CODE LETTE
9、R “W” PARTS THAT ARE TO BE COATED WITH MATERIAL CODE LETTER /1/ HIGH PURITY ALUMINUM SIZE CODE, TUBE SIZE SIZE CODE, TUBE SIZE OF PORT #3 OF PORT #1 IN .062 INCREMENTS IN .062 INCREMENTS SIZE CODE, TUBE SIZE OF PORT #2 IN .062 INCREMENTS /18/ PART NUMBERS WITH MATERIAL CODE LETTER D ARE INACTIVE FOR NEW DESIGN AS OF 2001-01. USE PART NUMBERS WITH W MATERIAL CODE LETTER FOR NEW DESIGN.
