1、Printed in the U.S.A.SAETechnicalStandardsBoardRulesprovidethat:“ThisreportispublishedbySAEtoadvancethestateoftechnicalandengineeringsciences.Theuseofthisreportisentirelyvoluntary,anditsapplicabilityandsuitabilityforanyparticularuse,includinganypatentinfringementarisingtherefrom,isthesoleresponsibil
2、ityoftheuser.”SAEreviewseachtechnicalreportatleasteveryfiveyearsatwhichtimeitmaybereaffirmed,revised,orcancelled.SAEinvitesyourwrittencommentsandsuggestions.SHEET 1 OF 4AS7768/1THIRD ANGLE PROJECTIONAEROSPACE STANDARDAS7768/1ISSUED 1998-08LIGHT, DESK, AIRCRAFTPREPARED BY SUBCOMMITTEE A-20AFEDERAL SU
3、PPLY CLASS 6230NOTICETHIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-L-7768/1(AS) AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIRED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL RELEASE OF THIS DOCUMENT IS
4、 INTENDED TO REPLACE MIL-L-7768/1(AS). ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED.THE ORIGINAL MILITARY SPECIFICATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 001) PERTAINING TO ACCELERA
5、TED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICATIONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION OR STANDARD FORMAT.UNDER D
6、EPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTRACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS SAE TECHNICAL DOCUMENT.REAFFIRMED 2005
7、-09Copyright 2005 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOC
8、UMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sae.org Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license fr
9、om IHS-,-,-LIGHT, DESK, AIRCRAFTAEROSPACE STANDARD AS7768/1SHEET 2 OF 4AS7768/1Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-LIGHT, DESK, AIRCRAFTAEROSPACE STANDARD AS7768/1SHEET 3 OF 4AS7768/1TABL
10、E IPART NUMBER: CONSISTS OF THE BASIC NUMBER OF THIS SPECIFICATION SHEET, PRECEDED BY THE LETTER “M”, AND A DASH NUMBER TAKEN FROM TABLE I.EXAMPLE:M7768/1-1MIL-L-7768/1(AS) SUPERSEDES AN3047 FOR NAVY USE.LAMP: EACH LIGHT ASSEMBLY SHALL BE DESIGNED TO USE ANY ONE OF THE LAMPS LISTED IN TABLE II.Copyr
11、ight SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-LIGHT, DESK, AIRCRAFTAEROSPACE STANDARD AS7768/1SHEET 4 OF 4AS7768/1TABLE IICopyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
