1、AEROSPACE STANDARD CONNECTOR, ELECTRIC, RECTANGULAR, INDIVIDUAL CONTACTSEALING, POLARIZED CENTER JACKSCREW, REPLACEMENT TOOL, WIRE SEAL, SIZE 16, CRIMP REMOVABLE CONTACTSAS85028/6Copyright 2010 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieva
2、l system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerS
3、ervicesae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 2004-06REVISED 2010-11THIRD ANGLE PROJECTION CUSTODIAN: AE-8/AE-8C1 REV.AFEDERAL SUPPLY CLASS 5935 AS85028/6SHEET 1 OF 1REV. APROCUREMENT SPECIFICATION: AS85028SAE Technical Standards Board Rules provide that: “This report ispublishedby SAE toa
4、dvance thestate of technicalandengineering sciences. Theuse ofthis report is entirely voluntary, andits applicability and suitability forany particular use,including any patent infringement arising therefrom, isthe soleresponsibilityofthe user.”SAE reviews eachtechnicalreport at least every five yea
5、rs at which time itmay bereaffirmed, revised, orcancelled. SAE invites yourwrittencomments andsuggestions. SAE values your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS85028/6ARATIONALE LIMITED SCOPE REVISION REQUIRED TO INCORPORATE AS85028
6、/6-A1. NOTICE THE REQUIREMENTS FOR PROCURING THE TOOL DESCRIBED HEREIN SHALL CONSIST OF THIS SPECIFICATION SHEET AND THE LATEST ISSUE OF AS85028. FIGURE 1 AS85028/2 CONFIGURATION NOTES: 1. DIMENSIONS ARE IN INCHES. 2. A CHANGE BAR (|) LOCATED IN THE LEFT MARGIN IS FOR THE CONVENIENCE OF THE USER IN
7、LOCATING AREAS WHERE TECHNICAL REVISIONS, NOT EDITORIAL CHANGES HAVE BEEN MADE TO THE PREVIOUS ISSUE OF THIS DOCUMENT. AN (R) SYMBOL TO THE LEFT OF THE DOCUMENT TITLE INDICATES A COMPLETE REVISION OF THE DOCUMENT, INCLUDING TECHNICAL REVISIONS. CHANGE BARS AND (R) ARE NOT USED IN ORIGINAL PUBLICATIONS NOR IN DOCUMENTS THAT CONTAIN EDITORIAL CHANGES ONLY. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
