1、 AEROSPACE STANDARD CONNECTOR ACCESSORIES, FIBER OPTIC BACKSHELLS FILLER PLUG, CATEGORY 7 AS85049/134 Copyright 2005 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical,
2、 photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 2005-09THIRD ANGLE PROJECTION CU
3、STODIAN: SAE AE-8/AE-8C1 FEDERAL SUPPLY CLASS5935 AS85049/134SHEET 1 OF 2 SAE TechnicalStandards Board Rules provide that: “This report is published by SAE toadvance thestate of technical andengineering sciences. Theuse of thisreport is entirely voluntary, andits applicabilityandsuitability forany p
4、articularuse,including any patent infringement arising therefrom, is thesole responsibility oftheuser.” SAE reviews each technical report at least every five yearsat which time it may be reaffirmed, revised, orcancelled.SAE invites yourwritten commentsandsuggestions.THE REQUIREMENTS FOR ACQUIRING TH
5、E ACCESSORIES DESCRIBED HEREIN SHALL CONSIST OF THIS SPECIFICATION AND THE LATEST ISSUE OF SAE AS85049. FIGURE 1 - DIMENSION AND CONFIGURATION NOTES: 1. DIMENSIONS ARE IN INCHES. 2. METRIC EQUIVALENTS ARE GIVEN FOR GENERAL INFORMATION ONLY AND ARE BASED ON 25.4 MM = 1 INCH. 3. THE NUMBER OF MILLIMET
6、ERS IS GIVEN IN PARENTHESES. 4. SEALING PLUGS TO BE BULK PACKAGED AND IDENTIFIED IN ACCORDANCE WITH SAE AS85049. 5. FOR USE WITH: SAE AS85049/131, /132, /133, /135, /136, & /137 BACKSHELLS. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking
7、permitted without license from IHS-,-,-AEROSPACE STANDARD CONNECTOR ACCESSORIES, FIBER OPTIC BACKSHELLS FILLER PLUG, CATEGORY 7 AS85049/134 AS85049/134SHEET 2 OF 2 REQUIREMENTS: DESIGN AND CONSTRUCTION: 1. DIMENSIONS AND CONFIGURATION: SEE FIGURE 1. 2. PLASTIC ROD, MOLDED, EXTRUDED, OR MACHINED TO M
8、EET 200C MINIMUM TEMPERATURE. COLOR BLACK, IN ACCORDANCE WITH EIA359. PART NUMBER: SEE EXAMPLE BELOW: QUALIFICATION: 1. SEE SAE AS85049, CATEGORY 7. 2. MATERIAL CERTIFICATIONS REQUIRED. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
