1、 AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-COMPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/11 Copyright 2004 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any
2、 form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.s
3、ae.org ISSUED 2004-06THIRD ANGLE PROJECTION CUSTODIAN: SAE AE-8/AE-8D FEDERAL SUPPLY CLASS6145 AS85485/11SHEET 1 OF 3 PROCUREMENT SPECIFICATION: MIL-C-85485SAE TechnicalStandards Board Rules provide that: “This report is published by SAE toadvance thestate of technical andengineering sciences. Theus
4、e of thisreport is entirely voluntary, andits applicabilityandsuitability forany particularuse,including any patent infringement arising therefrom, is thesole responsibility oftheuser.” SAE reviews each technical report at least every five yearsat which time it may be reaffirmed, revised, orcancelle
5、d.SAE invites yourwritten commentsandsuggestions. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-85485/11 AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIRED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE I
6、NITIAL RELEASE OF THIS DOCUMENT IS INTENDED TO REPLACE MIL-C-85485/11. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIFICATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS
7、 (TSB 001) PERTAINING TO ACCELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICATIONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFI
8、CATION OR STANDARD FORMAT. UNDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTRACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS TECH
9、NICAL REPORT. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-COMPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT A
10、S85485/11 AS85485/11SHEET 2 OF 3 FIGURE 1. TYPICAL CONFIGURATION RATINGS: TEMPERATURE RATING: 150C (302F) MAXIMUM CONTINUOUS CONDUCTOR TEMPERATURE. VOLTAGE RATING: 600 VOLTS (RMS) AT SEA LEVEL. ADDITIONAL REQUIREMENTS: ATTENUATION (INSERTION LOSS): THE CABLE OF THIS SPECIFICATION SHEET MEETS THE ATT
11、ENUATION REQUIREMENTS FOR THE APPLICABLE WIRE SIZE AND NUMBER OF COMPONENTS WHEN SHIELDED IN ACCORDANCE WITH M85485/12-*. CONSULT QPL SOURCE FOR DETAILS. INSULATION FLAWS: SPARK TEST - 3.0 KILOVOLTS (RMS), 60 HZ IMPULSE DIELECTRIC TEST - 8.0 KILOVOLTS (PEAK) THERMAL STABILITY: 1250 HOURS AT 180 3C (
12、356 5F). THE CABLE OF THIS SPECIFICATION SHEET, WHEN SHIELDED IN ACCORDANCE WITH M85485/12-*, SHALL MEET THE VOLTAGE WITHSTAND (DIELECTRIC) OF 1500 VOLTS (RMS), 60 HZ, AND THE STOP BAND ATTENUATION REQUIREMENTS FOR THE APPLICABLE COMPONENT WIRE SIZE AND NUMBER OF COMPONENTS. CONSULT QPL SOURCE FOR D
13、ETAILS. VOLTAGE WITHSTAND (DIELECTRIC): CONDUCTOR TO CONDUCTOR, 1500 VOLTS (RMS), 60 HZ TABLE I. CONSTRUCTION DETAILS Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRI
14、C, FILTER LINE, UNSHIELDED, UNJACKETED, MULTIPLE-COMPONENT, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/11 AS85485/11SHEET 3 OF 3 APPLICATION NOTE: THE COMPONENT WIRES IN THESE CONSTRUCTIONS ARE EFFECTIVE RADIO FREQUENCY ABSORPTIVE WIRES ONLY WHEN USED AS COMPONENTS IN A SHIELDED CABLE. QUALIFYING ACTIVITY: THE ACTIVITY RESPONSIBLE FOR THIS QUALIFIED PRODUCTS LIST IS THE NAVAL AIR SYSTEMS COMMAND, WASHINGTON, D.C. 20361. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
