1、 AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, SHIELDED, JACKETED, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/8 Copyright 2004 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, el
2、ectronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: custsvcsae.org SAE WEB ADDRESS: http:/www.sae.org ISSUED 2004-06THIR
3、D ANGLE PROJECTION CUSTODIAN: SAE AE-8/AE-8D FEDERAL SUPPLY CLASS6145 AS85485/8SHEET 1 OF 4 PROCUREMENT SPECIFICATION: MIL-C-85485SAE TechnicalStandards Board Rules provide that: “This report is published by SAE toadvance thestate of technical andengineering sciences. Theuse of thisreport is entirel
4、y voluntary, andits applicabilityandsuitability forany particularuse,including any patent infringement arising therefrom, is thesole responsibility oftheuser.” SAE reviews each technical report at least every five yearsat which time it may be reaffirmed, revised, orcancelled.SAE invites yourwritten
5、commentsandsuggestions. NOTICE THIS DOCUMENT HAS BEEN TAKEN DIRECTLY FROM U.S. MILITARY SPECIFICATION MIL-C-85485/8 AND CONTAINS ONLY MINOR EDITORIAL AND FORMAT CHANGES REQUIRED TO BRING IT INTO CONFORMANCE WITH THE PUBLISHING REQUIREMENTS OF SAE TECHNICAL STANDARDS. THE INITIAL RELEASE OF THIS DOCU
6、MENT IS INTENDED TO REPLACE MIL-C-85485/8. ANY PART NUMBERS ESTABLISHED BY THE ORIGINAL SPECIFICATION REMAIN UNCHANGED. THE ORIGINAL MILITARY SPECIFICATION WAS ADOPTED AS AN SAE STANDARD UNDER THE PROVISIONS OF THE SAE TECHNICAL STANDARDS BOARD (TSB) RULES AND REGULATIONS (TSB 001) PERTAINING TO ACC
7、ELERATED ADOPTION OF GOVERNMENT SPECIFICATIONS AND STANDARDS. TSB RULES PROVIDE FOR (A) THE PUBLICATION OF PORTIONS OF UNREVISED GOVERNMENT SPECIFICATIONS AND STANDARDS WITHOUT CONSENSUS VOTING AT THE SAE COMMITTEE LEVEL, AND (B) THE USE OF THE EXISTING GOVERNMENT SPECIFICATION OR STANDARD FORMAT. U
8、NDER DEPARTMENT OF DEFENSE POLICIES AND PROCEDURES, ANY QUALIFICATION REQUIREMENTS AND ASSOCIATED QUALIFIED PRODUCTS LISTS ARE MANDATORY FOR DOD CONTRACTS. ANY REQUIREMENT RELATING TO QUALIFIED PRODUCTS LISTS (QPLS) HAS NOT BEEN ADOPTED BY SAE AND IS NOT PART OF THIS TECHNICAL REPORT. Copyright SAE
9、International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, SHIELDED, JACKETED, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/8 AS85485/8SHEET 2 OF 4 FIGURE 1. TYPICAL CON
10、FIGURATION. RATINGS: TEMPERATURE RATING: 150C (302F) MAX CONTINUOUS CONDUCTOR TEMPERATURE VOLTAGE RATING: 600 VOLTS (RMS) AT SEA LEVEL ADDITIONAL REQUIREMENTS: ATTENUATION (INSERTION LOSS): CONSULT QPL SOURCE FOR DETAILS BLOCKING: 200 3C (392 5F) FOR 6 HOURS COLOR STRIPING DURABILITY: 125 CYCLES (25
11、0 STROKES) (MIN), 500 GRAMS WEIGHT CROSSLINKING PROOF TEST: 7 HOURS AT 300 3C (572 5F) FLAMMABILITY: 3 SECONDS (MAX); 3 INCHES (MAX) IDENTIFICATION DURABILITY: 125 CYCLES (250 STROKES) (MIN), 500 GRAMS WEIGHT IMMERSION: DIAMETER INCREASE 5% (MAX); NO CRACKING OF JACKET JACKET COLOR: BLACK JACKET CON
12、CENTRICITY: 70% (MIN) JACKET ELONGATION AND TENSILE STRENGTH: ELONGATION, 50% (MIN) TENSILE STRENGTH, 3500 LBF/IN2(MIN) JACKET FLAWS: NOT APPLICABLE LIFE CYCLE: 168 HOURS AT 200 3C (392 5F) LOW TEMPERATURE-COLD BEND: -65 2C (-85 4F) FOR 4 HOURS SHIELD COVERAGE AND ANGLE: 85% (MIN) COVERAGE; 18 (MIN)
13、, 40 (MAX) ANGLE SHIELD SIZE: 38 AWG ROUND WIRE STRANDS SURFACE TRANSFER IMPEDANCE, EFFECTIVE: CONSULT QPL SOURCE FOR DETAILS THERMAL SHOCK: OVEN TEMPERATURE, 150 3C (302 75F) MAX. CHANGE IN MEASUREMENTS, 0.125 INCH Copyright SAE International Provided by IHS under license with SAENot for ResaleNo r
14、eproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, SHIELDED, JACKETED, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/8 AS85485/8SHEET 3 OF 4 THERMAL STABILITY: 1250 HOURS AT 180 3C (356 5F) VOLTAGE WITHSTAND (DIELECTRIC) - NO BREAKD
15、OWN; SHALL MEET STOP BAND ATTENUATION REQUIREMENTS FOR THE APPLICABLE COMPONENT WIRE SIZE AND NUMBER OF COMPONENTS. CONSULT QPL SOURCE FOR DETAILS. VOLTAGE WITHSTAND (DIELECTRIC): CONDUCTOR TO SHIELD 1500 VOLTS (RMS) 60 HZ VOLTAGE WITHSTAND (POST-ENVIRONMENTAL): NOT APPLICABLE TABLE I. CONSTRUCTION
16、DETAILS. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-AEROSPACE STANDARD CABLE, ELECTRIC, FILTER LINE, SHIELDED, JACKETED, RADIO FREQUENCY ABSORPTIVE, 150C, 600-VOLT AS85485/8 AS85485/8SHEET 4 OF
17、4 FIGURE 2. SURFACE TRANSFER IMPEDANCE, EFFECTIVE. ENGINEERING REFERENCE CURVE APPLICATION NOTE: THE COMPONENT WIRES OF M85485/8 ARE COMPATIBLE WITH ALL STANDARD CONNECTOR AND CONTACT TYPES, EXCEPT THAT THE PRIMARY JACKET DIAMETERS OF M85485/5-22 COMPONENT WIRES EXCEED THE ALLOWABLE DIAMETER FOR MIL
18、-C-38999 SIZE 22D CONTACTS. HOWEVER, THESE COMPONENT WIRES CAN BE TERMINATED TO SIZE 22D CONTACTS IF THE PRIMARY JACKET AND FILTER LAYER ARE STRIPPED IN THE GROMMET AREA, LEAVING THE PRIMARY INSULATION INTACT. QUALIFYING ACTIVITY: THE ACTIVITY RESPONSIBLE FOR THIS QUALIFIED PRODUCTS LIST IS THE NAVAL AIR SYSTEMS COMMAND, WASHINGTON, D.C. 20361. Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
