1、SURFACEVEHICLERECOMMENDEDPRACTICEJ1248REAF.JUN2010Issued 1983-05Reaffirmed 2010-06Superseding J1248 NOV2002Performance Requirements for Parking Stability of Motorcycles1. ScopeThis SAE Recommended Practice presents performance requirements for the parking stability of two-wheeled motorcycles intende
2、d for highway use.2. References2.1 Applicable PublicationThe following publications form a part of this specification to the extent specifiedherein. Unless otherwise indicated, the latest issue of SAE publications shall apply.2.1.1 SAE PUBLICATIONAvailable from SAE, 400 Commonwealth Drive, Warrendal
3、e, PA 15096-0001.SAE J1101Test Procedures for Parking Stability of Motorcycles3. Performance RequirementsWhen tested according to SAE J1101, the motorcycle shall meet the followingrequirements:3.1 Maximum Pressure on the Parking Surface3.1.1 SIDE STAND700 kPa (100 lbf/in2).3.1.2 CENTER STAND700 kPa
4、100 lbf/in2).3.2 Minimum Required Tip Over AngleSee Figure 1.3.3 Minimum Required Roll Off AngleSee Figure 2.SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, a
5、nd its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written c
6、omments and suggestions. Copyright 2010 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission
7、of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: +1 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/techni
8、cal/standards/J1248_201006 Copyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE J1248 Reaffirmed JUN2010-2-FIGURE 1TIP OVER CONFIGURATIONCopyright SAE International Provided by IHS under license with
9、SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-SAE J1248 Reaffirmed JUN2010-3-FIGURE 2ROLL OFF CONFIGURATIONPREPARED BY THE SAE MOTORCYCLE COMMITTEECopyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking per
10、mitted without license from IHS-,-,-SAE J1248 Reaffirmed JUN2010RationaleNot applicable.Relationship of SAE Standard to ISO StandardNot applicable.ApplicationThis SAE Recommended Practice presents performance requirements for the parking stabilityof two-wheeled motorcycles intended for highway use.Reference SectionSAE J1101Test Procedures for Parking Stability of MotorcyclesDeveloped by the SAE Motorcycle CommitteeCopyright SAE International Provided by IHS under license with SAENot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
