SANS 60227-1-2006 Polyvinyl chloride insulated cables of rated voltages up to and including 450 750 V Part 1 General requirements《额定电压不超过450 750V的聚氯乙烯绝缘电缆 第1部分：一般要求》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

FORD WSD-M2C904-A-2009 OIL - ENGINE SAE 10W-30 API SG CD INITIAL FILL TO BE USED WITH FORD WSS-M99P1111-A 《初始注入的SAE 10W-30 API SG CD发动机油 与标准FORD WSS-M99P1111-A一起使用 》.pdf

FORD WSD-M2C904-B-2009 OIL - ENGINE SAE 10W-30 API SG CD CONTROLLED VISCOSITY INITIAL FILL TO BE USED WITH FORD WSS-M99P1111-A 《初始注入的、粘度控制的SAE 10W-30 API SG CD发动机油 与标准FORD WSS-M.pdf

FORD WSD-M2D243-A2-2014 POLYURETHANE (PUR) FOAM FLAME BONDABLE TO BE USED WITH FORD WSS-M99P1111-A .pdf

FORD WSD-M2D243-A4-2010 POLYURETHANE (PUR) FOAM FLAME BONDABLE TO BE USED WITH FORD WSS-M99P1111-A 《可火烧粘合的聚氨酯（PUR）泡沫 与标准FORD WSS-M99P1111-A一起使用 》.pdf

FORD WSD-M2D243-A5-2010 POLYURETHANE (PUR) FOAM FLAME BONDABLE TO BE USED WITH FORD WSS-M99P1111-A 《可火烧粘合的聚氨酯（PUR）泡沫 与标准FORD WSS-M99P1111-A一起使用 列于标准FORD WSD-M2D243-A4上》.pdf

FORD WSD-M2D249-A3-2010 TUBING SILICONE RUBBER HIGH TEMPERATURE 70 HARDNESS TO BE USED WITH FORD WSS-M99P1111-A 《硬度为70的耐高温硅橡胶管件 与标准FORD WSS-M99P1111-A一起使用 》.pdf

FORD WSD-M2D363-A2-2004 FLUOROELASTOMER (FKM) HIGH HEAT AND COMPRESSION STRESS RELAXATION RESISTANT TO BE USED WITH FORD WSS-M99P1111-A 《耐高温和耐压缩应力松弛的氟橡胶（FKM） 与标准FORD WSS-M99P111.pdf

FORD WSD-M2D363-A2-2016 FLUOROELASTOMER (FKM) HIGH HEAT AND COMPRESSION STRESS RELAXATION RESISTANT TO BE USED WITH FORD WSS-M99P1111-A .pdf

FORD WSD-M2D369-A-2004 POLYACRYLIC (ACM) RUBBER ENGINE OIL AND HIGH HEAT RESISTANT - LOW COMPRESSION SET STATIC SEAL TO BE USED WITH FORD WSS-M99P1111-A 《静密封用低压缩永久变形的耐发动机油和高温的聚丙烯.pdf