SIS SEN 33 05 01-1962 Kitchen fans Determination of capacity and sound levcl《厨房排气扇 容量和声音的测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GMKOREA EDS-A-1018-2008 METHOD OF INDICATING CENTER HOLES (VERSION 4 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for alln.pdf

GMKOREA EDS-A-1020-2008 PREPARING MULTI-DRAWINGS.pdf

GMKOREA EDS-A-1021-2008 DRAWING PRACTICE FOR GEARS (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all futurea.pdf

GMKOREA EDS-A-1022-2008 DRAWING PRACTICE FOR SCREW THREAD (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for alln.pdf

GMKOREA EDS-A-1023-2008 DRAWING PRACTICE FOR BEARINGS (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all futa.pdf

GMKOREA EDS-A-1024-2008 DRAWING PRACTICE FOR SPRINGS (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all futun.pdf

GMKOREA EDS-A-1101-2008 GENERAL TOLERANCES (VERSION 4 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all future project.pdf

GMKOREA EDS-A-1102-2008 SYSTEM OF LIMITS AND FITS (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all future r.pdf

GMKOREA EDS-A-1103-2008 LINEAR AND ANGULAR DIMENSIONS (VERSION 3 Note This standard may be applied only for current project drawings generated by CATIA It is Superceded for all futa.pdf