SIS SS 14 23 38-1984 Stainless steel- SS steel 23 38《不锈钢 SS 不锈钢23 38》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

JUS M F8 013-1990 Atomizing cil bumers Connecting dimensions betv een burners andheatgenerators《燃烧器和加热器间的连接尺寸》.pdf

JUS M G0 100-1991 Acceptance code for machine tools Geometric accuracy of machines operating under no-load or finishing conditions《机床验收规范 无负责或组装完工条件下的操作性的几何精度》.pdf

JUS M G0 101-1991 Acceptance code for machine tools Determination of accuracy and repeatability of positioning of numerically controlled machine tools《机床测试规范 数控机床精确度和定位重复性测试》.pdf

JUS M G0 200-1991 Machine tools Presentation of lubrication instruction《机床 润滑说明》.pdf

JUS M G0 201-1991 Machine tools Lubrication systems《机床，润滑系统》.pdf

JUS M G0 300-1991 Machine tools Cheking instruments for testing machine tools《机床，测试机床用机器仪器》.pdf

JUS M G0 705 1-1995 Machine tools - Tool shanks with 7 24 taper for automatic tool exchanger - Shanks No 40 45 and 50 - Amendment《机床 - 带7124自动工具交换器斜椎的工具弓形垫 弓形垫 No 40，45及 50 修订》.pdf

JUS M G1 102-1991 Acceptance conditions for horizontal spindle capstan turret and single spindle automatic lathes Testing of the accuracy Machinable bar diameters 25 mm or less and.pdf

JUS M G1 135-1994 Acceptance conditions for vertical turning and boring lathes with one or two columns and a single fixed or movable table - General introduction and testing of the.pdf