SIS SS 18 60 40-1991 Anti-rust agents for vehicles Underbody agents Determination of resistance to water spraying《车辆防锈剂 车身底座用剂 抗喷水测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

GOST 13104-1977 Leather raw material Determination of net mass and mass variation due to salting《制革原料 腌透性及净重测定法》.pdf

GOST 13105-1977 Leather raw material Methods of determination of the conservation components《制革原料 储存用的组份测定法》.pdf

GOST 13106-1967 Raw hides Histological and bacteriological control《生皮 组织和细菌控制》.pdf

GOST 13107-1979 Devices for speech reception and transmission Methods of measuring acoustic noeses《语言接收和传输装置 噪声测量方法》.pdf

GOST 13110-1983 Sheet stamping dies Lower plates-blanks for dies with diagonally positioned guide assemblies Construction and dimensions《带对角导柱和衬套的板材冲模用下料板 结构及尺寸》.pdf

GOST 13111-1983 Sheet stamping dies Upper plastic-blanks for dies with diagonally positioned guide assemdlies Design and dimensions《带对角导柱和衬套的板材冲模用上料板 结构及尺寸》.pdf

GOST 13112-1983 Die bases for cold plastic working dies with guide posts rear located Construction and dimensions《带后导柱和衬套的板材冲模用料板 结构及尺寸》.pdf

GOST 13113-1983 Die bases for cold plastic working dies with guide posts located on central line Construction and dimensions《带中间导柱和衬套的板材冲模用料板 结构及尺寸》.pdf

GOST 13114-1975 Die plate without shelves for cold plastic working dies Construction and dimensions《板材冲模用无托架料板 结构及尺寸》.pdf