SIS SS 63 61 39-1985 Information processing systems- Data communication - High-level data link control procedures- Frame structure《信息处理系统，数据通信 高级数据链路控制程序框架结构》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 8002-1955 Metal-cutting Tools Hobs for Spur Gears with Clutch Drive Slot or Keyway Modules 1 to 20《金属切削刀具 带离合器驱动槽或键槽模数为1至20 的正齿轮加工用的滚铣刀 》.pdf

DIN 8010-1963 Carbide Tips for Drills Point Angle 115 for Heavy Loading《钻头用硬质合金刀头 顶角115重载荷》.pdf

DIN 8011-2007 Reamers - Part 2 Technical specifications for shell reamers《铰刀 第2部分 套形铰刀的技术规范》.pdf

DIN 8012-1972 Carbide Inserts for Centre Points《中心点用硬质合金顶尖》.pdf

DIN 8013-1963 Carbide Tips for Drills Point Angle 85 for Light Loading《钻头用硬质合金刀头 顶角85轻载荷》.pdf

DIN 802-3-2016 Tolerances on the threaded portion of taps - Part 3 Ground taps for pipe thread (G) according to DIN EN ISO 228-1 and pipe thread (Rp) according to DIN EN 10226-1 - .pdf

DIN 802-4-2012 Ground thread taps for ISO metric threads of tolerances 7G 8G and special tolerances coarse and fine pitches - Part 4 Manufacturing tolerances on the threaded portio.pdf

DIN 802-5-1997 en 8469 Tolerances on the threaded portion of tape - Part 5 Ground threaded taps for ISO metric thread threads for interference fits according to DIN 8141-1 coarse a.pdf

DIN 802-6-2003 Manufacturing to tolerances on the threaded portion of screwing taps - Part 6 Ground taps for tapped holes (EG) for wire thread inserts as in DIN 8140 for ISO metric.pdf