SIS SS-ISO 5858-1992 Aerospace Self-locking nuts with maximum operating temperature less than or equal to 425 C Procurement specification《航空航天 最高工作温度小于或等于425 C的自锁螺母 采购规范》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NASA NACA-TN-3554-1956 A preliminary investigation of the effects of frequency and amplitude on the rolling derivatives of an unswept-wing model oscillating in roll《频率和振幅对非扫掠机翼模型滚转.pdf

NASA NACA-TN-3583-1955 Charts of boundary-layer mass flow and momentum for inlet performance analysis mach number range 0 2 to 5 0《当马赫数为0 2至5 0时 进气道性能分析边界层质量流和力矩的图表》.pdf

NASA NACA-TN-3607-1956 Effect of thickness camber and thickness distribution on airfoil characteristics at Mach numbers up to 1 0《当马赫数为1 0时 厚度 弧形和厚度分布对机翼特性的影响》.pdf

NASA NACA-TN-3615-1956 An experimental investigation of the scale relations for the impinging water spray generated by a planing surface《平面产生的碰撞喷水数量关系的实验性研究》.pdf

NASA NACA-TN-3663-1956 Discharge coefficients for combustor-liner air-entry holes《燃烧器衬垫进气孔的流量系数》.pdf

NASA NACA-TN-3669-1956 Perforated sheets as a porous material for distributed suction and injection《对于分布式抽吸和注射的作为多孔材料的冲孔薄板》.pdf

NASA NACA-TN-3671-1956 Wind-tunnel investigation of the effect of clipping the tips of triangular wings of different thickness camber and aspect ratio - transonic bump method《使用跨音速.pdf

NASA NACA-TN-3693-1956 Preliminary investigation of the effectiveness of a sliding flap in deflecting a propeller slipstream downward for vertical take-off《对于垂直起飞将螺旋桨滑流偏转向下滑行襟翼有效性的.pdf

NASA NACA-TN-3696-1956 A study of the high-speed performance characteristics of 90 degrees bends in circular ducts《圆形风管内90弯曲高速性能特性的研究》.pdf