SNI 03-2988-1998 Chinesse vitreouse monoblock sitted toilet《中国造玻璃质整体座式洗手间》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ONORM ISO 691-1986 Wrench and socket openings metric series tolerances for general use《扳手和套筒开度 公制系列 通用公差》.pdf

ONORM ISO 6926-1993 Acoustics - Determination of sound power levels of noise sources - Requirements forthe Performance and calibration of reference sound sources《声学 噪声源声功率级测定 基准声源性.pdf

ONORM ISO 697-1986 Surface active agents washing powders determination ofapparent density method by measuring the mass ofa given volume《表面活性剂 洗衣粉 表观密度测定 指定体积的质量测定方法》.pdf

ONORM ISO 6987 Teil 1-1987 Indexable hardmetal (carbide) inserts with rounded corners with partly cylindrical flxing hole dimensions of inserts with 7 normal clearance《带圆角及部分圆柱固定孔的.pdf

ONORM ISO 6987 Teil 2-1991 Indexable inserts for cutting tools - Hardmetal (carbide) inserts with rounded corners with partly cylindrical fixing hole - Part 2 Dimensions of inserts.pdf

ONORM ISO 6987-3-1992 《切削刀具的转位式刀片 带圆角和锥形固定孔的硬金属转位式刀片V 型转位式刀片》.pdf

ONORM ISO 7 Teil 1-1984 Pipe threads where pressure-tight joints are made on the threads Designation dimensions and tolerances《非螺纹密封的管螺纹 命名、尺寸和公差》.pdf

ONORM ISO 7049-1986 Cross recessed pan head tapping screws《十字槽平头自攻螺钉》.pdf

ONORM ISO 7050-1986 Cross recessed countersunk (flat) head tapping screws《十字槽沉头（平头）自攻螺钉》.pdf