SNI ISO 9098 2-2015 Bunk beds for domestic use – Safety requirements and tests – Part 2 Test methods.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS EN ISO 801-1-1995 Pulps Determination of saleable mass in lots Pulp baled in sheet form《纸浆 成批销售质量的测定 板式成捆包装的纸浆》.pdf

BS EN ISO 801-3-1995 Pulps Determination of saleable mass in lots Unitized bales《纸浆 成批销售质量的测定 按统一规格打包》.pdf

BS EN ISO 835-2007 Laboratory glassware - Graduated pipettes《实验室玻璃器皿 刻度移液管》.pdf

BS EN ISO 844-2014 Rigid cellular plastics Determination of compression properties《硬质泡沫塑料 压缩特性测定》.pdf

BS EN ISO 845-2009 Cellular plastics and rubbers - Determination of apparent density (ISO 845 2006)《泡沫塑料和橡胶 表观密度的测定(ISO 845-2006)》.pdf

BS EN ISO 846-1997 Plastics - Evaluation of the action of microorganisms《塑料 微生物作用的评定 》.pdf

BS EN ISO 862-1991 Glossary of terms for surface active agents《表面活性剂术语词汇》.pdf

BS EN ISO 868-2003 Plastics and ebonite - Determination of indentation hardness by means of a durometer (Shore hardness)《塑料和硬质橡胶 用硬度计测定压痕硬度(肖氏硬度)》.pdf

BS EN ISO 877-1-2010 Plastics Methods of exposure to solar radiation General guidance《塑料 暴露在太阳辐射条件下的方法 一般指南》.pdf