TCVN 5406-1991 Corrosion protection Metallic and non-metallic inorganic coatings Accelerate in salt-spray cabinet of acid solution of natrium chloride and copper chloride (method K.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ONORM M 1349-1997 Verification of measuring and test equipment - Testing Instruction for measuring tapes《测量设备和测试设备的检定 测尺的测试说明》.pdf

ONORM M 1362-1984 Edges of workpieces terms indications in drawings《工件边沿 条款，图示说明》.pdf

ONORM M 1365 Teil 1-1990 General tolerances tolerances for linear and angular dimensions without individual tolerance indications above 4000 mm up to 25000 mm《一般公差 4000 mm到25000 mm.pdf

ONORM M 1366-1984 Rough castings deviations for dimensions and machining allowances principles《毛坯铸件 尺寸偏差和切消袷度，原则》.pdf

ONORM M 1368 Teil 1-1978 Rough steel Castings dimensional variations《毛坯钢铸件 尺寸偏差》.pdf

ONORM M 1368 Teil 2-1984 Rough steel castings machining allowances《生钢铸件 机械加工公差》.pdf

ONORM M 1369 Teil 1-1978 Rough castlngs of grey iron dimensional variations《灰口铸铁毛坯铸件 尺寸偏差》.pdf

ONORM M 1369 Teil 2-1984 Rough castings ofgreyiron machining allowances《灰口铸铁毛坯铸件 机械加工公差》.pdf

ONORM M 1370 Teil 1-1978 Rough Castings of cast iron with spheroidal graphite dimensional variations《球墨铸铁毛坯铸件 尺寸偏差》.pdf