TS 3587-1981 DETERMINATION OF THE RESISTANCE OF GLASS TO ATTACK BY 6N HYDROCHLORIC ACID AT 100C《玻璃在100℃条件下抗6N 盐酸攻击的测定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ANSI ASTM D2855-2015 Standard Practice for the Two-Step (Primer and Solvent Cement) Method of Joining Poly (Vinyl Chloride) (PVC) or Chlorinated Poly (Vinyl Chloride) (CPVC) Pipe a.pdf

ANSI ASTM D2859-2016 Standard Test Method for Ignition Characteristics of Finished Textile Floor Covering Materials.pdf

ANSI ASTM D2902-2000 Standard Specification for Fluoropolymer Resin Heat-Shrinkable Tubing for Electrical Insulation《含氟聚合物树脂热缩管件规范(10.02)》.pdf

ANSI ASTM D2903-2011 Standard Specification for Crosslinked Chlorinated Polyolefin Heat-Shrinkable Tubing for Electrical Insulation《电绝缘用交链氯化聚烯烃热缩管规范》.pdf

ANSI ASTM D2924-2012 Standard Test Method for External Pressure Resistance of Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe《耐外部玻璃纤维管的压力试验》.pdf

ANSI ASTM D2925-2014 Standard Test Method for Beam Deflection of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe Under Full Bore Flow.pdf

ANSI ASTM D2949-2010 Standard Specification for 3.25-in Outside Diameter Poly(Vinyl Chloride) (PVC) Plastic Drain Waste and Vent Pipe and Fittings《外径3.25英寸的聚化乙烯塑料排水 排污管和配件规范》.pdf

ANSI ASTM D295-2012 Standard Test Methods for Varnished Cotton Fabrics Used for Electrical Insulation《电绝缘用浸漆棉织物新试验方法》.pdf

ANSI ASTM D2992-2012 Standard Practice for Obtaining Hydrostatic or Pressure Design Basis for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings《玻璃纤维(增强玻璃纤维的.pdf