UIC R 719-1-2011 Recommendations for the use of under ballast mats UBM.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NF E01-051-1978 Shaft heights for driving and driven machines 《传动机和从动机的轴高度》.pdf

NF E02-202-1994 Inspection of tolerances of plain workpieces Limit gauges Tolerances and permissible wear of manufacture limit gauges up to 500 mm 《普通加工件公差的检验 极限规 制造用公差与允许磨损量在500mm.pdf

NF E02-205-1994 Inspection of tolerances of plain workpieces Limit gauges Tolerances and permissible wear of acceptance gauges up to 500 mm 《普通加工件公差的检验 极限规 验收用公差与允充许磨损量在500mm以下的量规》.pdf

NF E02-350-1-1993 General tolerances Part 1 tolerances for linear and angular dimensions without individual tolerance indications 《一般公差 第1部分 未标注单个公差指示的线性尺寸和角尺寸公差》.pdf

NF E02-350-2-1993 General tolerances Part 2 geometrical tolerances for features without individual tolerance indications 《通用公差 第2部分 未注单个公差的零部件的几何公差》.pdf

NF E02-353-2001 Geometrical products specification (GPS) - Chased parts - Dimensional and surface eveness tolerances for dimensions and parts without individual tolerances 《几何产品规范(.pdf

NF E03-001-1999 ISO general purpose screw threads Basic profile Part 1 metric screw threads 《ISO一般用途螺纹 基本剖面图 第1部分 米制螺纹》.pdf

NF E03-013-1999 ISO general purpose metric threads General plan 《ISO一般用途米制螺纹 总图》.pdf

NF E03-014-1999 ISO general purpose metric screw threads Selected sizes for screws bolts and nuts 《ISO一般用途米制螺纹 螺纹、螺栓和螺母的选择尺寸》.pdf