1、 IEC 60598-2-4 Edition 3.0 2017-04 INTERNATIONAL STANDARD Luminaires Part 2-4: Particular requirements Portable general purpose luminaires IEC 60598-2-4:2017-04(en) THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2017 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no par
2、t of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IEC or IECs member National Committee in the country of the requester. If you have any questions about IEC copyri
3、ght or have an enquiry about obtaining additional rights to this publication, please contact the address below or your local IEC member National Committee for further information. IEC Central Office Tel.: +41 22 919 02 11 3, rue de Varemb Fax: +41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerlan
4、d www.iec.ch About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies. About IEC publications The technical content of IEC publications is kept unde
5、r constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published. IEC Catalogue - webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards, Technic
6、al Specifications, Technical Reports and other documents. Available for PC, Mac OS, Android Tablets and iPad. IEC publications search - www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria (reference number, text, technical committee,). It also gives inf
7、ormation on projects, replaced and withdrawn publications. IEC Just Published - webstore.iec.ch/justpublished Stay up to date on all new IEC publications. Just Published details all new publications released. Available online and also once a month by email. Electropedia - www.electropedia.org The wo
8、rlds leading online dictionary of electronic and electrical terms containing 20 000 terms and definitions in English and French, with equivalent terms in 16 additional languages. Also known as the International Electrotechnical Vocabulary (IEV) online. IEC Glossary - std.iec.ch/glossary 65 000 elect
9、rotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002. Some entries have been collected from earlier publications of IEC TC 37, 77, 86 and CISPR. IEC Customer Service Centre - webstore.iec.ch/csc If you wish to giv
10、e us your feedback on this publication or need further assistance, please contact the Customer Service Centre: csciec.ch. IEC 60598-2-4 Edition 3.0 2017-04 INTERNATIONAL STANDARD Luminaires Part 2-4: Particular requirements Portable general purpose luminaires INTERNATIONAL ELECTROTECHNICAL COMMISSIO
11、N ICS 29.140.40 ISBN 978-2-8322-4172-1 Registered trademark of the International Electrotechnical Commission Warning! Make sure that you obtained this publication from an authorized distributor. 2 IEC 60598-2-4:2017 IEC 2017 CONTENTS FOREWORD . 3 4.1 Scope 5 4.2 Normative references . 5 4.3 Terms an
12、d definitions 5 4.4 General test requirements . 5 4.5 Classification of luminaires 5 4.6 Marking . 6 4.7 Construction 6 4.8 Creepage distances and clearances 8 4.9 Provision for earthing . 8 4.10 Terminals. 8 4.11 External and internal wiring 8 4.12 Protection against electric shock 8 4.13 Endurance
13、 tests and thermal tests . 9 4.14 Resistance to dust and moisture 9 4.15 Insulation resistance and electric strength . 9 4.16 Resistance to heat, fire and tracking 9 Bibliography 10 Figure 1 Luminaires “For indoor use only” 6 IEC 60598-2-4:2017 IEC 2017 3 INTERNATIONAL ELECTROTECHNICAL COMMISSION _
14、LUMINAIRES Part 2-4: Particular requirements Portable general purpose luminaires FOREWORD 1) The International Electrotechnical Commission (IEC) is a worldwide organization for standardization comprising all national electrotechnical committees (IEC National Committees). The object of IEC is to prom
15、ote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, IEC publishes International Standards, Technical Specifications, Technical Reports, Publicly Available Specifications (PAS) and Guides
16、(hereafter referred to as “IEC Publication(s)”). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non- governmental organizations liaising with the IEC als
17、o participate in this preparation. IEC collaborates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of IEC on technical matters express, as nearly as possi
18、ble, an international consensus of opinion on the relevant subjects since each technical committee has representation from all interested IEC National Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEC National Committees in that sense. Whi
19、le all reasonable efforts are made to ensure that the technical content of IEC Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. 4) In order to promote international uniformity, IEC National Committees undertake
20、to apply IEC Publications transparently to the maximum extent possible in their national and regional publications. Any divergence between any IEC Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEC itself does not provide any attestati
21、on of conformity. Independent certification bodies provide conformity assessment services and, in some areas, access to IEC marks of conformity. IEC is not responsible for any services carried out by independent certification bodies. 6) All users should ensure that they have the latest edition of th
22、is publication. 7) No liability shall attach to IEC or its directors, employees, servants or agents including individual experts and members of its technical committees and IEC National Committees for any personal injury, property damage or other damage of any nature whatsoever, whether direct or in
23、direct, or for costs (including legal fees) and expenses arising out of the publication, use of, or reliance upon, this IEC Publication or any other IEC Publications. 8) Attention is drawn to the Normative references cited in this publication. Use of the referenced publications is indispensable for
24、the correct application of this publication. 9) Attention is drawn to the possibility that some of the elements of this IEC Publication may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 60598-2-4 has been
25、prepared by subcommittee 34D: Luminaires, of IEC technical committee 34: Lamps and related equipment. This third edition cancels and replaces the second edition published in 1997. This edition constitutes a technical revision. This edition includes the following significant technical changes with re
26、spect to the previous edition: a) alignment with IEC 60598-1; b) modification of the scope, classification and requirements to cover portable luminaires for both indoor and outdoor applications, by introducing the requirements already listed in IEC 60598-2-7; NOTE In this edition of IEC 60598-2-4 al
27、l requirements listed in IEC 60598-2-7 have been incorporated. As a consequence, IEC 60598-2-7 will be withdrawn after publication of this standard. 4 IEC 60598-2-4:2017 IEC 2017 c) modification of the scope to cover all electrical light sources (it was previously limited to tungsten filament, tubul
28、ar fluorescent and other discharge lamps); d) introduction of the symbol for luminaires which are other than ordinary, but suitable for indoor applications only (e.g. luminaire using PVC cable); e) modification in the detail of test to clarify that the stability test on an inclined plane (see 4.7.3)
29、 shall be carried out with the light source(s) in place; f) modification of the minimum degree of protection against dust and moisture for portable luminaires for outdoor use from IPX3 to IPX4 (see 4.5.2); as a consequence, the requirements for cable entry position, as given in IEC 60598-2-7:1982, 7
30、.6.3 were deleted as they are covered by IPX4; g) modification of the requirements for the acceptance criteria of plug and socket outlet; h) modification of the IP test requiring the most unfavourable of the overturned positions to cover all classes (and not only class II luminaires as in 7.13.1 of
31、IEC 60598-2-7:1982). The text of this International Standard is based on the following documents: FDIS Report on voting 34D/1257/FDIS 34D/1271/RVD Full information on the voting for the approval of this International Standard can be found in the report on voting indicated in the above table. This do
32、cument has been drafted in accordance with the ISO/IEC Directives, Part 2. This publication is to be read in conjunction with IEC 60598-1: Luminaires Part 1: General requirements and tests. It was established on the basis of the eight edition (2014) of that standard. A list of all parts in the IEC 6
33、0598 series, published under the general title Luminaires can be found on the IEC website. NOTE In this standard, the following print type is used: compliance statements: in italic type The committee has decided that the contents of this document will remain unchanged until the stability date indica
34、ted on the IEC website under “http:/webstore.iec.ch“ in the data related to the specific document. At this date, the document will be reconfirmed, withdrawn, replaced by a revised edition, or amended. A bilingual version of this publication may be issued at a later date. IEC 60598-2-4:2017 IEC 2017
35、5 LUMINAIRES Part 2-4: Particular requirements Portable general purpose luminaires 4.1 Scope This part of IEC 60598-2 specifies requirements for portable general purpose luminaires for indoor and/or outdoor use (e.g. garden use), other than handlamps, designed to be used with or incorporating electr
36、ical light sources on supply voltages not exceeding 250 V. 4.2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated referen
37、ces, the latest edition of the referenced document (including any amendments) applies. IEC 61032:1997, Protection of persons and equipment by enclosures Probes for verification IEC 60598-1, Luminaires Part 1: General requirements and tests 4.3 Terms and definitions For the purposes of this document,
38、 the terms and definitions given in IEC 60598-1 as well as the following apply.ISO and IEC maintain terminological databases for use in standardization at the following addresses: IEC Electropedia: available at http:/www.electropedia.org/ ISO Online browsing platform: available at http:/www.iso.org/
39、obp 4.3.1 candlestick luminaire portable luminaire having series connected lamps permanently mounted and separated on a free-standing frame Note 1 to entry: Candlestick luminaires can incorporate E5 or E10 lampholders. 4.4 General test requirements The provisions of Section 0 of IEC 60598-1 apply. T
40、he tests described in each appropriate section of Part 1 shall be carried out in the order listed in this part of IEC 60598-2. 4.5 Classification of luminaires Luminaires shall be classified in accordance with the provisions of Section 2 of IEC 60598-1 together with the following additions. NOTE In
41、Australia and New Zealand, AS/NZS 60598.2.4 introduces Appendix A “Simple Portable Luminaires”. 6 IEC 60598-2-4:2017 IEC 2017 4.5.1 According to the intended use: ordinary luminaires are classified for indoor use only; luminaires which are other than ordinary are classified “for indoor use only”, if
42、 they are marked according to 4.6.1; luminaires which are other than ordinary (see also 4.5.2) are classified for outdoor use. As the requirements for outdoor use are more severe than those for indoor use, these luminaires are also suitable for indoor use. 4.5.2 According to the degree of protection
43、 against dust and moisture, portable luminaires for outdoor use shall be classified IPX4 or higher. 4.5.3 According to the material of the supporting surface, portable luminaires designed for standing on a floor or table shall be classified as suitable for direct mounting on normally flammable surfa
44、ces. 4.6 Marking The provisions of Section 3 of IEC 60598-1 apply, together with the following requirements. 4.6.1 The provisions of 3.3.18 of IEC 60598-1 apply with the following addition. Luminaires which are other than ordinary, and not suitable for outdoor application (e.g. provided with a PVC s
45、upply cord), shall be marked with the appropriate symbol as shown in Figure 1. The symbol shall be explained in the instructions. SOURCE: IEC 60417-5957:2004-12 Figure 1 Luminaires “For indoor use only” 4.6.2 In addition to the provisions of 3.3.15 of IEC 60598-1, for luminaires for outdoor use, the
46、 maximum power calculated from the maximum current rating of the supply cable shall be marked in close proximity to the mains socket-outlet(s) incorporated in the luminaire. 4.7 Construction The provisions of Section 4 of IEC 60598-1 apply, together with the following requirements. 4.7.1 Portable lu
47、minaires shall be designed so that the insulation of flexible cables and cords is unlikely to be damaged when moving or adjusting the luminaire or when placing it on its support. Compliance shall be checked by inspection. 4.7.2 Wiring shall be fixed by means of wire carriers, clips or similar device
48、s of insulating material, at all places where it might otherwise rub against metal parts in the normal movement of the luminaire, if such rubbing will impair safety. Carriers and clips for flexible IEC 60598-2-4:2017 IEC 2017 7 cords shall be of insulating material, or shall be provided with a fixed
49、 insulating lining if they are accessible or are in contact with accessible metal parts. Compliance shall be checked by inspection. 4.7.3 Portable luminaires shall have adequate stability. Compliance shall be checked by placing the luminaire in the most unfavourable adjustment position of normal use on a plane inclined at an angle of: 6 to the horizontal for luminaires for indoor use; 15 to the horizontal for luminaires for outdoor use, the surface of the plane being such that
