CNS 696-1984 Open Type Knife Switch《无盖闸刀开关》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

TS 2675-1977 Anodizing Of Aluminium And Its Alloys - Assessment Of Sealing Quality By Measurement Of The Loss Of Mass After Immersion In Acid Solution《铝和铝合金的阳极处理 通过测量在酸溶液浸泡后重量的损失来进.pdf

TS 2676-1977 ANODIZING OP ALUMINIUM AND ITS ALLOYS - ASSESSMENT OP SEALING PUALITY BY MEASUREMENT OF THE LOSS OP MASS AFTER IMMERSION IN PHOSPHORIC - CHROMIC ACID SOLUTION《铝和铝合金的阳极.pdf

TS 2677-1977 ANODIZING OF ALUMINIUM AND ITS ALLOYS - ASSESSMENT OF RESISTANCE OF ANODIC COATINGS TO CRACKING BY DEFORMATION《铝和铝合金的阳极处理 阳极涂层抗变形破裂性的评定》.pdf

TS 2678-1977 Determination of Gross Calorific Value By The Calorimetric Bomb Method And Calculation of Net Calorific Value《用量热弹法和净发热值的计算法测定总发热值》.pdf

TS 2679-1977 NATURAL RUBBER LATEX - DETERMINATION OF SLUDGE CONTENT《天然胶乳 残渣含量的测定》.pdf

TS 268-1980 PUMPS (HORIZONTAL AXLE CENTRIFUGAL) and SUCTION and DISCHARGE SYSTEMS《泵（水平轴离心）和排吸系统》.pdf

TS 2680-1977 VULCANIZED RUBBERS - DETERMINATION OF RESISTANCE TO OZONE CRACKING UNDER STATIC CONDITIONS《硫化橡胶 静态条件下抗臭氧龟裂的测定》.pdf

TS 2681-1977 RUBBER - VULCANIZED - DETERMINATION OF ADHESION TO RIDIG PLATES IN SHEAR - QUADRUPLE SHEAR METHOD《硫化橡胶 与刚性板粘合剪切强度测定方法 四板法》.pdf

TS 2682-1977 Dimensions Of Aircraft - Pressure - Oiling Connection《航空器尺寸 压力加注润滑油接头》.pdf