1、 IEEE Guide for Conducting Distribution Impact Studies for Distributed Resource Interconnection Sponsored by the IEEE Standards Coordinating Committee 21 on Fuel Cells, Photovoltaics, Dispersed Generation, and Energy Storage IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Standards Coordinating
2、Committee 21 IEEE Std 1547.7-2013IEEE Std 1547.7-2013 IEEE Guide for Conducting Distribution Impact Studies for Distributed Resource Interconnection Sponsor IEEE Standards Coordinating Committee 21 of the IEEE Standards Coordinating Committee 21 on Fuel Cells, Photovoltaics, Dispersed Generation, an
3、d Energy Storage Approved 11 December 2013 IEEE-SA Standards Board Abstract: IEEE Std 1547.7 is part of the IEEE 1547 series of standards. Whereas IEEE Std 1547-2003 provides mandatory requirements for the interconnection of distributed resources (DR) with electric power systems (EPS), this guide do
4、es not presume the interconnection is IEEE 1547 compliant. Further, this guide does not interpret IEEE Std 1547 or other standards in the IEEE 1547 series, and this guide does not provide additional requirements or recommended practices related to the other IEEE 1547 documents. However, DR interconn
5、ection may contribute to resultant conditions that could exceed what was normally planned for and built into the distribution system. This guide provides alternative approaches and good practices for engineering studies of the potential impacts of a DR or aggregate DR interconnected to the electric
6、power distribution system. This guide describes criteria, scope, and extent for those engineering studies. Study scope and extent are described as functions of identifiable characteristics of the DR, the EPS, and the interconnection. The intent includes promoting impact study consistency while helpi
7、ng identify only those studies that should be performed based on technically transparent criteria for the DR interconnection. Keywords: distributed energy resources, distributed generation, distributed power, distributed resources, distribution grid, distribution system, electric power systems, ener
8、gy storage, federal utility grid, fuel cells, grid interconnection requirements and specifications, IEEE 1547.7, interconnection, microturbines, national, photovoltaic power systems, public utility commission, regulations, renewable energy, rulemaking, regional, utility grid, utility grid dispersed
9、generation The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 28 February 2014. Printed in the United States of America. IEEE is a registe
10、red trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS
11、 IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoin
12、t expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other serv
13、ices for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstan
14、ces or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITU
15、TE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF A
16、DVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be
17、 considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considere
18、d to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal positi
19、on of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes i
20、n documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For t
21、his reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. An
22、y person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE
23、 Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regula
24、tory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyrig
25、ht laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these doc
26、uments available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard
27、for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual sta
28、ndard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to ti
29、me through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a
30、 document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE sta
31、ndard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more
32、information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encou
33、raged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity
34、 of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indic
35、ate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims
36、 may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or condit
37、ions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is ent
38、irely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2014 IEEE. All rights reserved. vi Participants At the time this IEEE guide was completed, the DRIS Working Group had the following membership: Robert Saint, Chair Thomas Basso, Secreta
39、ry Rasool Aghatehrani Marcelo Algrain Muhammed Ali Wendy Al-Mukdad Robert Arritt Adil Aziz Martin Baier Mark Baldassari David Bassett David Beach Weruir Blumer David Bosack Ryan Boudreau James Bridges Robert Broadwater Drazena Brocilo Ken Brunkenhoefer Yi Chen Christopher Clarke James Cleary Michael
40、 Coddington Nancy Connelly Marv Dagatz Subir Das Herbert Daugherty Richard DeBlasio Mamadou Diong Jose Dizon Dale Donovan Michael Doyle Robert Eastham Peter Evans Masoud Farivar David Farmer Omar Faruque Markus Fischer Rhys Foster John Foster Joe Fox John Gajda Harjects Gill Joerg Grosshennig Jason
41、Gunawardena Jianlin Guo Joshua Hambrick Keith Harley Patrick Healey Taylor Hollis Soonwook Hong Iran Iqbal Hiroshi Irie Stoli Jager Lu Jiang Gerald Johnson Hal Kamigaki Farid Katiraei Maeda Kazuto David Kelley Joseph L. Koepfinger Connie Komomua James Lemke Claudio Lima Brian Lydic Hitoshi Maejima N
42、okhum Markushevich Anthony Mazy Tom McDermott Charles Mee Bill Moncrief Zinn Morton George Moskos Arun Narang David Nichols Rafael Nielson John Nunneley Gary Olson Marc Patterson David Pearce Mark Pokryska James Reilly Roy Riety D. Tom Rizy Roger Salas Daniel Sammon Colin Schauder Karl Schoder Brian
43、 Seal Paul Sheaffer Michael Sheehan Mark Siira Mark Smith Gary Smullin Farajollah Soudi Jim Sprecher Wayne Stec Chase Sun Tzen Woo Tham Michael Thesing Scott Thomas Sylvester Toe Brandon Tolentino Phuoc Tran Philippe Venne Simon Wall Reigh Walling Keith Walters Allen Windhom Nicolas Wrathall Timothy
44、 Zgonena Michael Zuercher-Martinson At the time this draft guide was completed, SCC21 had the following membership: Richard DeBlasio, Chair Thomas Basso, Vice Chair and Secretary David Bassett Paul Bishop John Bzura James M. Daley Douglas C. Dawson Frank Goodman Kelvin Hecht Yiming Hou Gerald Johnso
45、n Joseph L. Koepfinger Benjamin Kroposki Peter McNutt Thomas Prevost Charles Rogers Robert Saint Mark Siira Timothy Zgonena vii Copyright 2014 IEEE. All rights reserved. The following members of the individual balloting committee voted on this guide. Balloters may have voted for approval, disapprova
46、l, or abstention.Mohamed Abdel Khalek William Ackerman Steven Alexanderson Marcelo Algrain Jay Anderson Martin Baier Mark Baldassari G. Bartok David Bassett Kenneth Behrendt Wallace Binder William Bloethe David Bosack Ryan Boudreau James Bouford James Bougie Chris Brooks David Brown Gustavo Brunello
47、 William Byrd Paul Cardinal Keith Chow James Cleary James Cole Larry Conrad Stephen Conrad Terry Conrad Garth Corey Luis Coronado Randall Crellin Randall Cunico Matthew Davis Kevin Donahoe Carlo Donaati Neal Dowling Michael Doyle Ahmed Elneweihi Brian Escott Dan Evans David Farmer Omar Faruque Rosty
48、slaw Fostiak Fredric Friend Doaa Galal Frank Gerleve David Gilmer J. T. Gordon Stephen Grier Randall Groves Donald Hall Keith Harley J. Harlow Jeffrey Hauber Patrick Healey Werner Hoelzl Robert Hoerauf Jerry Hohn Soonwook Hong Joseph Jancauskas Brian Johnson Gerald Johnson Innocent Kamwa Gael Kenned
49、y Yuri Khersonsky Morteza Khodaie James Kinney Boris Kogan Ljubomir Kojovic Benjamin Kroposki Jim Kulchisky Chung-Yiu Lam Raluca Lascu Kevin Little Omar Mazzoni John McDaniel John McDonald Hank McGlynn Dean Miller John Miller William Moncrief Jose Morales Kimberly Mosley Daniel Mulkey Daniel Mungovan Jerry Murphy Mangapathirao Mynam Arun Narang Michael Newman Charles Ngethe David Nichols Nick S. A. Nikjoo Joe Nims Matthew Norwalk Lorraine Padden Mirko Palazzo Panagiotis Papadopoulos Bansi Patel Subhash Patel Marc Patterson Christopher Petrola Dean Philips Alvaro Porti
