1、Reference numberISO/IEC/IEEE 8802-1X:2013/AM 1:201(E)IEEE 201,17(51$7,21$/67$1$5 ISO/IEC/IEEE8802-1XInformation technology Telecommunications and information exchange between systems Local and metropolitan area networks Part 1X: Port-based network access control AMENDMENT 1: MAC security key agreeme
2、nt protocol (MKA) extensions Technologies de linformation Tlcommunications et change dinformation entre systmes Rseaux locaux et mtropolitains Exigences spcifiques Partie 1X: Contrle daccs au rseau bas sur le port AMENDEMENT 1(WHQVLRQVGXSURWRFROHG DFFRUGGHFOpVGHVpFXULWp0$:201$0(E) PDF disclaimer Thi
3、s PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept the
4、rein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat, the IEC Central Office and IEEE do not accept any liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in
5、the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies and IEEE members. In the unlikely event that a problem relating to it is found, please inform the ISO Central Sec
6、retariat or IEEE at the address given below. COPYRIGHT PROTECTED DOCUMENT IEEE 201 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permissio
7、n in writing from ISO, IEC or IEEE at the respective address below. ISO copyright office IEC Central Office Institute of Electrical and Electronics Engineers, Inc. Case postale 56 3, rue de Varemb 3 Park Avenue, New York CH-1211 Geneva 20 CH-1211 Geneva 20 NY 10016-5997, USA Tel. + 41 22 749 01 11 S
8、witzerland E-mail stds.iprieee.org Fax + 41 22 749 09 47 E-mail inmailiec.ch Web www.ieee.org E-mail copyrightiso.org Web www.iec.ch Web www.iso.org Published in Switzerland ii IEEE 201 All rights reservedISO/IEC/IEEE 8802-1X:2013/AM 1:201(E) IEEE 201 All rights reserved iiiForeword ISO (the Interna
9、tional Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees establishe
10、d by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the fiel
11、d of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (IEEE-SA) Standards Board. The IEEE develops its standard
12、s through a consensus development process, approved by the American National Standards Institute, which brings together volunteers representing varied viewpoints and interests to achieve the final product. Volunteers are not necessarily members of the Institute and serve without compensation. While
13、the IEEE administers the process and establishes rules to promote fairness in the consensus development process, the IEEE does not independently evaluate, test, or verify the accuracy of any of the information contained in its standards. The main task of ISO/IEC JTC 1 is to prepare International Sta
14、ndards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is called to the possibility that implementation o
15、f this standard may require the use of subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. ISO/IEEE is not responsible for identifying essential patents or patent claims
16、 for which a license may be required, for conducting inquiries into the legal validity or scope of patents or patent claims or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance or a Patent Statement and Licensing Declaration Form, i
17、f any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained fro
18、m ISO or the IEEE Standards Association. Amendment 1 to ISO/IEC/IEEE 8802-1X:2013 was prepared by the LAN/MAN of the IEEE Computer Society (as IEEE 802.1Xbx-2014). It was adopted by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 6, Telecommunications and information
19、 exchange between systems, in parallel with its approval by the ISO/IEC national bodies, under the “fast-track procedure” defined in the Partner Standards Development Organization cooperation agreement between ISO and IEEE. IEEE is responsible for the maintenance of this document with participation
20、and input from ISO/IEC national bodies. iv (blank page) IEEE Standard for Local and metropolitan area networks Port-Based Network Access Control Amendment 1: MAC Security Key Agreement Protocol (MKA) Extensions Sponsored by the LAN/MAN Standards CommitteeIEEE 3 Park Avenue New York, NY 10016-5997 US
21、A IEEE Computer SocietyIEEE Std 802.1Xbx-2014 (Amendment to IEEE Std 802.1X-2010) IEEE Std 802.1Xbx-2014(Amendment toIEEE Std 802.1X-2010)IEEE Standard for Local and metropolitan area networksPort-Based Network Access ControlAmendment 1: MAC Security Key AgreementProtocol (MKA) ExtensionsSponsorLAN/
22、MAN Standards Committeeof theIEEE Computer SocietyApproved 10 December 2014IEEE-SA Standards Board,62,($0 ( The Institute of Electrical and Electronics Engineers, Inc.3 Park Avenue, New York, NY 10016-5997, USACopyright 2014 by The Institute of Electrical and Electronics Engineers, Inc.All rights re
23、served. Published 22 December 2014. Printed in the United States of America.IEEE and 802 are registered trademarks in the U.S. Patent $0 ( Copyright 2014 IEEE. All rights reserved. iiiImportant Notices and Disclaimers Concerning IEEE Standards DocumentsIEEE documents are made available for use subje
24、ct to important notices and legal disclaimers. These noticesand disclaimers, or a reference to this page, appear in all standards and may be found under the heading“Important Notice” or “Important Notices and Disclaimers Concerning IEEE Standards Documents.”Notice and Disclaimer of Liability Concern
25、ing the Use of IEEE StandardsDocumentsIEEE Standards documents (standards, recommended practices, and guides), both full-use and trial-use, aredeveloped within IEEE Societies and the Standards Coordinating Committees of the IEEE StandardsAssociation (“IEEE-SA”) Standards Board. IEEE (“the Institute”
26、) develops its standards through aconsensus development process, approved by the American National Standards Institute (“ANSI”), whichbrings together volunteers representing varied viewpoints and interests to achieve the final product.Volunteers are not necessarily members of the Institute and parti
27、cipate without compensation from IEEE.While IEEE administers the process and establishes rules to promote fairness in the consensus developmentprocess, IEEE does not independently evaluate, test, or verify the accuracy of any of the information or thesoundness of any judgments contained in its stand
28、ards.IEEE does not warrant or represent the accuracy or content of the material contained in its standards, andexpressly disclaims all warranties (express, implied and statutory) not included in this or any otherdocument relating to the standard, including, but not limited to, the warranties of: mer
29、chantability; fitnessfor a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness ofmaterial. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort.IEEE standards documents are supplied “AS IS” and “WITH ALL FAU
30、LTS.”Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that thereare no other ways to produce, test, measure, purchase, market, or provide other goods and services related tothe scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a
31、 standard is approved andissued is subject to change brought about through developments in the state of the art and commentsreceived from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or otherservices for, or on behalf of, a
32、ny person or entity nor is IEEE undertaking to perform any duty owed by anyother person or entity to another. Any person utilizing any IEEE Standards document, should rely upon hisor her own independent judgment in the exercise of reasonable care in any given circumstances or, asappropriate, seek th
33、e advice of a competent professional in determining the appropriateness of a given IEEEstandard.IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO:PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
34、DATA, OR PROFITS; ORBUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OROTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPONANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAG
35、E ANDREGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE.,62,($0 ( iv Copyright 2014 IEEE. All rights reserved.Translations The IEEE consensus development process involves the review of documents in English only. In the eventthat an IEEE standard is translated, only the English version published by IE
36、EE should be considered theapproved IEEE standard.Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards BoardOperations Manual shall not be considered or inferred to be the official position of IEEE or any of itscommittees and shall not be c
37、onsidered to be, or be relied upon as, a formal position of IEEE. At lectures,symposia, seminars, or educational courses, an individual presenting information on IEEE standards shallmake it clear that his or her views should be considered the personal views of that individual rather than theformal p
38、osition of IEEE. Comments on standardsComments for revision of IEEE Standards documents are welcome from any interested party, regardless ofmembership affiliation with IEEE. However, IEEE does not provide consulting information or advicepertaining to IEEE Standards documents. Suggestions for changes
39、 in documents should be in the form of aproposed change of text, together with appropriate supporting comments. Since IEEE standards represent aconsensus of concerned interests, it is important that any responses to comments and questions also receivethe concurrence of a balance of interests. For th
40、is reason, IEEE and the members of its societies andStandards Coordinating Committees are not able to provide an instant response to comments or questionsexcept in those cases where the matter has previously been addressed. For the same reason, IEEE does notrespond to interpretation requests. Any pe
41、rson who would like to participate in revisions to an IEEEstandard is welcome to join the relevant IEEE working group.Comments on standards should be submitted to the following address:Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USALaws and regulations Users of IEEE Standar
42、ds documents should consult all applicable laws and regulations. Compliance with theprovisions of any IEEE Standards document does not imply compliance to any applicable regulatoryrequirements. Implementers of the standard are responsible for observing or referring to the applicableregulatory requir
43、ements. IEEE does not, by the publication of its standards, intend to urge action that is notin compliance with applicable laws, and these documents may not be construed as doing so.CopyrightsIEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws.They a
44、re made available by IEEE and are adopted for a wide variety of both public and private uses. Theseinclude both use, by reference, in laws and regulations, and use in private self-regulation, standardization,and the promotion of engineering practices and methods. By making these documents available
45、for use andadoption by public authorities and private users, IEEE does not waive any rights in copyright to thedocuments.,62,($0 ( Copyright 2014 IEEE. All rights reserved. vPhotocopiesSubject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license tophotocopy porti
46、ons of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center,Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission tophotocopy p
47、ortions of any individual standard for educational classroom use can also be obtained throughthe Copyright Clearance Center.Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any timeby the issuance of new editions or may
48、be amended from time to time through the issuance of amendments,corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of thedocument together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten yearsold and has not undergone a revision process, it is reasonable to conclude that its contents, although still ofsome value, do not wholly reflect the present state of the art. Users are cauti
