1、 IEEE Standard Test Methods for Surge Protectors Used in Low-Voltage Data, Communications, and Signaling Circuits Sponsored by the Surge Protective Devices Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std C62.36-2014 (Revision of IEEE Std C62.36-2000) I
2、EEE Std C62.36-2014 (Revision of IEEE Std C62.36-2000) IEEE Standard Test Methods for Surge Protectors Used in Low-Voltage Data, Communications, and Signaling Circuits Sponsor Surge Protective Devices Committee of the IEEE Power and Energy Society Approved 27 March 2014 IEEE-SA Standards Board Abstr
3、act: Surge protectors for application on multiconductor balanced or unbalanced data, communications, and signaling circuits with voltages equal to or less than 1000 Vrms, or 1200 V dc are covered by this standard. These surge protectors are designed to limit voltage surges, current surges, or both.
4、The methods of testing and criteria for determining the end of life of electrical surge protectors used in low-voltage data, communications, and signaling circuits are described. The surge protectors covered are multiple-component series or parallel combinations of linear or nonlinear elements, pack
5、aged for the purpose of limiting voltage, current, or both. This standard is not intended to cover packaged single gas tube, air gap, varistor, or avalanche junction surge-protective devices, which are covered by IEEE Std C62.31 B21, IEEE Std C62.32 B22, IEEE Std C62.33 B23, and IEEE Std C62.35 B24,
6、 respectively. Keywords: communications circuits, current limiters, data circuits, electrical protection, IEEE C62.36, signaling circuits, surge protectors, surge-protective devices, voltage limiters The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997,
7、USA Copyright 2014 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 9 July 2014. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiv
8、eness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not
9、imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in
10、 the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person
11、 or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IE
12、EE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF L
13、IABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEE
14、E consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in a
15、ccordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, a
16、n individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested
17、party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since
18、 IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an i
19、nstant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working
20、 group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE
21、Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in complian
22、ce with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These i
23、nclude both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in cop
24、yright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensi
25、ng fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE St
26、andards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consist
27、s of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its
28、 contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through
29、 the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.i
30、eee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation
31、of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assur
32、ance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or unde
33、r reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essent
34、ial Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are rea
35、sonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2
36、014 IEEE. All rights reserved. vi Participants At the time this IEEE standard was completed, the 3.6.7 LV Data, Communications and Signaling Circuit Surge Protective Devices Working Group had the following membership: Albert Martin, Chair Robert Ashton Frank Basciano Nisar Chaudhry Leonard Drewes Ga
37、llo Ernie Bogey Klabassa Peter Kobsa Michael Maytum Wolfgang Oertel Tim Patel Bill Travis The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. William Ackerman Robert Ashton William Bush William Byrd Su
38、resh Channarasappa Chuanyou Dai Carlo Donati Gary Donner Randall Groves Raymond Hill Ronald Hotchkiss Yuri Khersonsky Chad Kiger Jim Kulchisky Saumen Kundu Chung-Yiu Lam Paul Lindemulder Greg Luri Ahmad Mahinfallah Albert Martin Michael Maytum William McBride Daleep Mohla Michael Newman Gary Nissen
39、Wolfgang Oertel Lorraine Padden Thomas Phipps Ulrich Pohl Percy Pool Michael Roberts Thomas Rozek Bartien Sayogo Robert Schuerger James Smith Jerry Smith Gary Stoedter David Tepen Donald Turner John Vergis Matthew Wakeham James WilsonCopyright 2014 IEEE. All rights reserved. vii When the IEEE-SA Sta
40、ndards Board approved this standard on 27 March 2014, it had the following membership: John Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Peter Balma Farooq Bari Ted Burse Clint Chaplain Stephen Dukes Jean-Phillippe Faure Gary Hoffman
41、Michael Janezic Jeffrey Katz Joseph L. Koepfinger* David J. Law Hung Ling Oleg Logvinov Ted Olsen Glenn Parsons Ron Peterson Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Don Wright Yu Yuan *Member Emeritu Also included are the following nonvoting IEEE-SA Standards Board liaisons: Rich
42、ard DeBlasio, DOE Representative Michael Janezic, NIST Representative Michelle Turner IEEE-SA Content Publishing Malia Zaman IEEE-SA Standards Technical Community Copyright 2014 IEEE. All rights reserved. viii Introduction This introduction is not part of IEEE Std C62.36-2014, IEEEIEEE Standard for
43、Test Methods for Surge Protectors Used in Low-Voltage Data, Communications, and Signaling Circuits. This standard was originally developed to establish methods for testing characteristics and for identifying criteria that determine the end of life for surge protectors used in low-voltage data, commu
44、nications, and signaling circuits. This edition of the standard is a major rewrite of the 2000 edition. It has two main changes from the previous edition. One is reformatted test clauses so that each test clause now has subclauses covering background, purpose, equipment to be used, protector states
45、to test, a step-by-step test procedure, alternative tests (if any), suggested test data, requirements (if any), and comments (if any). The second is reorganized tests by characteristics and ratings, rather than by nonsurge performance tests and active performance tests. Some of the tests in the prev
46、ious edition have been deleted (subclauses 7.1, 7.2, 7.11, 7.12, 7.13, 8.6, and 8.11 in the previous edition). Some new tests have been added (7.4, 7.5, 8.10, 8.12, 8.13, 8.14, 8.15, and 8.16). The remaining tests have been updated to reflect current practice. For those tests where it is appropriate
47、, end-of-life conditions are reflected in the requirements. The purpose of this standard is to establish tests for the ratings and characteristics of surge protectors packaged for the purpose of limiting surge voltages, currents, or both. These surge protectors contain at least one nonlinear element
48、. Because these test methods and criteria apply to a range of surge protectors used in various environmental conditions and include various combinations of elements, not all tests are appropriate for every surge protector. Manufacturers and users may determine which tests apply to a surge protector
49、intended for a specific application. These standard test methods should improve the consistency of information on the data sheets for covered surge protectors. Copyright 2014 IEEE. All rights reserved. ix Contents 1. Overview 1 1.1 Scope . 1 1.2 Purpose 2 2. Normative references 2 3. Definitions, acronyms, and abbreviations 2 3.1 Definitions . 2 3.2 Acronyms and abbreviations . 3 4. Service conditions 4 4.1 Normal service conditions . 4 4.2 Unusual service conditions 5 4.3 Radiation 6 5. Basic configurations . 6 6. Standard design test procedure . 8 6.1 Standar
