MNOSZ 105-6 lap-1950 《螺丝测试》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ISO 9266-1988 Woodworking machines universal tool and cutter sharpeners nomenclature《木工机械 万能磨刀机 术语 两种语言版》.pdf

ISO 9267-1988 Woodworking machines bandsaw blade sharpening machines nomenclature《木工机械 带锯磨锯机 术语 两种语言版》.pdf

ISO 9268-1988 Implants for surgery metal bone screws with conical under-surface of head dimensions《外科植入物 具有锥形下表面头部的金属接骨螺钉 尺寸》.pdf

ISO 9269-1988 Implants for surgery metal bone plates holes and slots corresponding to screws with conical under-surface《外科植入物 金属接骨板 与锥形下表面螺钉对应的孔和槽》.pdf

ISO 927 CORR 1-2012 Spices and condiments - Determination of extraneous matter and foreign matter content Technical Corrigendum 1《香料和调料 异物和杂质含量的测定 技术勘误表1》.pdf

ISO 9270-1-2010 7 24 taper spindle noses for automatic tool changers - Part 1 Dimensions and designation of spindle noses of forms S and SF《锥度为7 24的自动换刀装置用工具手柄 .pdf

ISO 9270-2-2010 7 24 taper spindle noses for automatic tool changers - Part 2 Dimensions and designation of spindle noses of forms J and JF《锥度为7 24的自动换刀装置用工具手柄 .pdf

ISO 9276-4-2001 Representation of results of particle size analysis - Part 4 Characterization of a classification process《粒度分析结果的表述 第4部分 分级过程的表征》.pdf

ISO 9278-2008 Nuclear energy - Uranium dioxide pellets - Determination of density and volume fraction of open and closed porosity《核能 丸状二氧化铀 开口孔隙率和封闭孔隙率密度和体积分率的测.pdf