MNOSZ 12028-1953 《可滚动铁路用轮椅 负重800公斤》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NF C20-300-3-14-2005 Dependability management - Part 3-14 application guide - Maintenance and maintenance support 《可靠性管理 第3-14部分 应用指南 维修和维修支持》.pdf

NF C20-300-3-16-2008 Dependability management - Part 3-16 application guide - Guideline for the specification of maintenance support services 《可靠性管理 第3-16部分 应用指南 技术维护设施规范用指南》.pdf

NF C20-300-3-2-2005 Dependability management - Part 3-2 application guide - Collection of dependability data from the field 《可信性管理 第3-2部分 应用指南 现场收集可信性数据》.pdf

NF C20-300-3-3-2005 Dependability management - Part 3-3 application guide - Life cycle costing analysis 《可靠性管理 第3-3部分 应用指南 寿命周期成本分析》.pdf

NF C20-300-3-4-2008 Dependability management - Part 3-4 application guide - Guide to the specification of dependability requirements 《可靠性管理 第3-4部分 应用指南 可靠性要求的规范指南》.pdf

NF C20-301-1-2007 Reliability stress screening - Part 1 repairable assemblies manufactured in lots 《应力筛分的可靠性 第1部分 批量生产可修复配件》.pdf

NF C20-302-2006 Analysis techniques for system reliability - Procedure for failure mode and effects analysis (FMEA) 《系统可靠性分析技术 失效模式和效应分析(FMEA)程序》.pdf

NF C20-305-2006 Design review 《设计评审》.pdf

NF C20-306-2-2006 Maintainability of equipment - Part 2 maintainability requirements and studies during the design and development phase 《设备的维修性 第2部分 设计和开发阶段期的维修性要求和研究》.pdf