HB 5441.6-1989 《粉末冶金制品和粉末的性能测试 金属粉末流动性的测试方法》.pdf

相关资源

YB T 5308-2006 粉末冶金用还原铁粉.pdf

JIS Z2503-2000 粉末冶金用粉末.取样.pdf

FZ T 92050-1995 粉末冶金轴承.pdf

HB 5441.1-1989 粉末冶金制品和粉末的性能测试测定金属粉末粒度的筛分法.pdf

HB 5441.7-1989 粉末冶金制品和粉末的性能测试渗透性烧结金属材料密度和开孔度的测试方法.pdf

HB 5441.8-1989 粉末冶金制品和粉末的性能测试烧结金属衬套径向压溃强度的测定.pdf

HB 5458-1990 粉末冶金铜基多孔轴承.pdf

JB T 10310-2001 摩托车离合器用粉末冶金从动齿轮技术条件.pdf

JB T 10310-2011 摩托车离合器用粉末冶金从动齿轮 技术条件.pdf

JB T 2798-1999 铁基粉末冶金烧结制品金相标准.pdf

猜你喜欢

NASA NACA-TN-3529-1955 The transonic characteristics of 36 symmetrical wings of varying taper aspect ratio and thickness as determined by the transonic-bump technique《根据跨音速撞击技术决定的变.pdf

NASA NACA-TN-3547-1955 Aerodynamic characteristics of a small-scale shrouded propeller at angles of attack from 0 degrees to 90 degrees《当攻角为0至90时 小型遮蔽螺旋桨的空气动力特性》.pdf

NASA NACA-TN-3551-1955 Experimental investigation at low speed of effects of fuselage cross section on static longitudinal and lateral stability characteristics of models having 0 截.pdf

NASA NACA-TN-3554-1956 A preliminary investigation of the effects of frequency and amplitude on the rolling derivatives of an unswept-wing model oscillating in roll《频率和振幅对非扫掠机翼模型滚转.pdf

NASA NACA-TN-3583-1955 Charts of boundary-layer mass flow and momentum for inlet performance analysis mach number range 0 2 to 5 0《当马赫数为0 2至5 0时 进气道性能分析边界层质量流和力矩的图表》.pdf

NASA NACA-TN-3607-1956 Effect of thickness camber and thickness distribution on airfoil characteristics at Mach numbers up to 1 0《当马赫数为1 0时 厚度 弧形和厚度分布对机翼特性的影响》.pdf

NASA NACA-TN-3615-1956 An experimental investigation of the scale relations for the impinging water spray generated by a planing surface《平面产生的碰撞喷水数量关系的实验性研究》.pdf

NASA NACA-TN-3663-1956 Discharge coefficients for combustor-liner air-entry holes《燃烧器衬垫进气孔的流量系数》.pdf

NASA NACA-TN-3669-1956 Perforated sheets as a porous material for distributed suction and injection《对于分布式抽吸和注射的作为多孔材料的冲孔薄板》.pdf