1、INTERNATIONAL STANDARD I EC 60464-3-2 2001 AMENDMENT 1 2006-04 Amendment 1 Varnishes used for electrical insulation- Part 3: Specifications for individual materials - Sheet 2: Hot curing impregnating varnishes O IEC 2006 Droits de reproduction rservs - Copyright - all rights reserved Intemational El
2、ectrotechnical Commission, 3, nie de Varemb, PO Box 131, CH-I21 1 Geneva 20, Switzerland Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 O0 E-mail: inmailiec.ch Web: www.iec.ch PRICECODE B For price, see current catalogue Commission Electrotechnique Internationale International Electrotechnical C
3、ommission MeWyHapOaHa 3neKTpOTeXHtlW%CKa KOMMCCM Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-2- FDIS 60464-3-2 Amend. 1 O IEC:2006(E) Report on voting FOREWORD Properties
4、before drying and curing This amendment has been prepared by IEC technical committee 15: Electrical insulating materials. Properties after curing Water content (W and E varnishes) I 15/299/FDIS I 15/320/RVD I Dissipation factor and relative permittivity Breakdown voltage and electric strength Full i
5、nformation on the voting for the approval of this amendment can be found in the report on voting indicated in the above table. The committee has decided that the contents of this amendment and the base publication will remain unchanged until the maintenance result date indicated on the IEC web site
6、under “http:/webstore.iec.ch“ in the data related to the specific publication. At this date, the publication will be reconfirmed, withdrawn, amended. replaced by a revised edition, or Page 9 Replace Table 2 as follows: I Density I Tackiness I I Dilution ability I Bond strength I I pH (W and E varnis
7、hes) I Cupping test I I Volatile organic content (W and E varnishes) I Resistance to liquids (Including water) I I I Resistance to mould growth I I I Flash rusting of steel panels (W and E varnishes) I Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for
8、ResaleNo reproduction or networking permitted without license from IHS-,-,-Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-ISBN 2-831 8-861 1-2 ICs 29.035.01 Typeset and print
9、ed by the IEC Central Office GENEVA, SWITZERLAND Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-NORME CE1 INTERNATIONALE INTERNATIONAL STANDARD IEC 60464-3-2 Deuxime dition S
10、econd edition 2001 -07 Vernis utiliss comme isolants lectriques - Partie 3: Spcifications pour matriaux particuliers - Fe u i I le 2 : Ver n is d i m prg nation d u rcissa n t chaud Varnishes used for electrical insulation - Part 3: Specifications for individual materials - Sheet 2: Hot curing impre
11、gnating varnishes Numro de rfrence Reference number CEIIIEC 60464-3-2:2001 Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Numrotation des publications Depuis le ler janvier 1
12、997, les publications de la CE1 sont numrotes partir de 60000. Ainsi, la CE1 34-1 devient la CE1 60034-1. Editions consolides Les versions consolides de certaines publications de la CE1 incorporant les amendements sont disponibles. Par exemple, les numros ddition 1 .O, 1 .I et 1.2 indiquent respecti
13、vement la publication de base, la publication de base incorporant lamendement 1, et la publication de base incorporant les amendements 1 et 2. Informations supplmentaires sur les publications de la CE1 Le contenu technique des publications de la CE1 est constamment revu par la CE1 afin quil reflte l
14、tat actuel de la technique. Des renseignements relatifs cette publication, y compris sa validit, sont dispo- nibles dans le Catalogue des publications de la CE1 (voir ci-dessous) en plus des nouvelles ditions, amendements et corrigenda. Des informations sur les sujets ltude et lavancement des travau
15、x entrepris par le comit dtudes qui a labor cette publication, ainsi que la liste des publications parues, sont galement disponibles par lintermdiaire de: Site web de la CE1 (www.8ec.ch) Catalogue des publications de la CE1 Le catalogue en ligne sur le site web de la CE1 (www.iec.ch/catla-f.htm) vou
16、s permet de faire des recherches en utilisant de nombreux critres, comprenant des recherches textuelles, par comit dtudes ou date de publication. Des informations en ligne sont galement disponibles sur les nouvelles publications, les publications rempla- ces ou retires, ainsi que sur les corrigenda.
17、 IEC Just Published Ce rsum des dernires publications parues (www/.iec.ch/JP.htm) est aussi disponible par courrier lectronique. Veuillez prendre contact avec le Service client (voir ci-dessous) pour plus dinformations. Service clients Si vous avez des questions au sujet de cette publication ou avez
18、 besoin de renseignements supplmentaires, prenez contact avec le Service clients: Email: custserriec.ch TI: +41 22 919 02 11 Fax: +41 22 919 03 O0 Publication numbering As from 1 January 1997 all IEC publications are issued with a designation in the 60000 series. For example, IEC 34-1 is now referre
19、d to as IEC 60034-1. Consolidated editions The IEC is now publishing consolidated versions of its publications. For example, edition numbers 1 .O, 1 .I and 1.2 refer, respectively, to the base publication, the base publication incorporating amendment 1 and the base publication incorporating amendmen
20、ts 1 and 2. Further information on IEC publications The technical content of IEC publications is kept under constant review by the IEC, thus ensuring that the content reflects current technology. Information relating to this publication, including its validity, is available in the IEC Catalogue of p
21、ublications (see below) in addition to new editions, amendments and corrigenda. Information on the subjects under consideration and work in progress undertaken by the technical committee which has prepared this publication, as well as the list of publications issued, is also available from the follo
22、wing: IEC Web Site (www.iec.ch) Catalogue of IEC publications The on-line catalogue on the IEC web site (www.iec.chlcat8a-e.htm) enables you to search by a variety of criteria including text searches, technical committees and date of publication. On- line information is also available on recently is
23、sued publications, withdrawn and replaced publications, as well as corrigenda. IEC Just Published This summary of recently issued publications (www.iec.ch/JP.htm) is also available by email. Please contact the Customer Service Centre (see below) for further information. Customer Service Centre If yo
24、u have any questions regarding this publication or need further assistance, please contact the Customer Service Centre: Email: custserv,iec.ch Tel: +41 22 91 9 02 11 Fax: +41 22 919 03 O0 Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo repro
25、duction or networking permitted without license from IHS-,-,-NORME CE1 IEC INTERNATIONALE INTERNATIONAL STANDARD 60464-3-2 Deuxime dition Second edition 2001 -07 Vernis utiliss comme isolants lectriques - Partie 3: Spcifications pour matriaux particuliers - Fe u i I le 2 : Ver n is d i m prg nation
26、d u rcissa n t chaud Varnishes used for electrical insulation - Part 3: Specifications for individual materials - Sheet 2: Hot curing impregnating varnishes O IEC 2001 Droits de reproduction rservs - Copyright - all rights reserved Aucune partie de cette publication ne peut tre reproduite ni No part
27、 of this publication may be reproduced or utilized in utilis4e sous quelque forme que ce soit et par aucun proc4d4, any form or by any means, electronic or mechanical, 4lectronique ou m4canique, y compris la photocopie et les including photocopying and microfilm, without permission in microfilms, sa
28、ns laccord 4crit de 14diteur. writing from the publisher. International Electrotechnical Commission Telefax: +41 22 91 9 0300 3, rue de Varemb Geneva, Switzerland IEC web site http:/www.iec.ch e-mail: inmailiec.ch CODE PRIX Commission Electrotechnique Internationale PRICECODE H International Electro
29、technical Commission MemnvHaponHaR KTPOTXHHCHR HOMHCCMR Pourprix, voir catalogue en vigueur O Forprice, see current catalogue Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-2
30、- 60464-3-2 O CEI:2001 COMMISSION LECTROTECHNIQUE INTERNATIONALE VERNIS UTILISES COMME ISOLANTS LECTRIQUES - Partie 3: Spcifications pour matriaux particuliers - Feuille 2: Vernis dimprgnation durcissant chaud AVANT-PROPOS 1) La CE1 (Commission lectrotechnique Internationale) est une organisation mo
31、ndiale de normalisation compose de lensemble des comits lectrotechniques nationaux (Comits nationaux de la CEI). La CE1 a pour objet de favoriser la coopration internationale pour toutes les questions de normalisation dans les domaines de llectricit et de llectronique. A cet effet, la CEI, entre aut
32、res activits, publie des Normes internationales. Leur laboration est confie des comits dtudes, aux travaux desquels tout Comit national intress par le sujet trait peut participer. Les organisations internationales, gouvernementales et non gouvernementales, en liaison avec la CEI, participent galemen
33、t aux travaux. La CE1 collabore troitement avec lOrganisation Internationale de Normalisation (ISO), selon des conditions fixes par accord entre les deux organisations. 2) Les dcisions ou accords officiels de la CE1 concernant les questions techniques reprsentent, dans la mesure du possible, un acco
34、rd international sur les sujets tudis, tant donn que les Comits nationaux intresss sont reprsents dans chaque comit dtudes. 3) Les documents produits se prsentent sous la forme de recommandations internationales. Ils sont publis comme normes, spcifications techniques, rapports techniques ou guides e
35、t agrs comme tels par les Comits nationaux. 4) Dans le but dencourager lunification internationale, les Comits nationaux de la CE1 sengagent appliquer de faon transparente, dans toute la mesure possible, les Normes internationales de la CE1 dans leurs normes nationales et rgionales. Toute divergence
36、 entre la norme de la CE1 et la norme nationale ou rgionale correspondante doit tre indique en termes clairs dans cette dernire. 5) La CE1 na fix aucune procdure concernant le marquage comme indication dapprobation et sa responsabilit nest pas engage quand un matriel est dclar conforme lune de ses n
37、ormes. 6) Lattention est attire sur le fait que certains des lments de la prsente Norme internationale peuvent faire lobjet de droits de proprit intellectuelle ou de droits analogues. La CE1 ne saurait tre tenue pour responsable de ne pas avoir identifi de tels droits de proprit et de ne pas avoir s
38、ignal leur existence. La Norme internationale CE1 60464-3-2 a t tablie par le sous-comit comit dtudes 15 de la CEI: Matriaux isolants. Cette deuxime dition annule et remplace la premire dition, parue en Le texte de cette norme est issu des documents suivants: I FDIS I Rapport devote I 5C: Spcificati
39、ons, du 1989. Le rapport de vote indiqu dans le tableau ci-dessus donne toute information sur le vote ayant abouti lapprobation de cette norme. Cette publication a t rdige selon les Directives ISO/CEI, Partie 3. Le comit a dcid que le contenu de cette publication ne sera pas modifi avant 2005. A cet
40、te date, la publication sera reconduite; supprime; amende. remplace par une dition rvise, ou Copyright International Electrotechnical Commission Provided by IHS under license with IECNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-60464-3-2 O IEC:2001 -3- INTERNATI
41、ONAL ELECTROTECHNICAL COMMISSION VARNISHES USED FOR ELECTRICAL INSULATION - Part 3: Specifications for individual materials - Sheet 2: Hot curing impregnating varnishes FOREWORD 1) The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising all nati
42、onal electrotechnical committees (IEC National Committees). The object of the IEC is to promote international co-operation on all questions concerning standardization in the electrical and electronic fields. To this end and in addition to other activities, the IEC publishes International Standards.
43、Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may participate in this preparatory work. International, governmental and non-governmental organizations liaising with the IEC also participate in this preparation. The IEC collabo
44、rates closely with the International Organization for Standardization (ISO) in accordance with conditions determined by agreement between the two organizations. 2) The formal decisions or agreements of the IEC on technical matters express, as nearly as possible, an international consensus of opinion
45、 on the relevant subjects since each technical committee has representation from all interested National Committees. 3) The documents produced have the form of recommendations for international use and are published in the form of standards, technical specifications, technical reports or guides and
46、they are accepted by the National Committees in that sense. 4) In order to promote international unification, IEC National Committees undertake to apply IEC International Standards transparently to the maximum extent possible in their national and regional standards. Any divergence between the IEC S
47、tandard and the corresponding national or regional standard shall be clearly indicated in the latter. 5) The IEC provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with one of its standards. 6) Attention is drawn t
48、o the possibility that some of the elements of this International Standard may be the subject of patent rights. The IEC shall not be held responsible for identifying any or all such patent rights. International Standard IEC 60464-3-2 has been prepared by subcommittee 15C: Specifications, of IEC technical committee 15: Insulating materials. This second edition cancels and replaces the first edition published in 1989. The text of this standard
