GB T 37866-2019 绿色产品评价 塑料制品.pdf

相关资源

JIS K7219-1998 塑料制品.直接风化辐照、使用玻璃滤过日光风化辐照和使用菲涅耳镜处理的日光强度辐照方法.pdf

JIS Z7120-2003 塑料.塑料制品中茂比乌斯环的应用指南.pdf

CB T 180-1998 船用玻璃纤维增强塑料制品手糊成型工艺.pdf

JB 3820-1984 塑料制品液压机 精度.pdf

HB-Z 5017-1976 热固性塑料制品模压工艺.pdf

HJ T 231-2006 环境标志产品技术要求 再生塑料制品.pdf

SN T 2691-2010 塑料制品中二噁英类多氯联苯的测定 气相色谱-高分辨磁质谱法.pdf

SN T 2692-2010 塑料制品中二噁英的测定 气相色谱-高分辨磁质谱法.pdf

JB T 8458-1996 电气设备辅件塑料制品一般要求和试验方法.pdf

JT T 593-2004 公路沿线设施塑料制品耐候性指标及测试方法.pdf

猜你喜欢

NASA NACA-RM-L57B21-1957 Jet effects on the drag of conical afterbodies for Mach numbers of 0 6 to 1 28《当马赫数为0 6至1 3时 圆锥形飞机后体阻力的喷射影响》.pdf

NASA NACA-RM-L57C20-1957 Results of an investigation at high subsonic speeds to determine lateral-control and hinge-moment characteristics of a spoiler-slot-deflector configuration.pdf

NASA NACA-RM-L57E02-1957 Experimental and theoretical aerodynamic characteristics of two low-aspect-ratio delta wings at angles of attack to 50 degrees at a Mach number of 4 07《当马赫.pdf

NASA NACA-RM-L57F07-1957 Effect of frequency of sideslipping motion on the lateral stability derivatives of a typical delta-wing airplane《侧滑动作频率对典型三角形机翼飞机横向稳定性导数的影响》.pdf

NASA NACA-RM-L57H13-1957 BUFFET TESTS OF AN ATTACK-AIRPLANE MODEL WITH EMPHASIS ON ANALYSIS OF DATA FROM WIND-TUNNEL TESTS《攻击飞机模型的猛烈冲击试验 着重于风洞试验数据的分析》.pdf

NASA NACA-RM-L58B05-1958 Low-subsonic investigation to determine the chordwise pressure distribution and effectiveness of spoilers on a thin low-aspect-ratio unswept untapered semiaili.pdf

NASA NACA-RM-L58C18-1958 Effects of vertical location of the wing and horizontal tail on the static lateral and directional stability of a trapezoidal-wing airplane model at Mach n.pdf

NASA NACA-RM-L6L27-1947 Effects of a fuselage and various high-lift and stall-control flaps on aerodynamic characteristics in pitch of an NACA 64-series 40 degrees swept-back wing《.pdf

NASA NACA-RM-L7A30-1947 Wind-tunnel investigation of air loads over a double slotted flap on the NACA 65(216)-215 a = 0 8 airfoil section《NACA 65(216)-215 a = 0 8翼剖面上双开缝襟翼空气荷载的风洞研究.pdf