1、IEEE Standard for Requirements, Terminology, and Test Procedures for Neutral Grounding Devices Sponsored by the Transformers Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std C57.32-2015(Revision ofIEEE Std 32-1972) IEEE Std C57.32-2015 (Revision of IEEE
2、 Std 32-1972) IEEE Standard for Requirements, Terminology, and Test Procedures for Neutral Grounding Devices Sponsor Transformers Committee of the IEEE Power and Energy Society Approved 5 December 2015 IEEE-SA Standards Board Abstract: This standard applies to devices used for the purpose of control
3、ling the ground current or the potentials to ground of an alternating current system. These devices are: grounding transformers, ground-fault neutralizers, resistors, reactors, or combinations of these. Keywords: arc-suppression reactors, ground fault neutralizers, grounding transformers, IEEE C57.3
4、2, neutral grounding devices, reactors, resistors Acknowledgements: The author thanks the International Electrotechnical Commission (IEC) for permission to reproduce information from its International Publication IEC 60076-6 ed.1.0 (2007). All such extracts are copyright of IEC, Geneva, Switzerland.
5、 All rights reserved. Further information on the IEC is available from www.iec.ch. IEC has no responsibility for the placement and context in which the extracts and contents are reproduced by the author, nor is IEC in any way responsible for the other content or accuracy therein. The Institute of El
6、ectrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2016 by The Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 15 April 2016. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent
7、fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use o
8、f an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standar
9、d is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any pe
10、rson or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the
11、advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE
12、, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH
13、 DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE sta
14、ndard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a
15、formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards
16、 Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form
17、 of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members
18、of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to partic
19、ipate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consu
20、lt all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not,
21、 by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available b
22、y IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adopt
23、ion by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational inte
24、rnal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom us
25、e can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendme
26、nts, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years o
27、ld and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine wheth
28、er a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:/ieeexplore.ieee.org/Xplore/home.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEE
29、Es standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata p
30、eriodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection
31、therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing
32、 or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Ass
33、urance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with sub
34、mission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Furt
35、her information may be obtained from the IEEE Standards Association Copyright 2016 IEEE. All rights reserved. vi Participants At the time this IEEE standard was completed, the Performance Characteristics - Neutral Grounding Devices Working Group had the following membership: Sheldon P. Kennedy, Chai
36、r Thomas R. Melle, Vice Chair Fred Elliott, Secretary Donald Ayers Peter Balma J. Arturo Del Rio Richard Dudley David Harris Dan Kobida Sergio Panetta Klaus Papp Klaus Pointner Ulf Radbrandt Dinesh Sankarakurup Steven Schappell Devki Sharma Michael Sharp Sanjib Som Vijay Tendulkar The following memb
37、ers of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. William Ackerman Saleman Alibhay Donald Ayers Roy Ayers Peter Balma Thomas Barnes Paul Barnhart G. Bartok Wallace Binder Thomas Blackburn William Bloethe Gustavo Brune
38、llo Carl Bush William Bush William Byrd Paul Cardinal Michael Champagne Yunxiang Chen Robert Christman Stephen Conrad John Crouse Glenn Davis Mamadou Diong Gary Donner Fred Elliott Jorge Fernandez Daher Sergio Flores Marcel Fortin Dale Fredrickson Fredric Friend Frank Gerleve David Gilmer Jalal Goha
39、ri James Graham Randall Groves Ajit Gwal Said Hachichi J. Harlow Lee Herron Werner Hoelzl Robert Hoerauf Jill Holmes Richard Jackson Song Jin John John Laszlo Kadar Sheldon Kennedy Yuri Khersonsky James Kinney Boris Kogan Jim Kulchisky Saumen Kundu Chung-Yiu Lam Benjamin Lanz Thomas Lundquist Regina
40、ldo Maniego Richard Marek Lee Matthews Omar Mazzoni William McBride Charles Mc Shane Tom Melle Daleep Mohla Jerry Murphy Ryan Musgrove K. R. M. Nair Martin Navarro Kris K. Neild Arthur Neubauer Michael Newman Joe Nims T. W. Olsen Sergio Panetta Klaus Papp Bansi Patel Dhiru Patel Branimir Petosic Don
41、ald Platts Klaus Pointner Alvaro Portillo Tom Prevost Ulf Radbrandt Reynaldo Ramos Robert Resuali Jean-Christophe Riboud Michael Roberts Charles Rogers Thomas Rozek Daniel Sabin Dinesh Sankarakurup Steven Sano Bartien Sayogo Devki Sharma Michael Sharp Hyeong Sim Jeremy Smith Jerry Smith Gary Smullin
42、 Wayne Stec Kyle Stechschulte K. Stump Paul Sullivan Michael Swearingen Ed TeNyenhuis David Tepen Michael Thompson James Van De Ligt John Vergis Sukhdev Walia David Walker John Wang Daniel Ward S. Frank Waterer Yingli Wen Kenneth White James Wilson Jian Yu Copyright 2016 IEEE. All rights reserved. v
43、ii When the IEEE-SA Standards Board approved this standard on 5 December 2015, it had the following membership: John Kulick, Chair Jon Walter Rosdahl, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Masayuki Ariyoshi Ted Burse Stephen Dukes Jean-Philippe Faure J. Travis
44、Griffith Gary Hoffman Michael Janezic Joseph L. Koepfinger* David J. Law Hung Ling Andrew Myles T. W. Olsen Glenn Parsons Ronald C. Petersen Annette D. Reilly Stephen J. Shellhammer Adrian P. Stephens Yatin Trivedi Phillip Winston Don Wright Yu Yuan Daidi Zhong *Member Emeritus Copyright 2016 IEEE.
45、All rights reserved. viii Introduction This introduction is not part of IEEE Std C57.32-2015, IEEE Standard for Requirements, Terminology, and Test Procedures for Neutral Grounding Devices. Historically this standard developed from AIEE Standard 32, 1947. The standard was substantially revised to be
46、come IEEE Std 32 in 1972 and was reaffirmed in 1978, 1984, and 1990. This standard is a revision of IEEE Std 32-1972, to which many changes have been made. The Standard 32 was originally developed by the Neutral Grounding Subcommittee of the Surge Protective Devices Committee of the IEEE Power Engin
47、eering Society. In 2003, the responsibility for upkeep and maintenance of this standard was transferred to the Performance Characteristics Subcommittee of the Transformers Committee of the IEEE Power and Energy Society. This version is being published under a new number, C57.32, and has been complet
48、ely revised to bring it in line with the current technology. Each grounding device now has its own section with all requirements and test methods included. Old test methods that were developed in the 1930s and 1940s have lost their relevance over time. Conservative calculation methods were lost in h
49、istory and did not correlate to modern practices. To maintain a link to the old methods for now, Annex A is a copy of the old test code and is provided solely for reference purposes. Note that capacitors have been removed from this standard. They had traditionally been used on occasion for front of wave surges. They are rarely used today. The use of capacitors has evolved into blocking devices in the neutral of transformers to block Geomagnetically Induced Currents (GIC) from Geomagnetic Disturbances (GMD). The IEEE Capacitor Subcommittee of the Transmissi
