1、 IEEE Guide for Safety in AC Substation Grounding Sponsored by the Substations Committee IEEE 3 Park Avenue New York, NY 10016-5997 USA IEEE Power and Energy Society IEEE Std 80-2013 (Revision of IEEE Std 80-2000/ Incorporates IEEE Std 80-2013/Cor 1-2015) IEEE Std 80-2013 (Revision of IEEE Std 80-20
2、00/ Incorporates IEEE Std 80-2013/Cor 1-2015) IEEE Guide for Safety in AC Substation Grounding Sponsor Substations Committee of the IEEE Power and Energy Society Approved 11 December 2013 IEEE-SA Standards Board Copyrights and permissions: Annex E translated by T. W. Stringeld from Koch, W., “Erdung
3、smassnahmen fur Hochstspannungsanlagen mit Geerdetem Sternpunkt,” Electrotechnische Zeitschrift, vol. 71, no. 4, pp. 891, Feb. 1950. Annex F is taken from Dawalibi, F., and Mukhedkar, D., “Parametric analysis of grounding systems,” IEEE Transactions on Power Apparatus and Systems, vol. PAS-98, no. 5
4、, pp. 16591668, Sept./Oct. 1979; and Dawalibi, F., and Mukhedkar, D., “Inuence of ground rods on grounding systems,” IEEE Transactions on Power Apparatus and Systems, vol. PAS-98, no. 6, pp. 20892098, Nov./Dec. 1979. Annex G translated by T. W. Stringeld from Koch, W., “Erdungsmassnahmen fur Hochsts
5、pannungsanlagen mit Geerdetem Sternpunkt,” Electrotechnische Zeitschrift, vol. 71, no. 4, pp. 891, Feb. 1950. Abstract: This guide is primarily concerned with outdoor ac substations, either conventional or gas-insulated. These include distribution, transmission, and generating plant substations. Wit
6、h proper caution, the methods described herein are also applicable to indoor portions of such substations, or to substations that are wholly indoors. No attempt is made to cover the grounding problems peculiar to dc substations. A quantitative analysis of the effects of lightning surges is also beyo
7、nd the scope of this guide. Keywords: ground grids, grounding, IEEE 80TM, substation design, substation grounding The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2015 by The Institute of Electrical and Electronics Engineers, Inc. All
8、rights reserved. Published 15 May 2015. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all
9、conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or pro
10、vide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing
11、and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely u
12、pon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, seek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SP
13、ECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHE
14、RWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE WAS FORESEEABLE. Translations The IEEE consensus development process involves the review of documents in English only. In t
15、he event that an IEEE standard is translated, only the English version published by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered o
16、r inferred to be the official position of IEEE or any of its committees and shall not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or
17、her views should be considered the personal views of that individual rather than the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide
18、consulting information or advice pertaining to IEEE Standards documents. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any
19、 responses to comments and questions also receive the concurrence of a balance of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has pr
20、eviously been addressed. For the same reason, IEEE does not respond to interpretation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary,
21、 IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regulations Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements
22、. Implementers of the standard are responsible for observing or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrig
23、hts IEEE draft and approved standards are copyrighted by IEEE under U.S. and international copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regula
24、tion, standardization, and the promotion of engineering practices and methods. By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents. Photocopies Subject to payment of the appropriate fee, IEEE w
25、ill grant users a limited, non-exclusive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Dri
26、ve, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documen
27、ts may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or
28、errata then in effect. Every IEEE standard is subjected to review at least every ten years. When a document is more than ten years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of th
29、e art. Users are cautioned to check to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE-SA Website at http:
30、/ieeexplore.ieee.org/xpl/standards.jsp or contact IEEE at the address listed previously. For more information about the IEEE SA or IEEEs standards development process, visit the IEEE-SA Website at http:/standards.ieee.org. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA
31、Website at the following URL: http:/standards.ieee.org/findstds/errata/index.html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By public
32、ation of this standard, no position is taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE-SA
33、Website at http:/standards.ieee.org/about/sasb/patcom/patents.html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of
34、 any unfair discrimination to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into t
35、he legal validity or scope of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that deter
36、mination of the validity of any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association. Copyright 2015 IEEE. All rights reserved. viParticipants IEEE Std 80-2013 At the time this IEEE g
37、uide was completed, the Grounding (PE/SUB/WGD7) Working Group had the following membership: Richard P. Keil, Chair Curtis R. Stidham, Secretary Hanna Abdallah Stan J. Arnot Thomas Barnes Bryan Beske Dale Boling Steven Brown James Cain Bill Carman K. S. Chan Koushik Chanda Carson Day Dennis DeCosta E
38、. Peter Dick William K. Dick Marcia Eblen D. Lane Garrett Joseph Gravelle Steven Greenfield Charles Haahr Thomas Harger Martin Havelka Dave Kelley Donald N. Laird Henri Lemeilleur Cary Mans Sakis Meliopoulos Mike Noori Shashi G. Patel Christian Robles Jesse Rorabaugh Hamid Sharifnia William Sheh Dou
39、glas Smith David Stamm Greg J. Steinman Brian Story Yance Syarif Keith Wallace Alexander Wong The following members of the individual balloting committee voted on this guide. Balloters may have voted for approval, disapproval, or abstention. William Ackerman Michael Adams Ali Al Awazi Ficheux Arnaud
40、 Stan J. Arnot Adam Bagby Thomas Barnes George Bartok George Becker W. J. (Bill) Bergman Bryan Beske Steven Bezner Wallace Binder Michael Bio Derek Brown Steven Brown William Bush William Byrd James Cain Thomas Callsen K. S. Chan Koushik Chanda Robert Christman Randy Clelland Chuanyou Dai Ray Davis
41、Dennis DeCosta Charles DeNardo Gary Donner Michael Dood Douglas Dorr Randall Dotson Gearoid OhEidhin C. Erven Dan Evans Keith Flowers Rabiz Foda Doaa Galal D. Lane Garrett Frank Gerleve David Giegel David Gilmer Jalal Gohari Edwin Goodwin James Graham Lance Grainger Joseph Gravelle Steven Greenfield
42、 Randall Groves Ajit Gwal Charles Haahr Thomas Harger Martin Havelka Lee Herron Scott Hietpas Robert Hoerauf Gary Hoffman Richard P. Keil Gael Kennedy Mohamed Abdel Khalek Yuri Khersonsky James Kinney Joseph L. Koepfinger* David Krause Jim Kulchisky Saumen Kundu Donald N. Laird Chung-Yiu Lam Benjami
43、n Lanz Michael Lauxman Duane Leschert Hua Liu Debra Longtin Greg Luri Bruce Mackie John Mcalhaney, Jr. John Merando T. David Mills Georges Montillet Kimberly Mosley Adi Mulawarman Jerry Murphy Arun Narang Dennis Neitzel Arthur Neubauer Michael Newman Matthew Norwalk Robert Nowell Ted Olsen Lorraine
44、Padden Shashi G. Patel Donald Platts Percy Pool Copyright 2015 IEEE. All rights reserved. vii Moises Ramos Reynaldo Ramos Michael Roberts Charles Rogers Jesse Rorabaugh Thomas Rozek Steven Sano Bartien Sayogo Dennis Schlender Robert Schuerger Hamid Sharifnia Devki Sharma William Sheh Suresh Shrimavl
45、e Gil Shultz Hyeong Sim Garry Simms David Singleton Douglas Smith Jerry Smith David Solhtalab Curtis R. Stidham Gary Stoedter Brian Story Raymond Strittmatter Peter Sutherland Michael Swearingen William Taylor David Tepen Wayne Timm John Toth Joe Uchiyama Eric Udren Marcelo Valdes John Vergis Jane V
46、erner Keith Wallace S. Frank Waterer Donald Wengerter Kenneth White James Wilson Alexander Wong Jonathan Woodworth Larry Young Roland Youngberg Jian Yu Luis Zambrano When the IEEE-SA Standards Board approved this guide on 11 December 2013, it had the following membership: John Kulick, Chair David J.
47、 Law, Vice Chair Richard H. Hulett, Past Chair Konstantinos Karachalios, Secretary Masayuki Ariyoshi Peter Balma Farooq Bari Ted Burse Stephen Dukes Jean-Philippe Faure Alexander Gelman Mark Halpin Gary Hoffman Paul Houz Jim Hughes Michael Janezic Joseph L. Koepfinger* Oleg Logvinov Ron Petersen Gar
48、y Robinson Jon Walter Rosdahl Adrian Stephens Peter Sutherland Yatin Trivedi Phil Winston Yu Yuan *Member Emeritus Also included are the following non-voting IEEE-SA Standards Board liaisons: Richard DeBlasio, DOE Representative Michael Janezic, NIST Representative Don Messina IEEE-SA Content Produc
49、tion and Management Erin Spiewak IEEE-SA Technical Program Operations Copyright 2015 IEEE. All rights reserved. viiiIEEE Std 80-2013/Cor 1-2015 Participants At the time this IEEE corrigendum was completed, the Grounding (PE/SUB/WGD7) Working Group had the following membership: Richard P. Keil, Chair Curtis R. Stidham, Secretary Hanna Abdallah Stan J. Arnot Thomas Barnes Bryan Beske Dale Boling Steven Brown James Cain Bill Carman K. S. Chan Koushik Chanda Carson Day Dennis DeCosta E. Peter Dick William K. Dick Marcia Eblen D. Lane Garrett Joseph Gra
