1、IEEE Standard Test Specifications for Surge-Protective Devices (SPDs) for Use on the Load Side of the Service Equipment in Low-Voltage (1000 V and Less) AC Power Circuits IEEE Std C62.62-2018 (Revision of IEEE Std C62.62-2010) IEEE Power and Energy Society Sponsored by the Surge Protective Devices C
2、ommittee IEEE 3 Park Avenue New York, NY 10016-5997 USAIEEE Std C62.62-2018 (Revision of IEEE Std C62.62-2010) IEEE Standard Test Specifications for Surge-Protective Devices (SPDs) for Use on the Load Side of the Service Equipment in Low-Voltage (1000 V and Less) AC Power Circuits Sponsor Surge Prot
3、ective Devices Committee of the IEEE Power and Energy Society Approved 15 February 2018 IEEE-SA Standards BoardAbstract: Surge-protective devices (SPDs) intended to be installed on the load side of the service equipment connected to 50 Hz or 60 Hz ac power circuits rated at 1000 V (root mean squared
4、 rms) or less are the focus of this standard. Performance characteristics and standard methods for testing and rating are established for these devices, which may be composed of any combination of components. The tests in this standard are aimed at providing comparisons among the variety of SPDs ava
5、ilable. Keywords: combination wave, current-driven test, disconnector, IEEE C62.62, induced failure, maximum continuous operating voltage, MCOV, nominal discharge current, one-port SPD, operational duty cycle, ring wave, SCCR, service equipment, short-circuit current rating, SPD, SPD Type, surge pro
6、tection, surge tests, surge-protective device, temporary overvoltage, TOV, transient voltage-surge suppressor, TVSS, two-port SPD, Type 1 Component Assembly, Type 1 SPD, Type 2 Component Assembly, Type 2 SPD, Type 3 Component Assembly, Type 3 SPD, Type 4 Component Assemblies, Type 5 SPD The Institut
7、e of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2018 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 14 August 2018. Printed in the United States of America. IEEE is a registered trademark in the U.S.
8、 Patent fitness for a particular purpose; non-infringement; and quality, accuracy, effectiveness, currency, or completeness of material. In addition, IEEE disclaims any and all conditions relating to: results; and workmanlike effort. IEEE standards documents are supplied “AS IS” and “WITH ALL FAULTS
9、.” Use of an IEEE standard is wholly voluntary. The existence of an IEEE standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE standard. Furthermore, the viewpoint expressed at the time a
10、 standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. In publishing and making its standards available, IEEE is not suggesting or rendering professional or other services for, or on behalf of
11、, any person or entity nor is IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing any IEEE Standards document, should rely upon his or her own independent judgment in the exercise of reasonable care in any given circumstances or, as appropriate, s
12、eek the advice of a competent professional in determining the appropriateness of a given IEEE standard. IN NO EVENT SHALL IEEE BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO: PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOS
13、S OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE PUBLICATION, USE OF, OR RELIANCE UPON ANY STANDARD, EVEN IF ADVISED OF THE POSSIBILITY
14、 OF SUCH DAMAGE AND REGARDLESS OF WHETHER SUCH DAMAGE W AS FORESEEABLE.4 Copyright 2018 IEEE. All rights reserved. Translations The IEEE consensus development process involves the review of documents in English only. In the event that an IEEE standard is translated, only the English version publishe
15、d by IEEE should be considered the approved IEEE standard. Official statements A statement, written or oral, that is not processed in accordance with the IEEE-SA Standards Board Operations Manual shall not be considered or inferred to be the official position of IEEE or any of its committees and sha
16、ll not be considered to be, or be relied upon as, a formal position of IEEE. At lectures, symposia, seminars, or educational courses, an individual presenting information on IEEE standards shall make it clear that his or her views should be considered the personal views of that individual rather tha
17、n the formal position of IEEE. Comments on standards Comments for revision of IEEE Standards documents are welcome from any interested party, regardless of membership affiliation with IEEE. However, IEEE does not provide consulting information or advice pertaining to IEEE Standards documents. Sugges
18、tions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Since IEEE standards represent a consensus of concerned interests, it is important that any responses to comments and questions also receive the concurrence of a balance
19、of interests. For this reason, IEEE and the members of its societies and Standards Coordinating Committees are not able to provide an instant response to comments or questions except in those cases where the matter has previously been addressed. For the same reason, IEEE does not respond to interpre
20、tation requests. Any person who would like to participate in revisions to an IEEE standard is welcome to join the relevant IEEE working group. Comments on standards should be submitted to the following address: Secretary, IEEE-SA Standards Board 445 Hoes Lane Piscataway, NJ 08854 USA Laws and regula
21、tions Users of IEEE Standards documents should consult all applicable laws and regulations. Compliance with the provisions of any IEEE Standards document does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing or referring to th
22、e applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights IEEE draft and approved standards are copyrighted by IEEE under U.S. and in
23、ternational copyright laws. They are made available by IEEE and are adopted for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self-regulation, standardization, and the promotion of engineering practices and methods.
24、By making these documents available for use and adoption by public authorities and private users, IEEE does not waive any rights in copyright to the documents.5 Copyright 2018 IEEE. All rights reserved. Photocopies Subject to payment of the appropriate fee, IEEE will grant users a limited, non-exclu
25、sive license to photocopy portions of any individual standard for company or organizational internal use or individual, non-commercial use only. To arrange for payment of licensing fees, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 75
26、0 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Updating of IEEE Standards documents Users of IEEE Standards documents should be aware that these documents may be superseded at any time by
27、the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. A current official IEEE document at any point in time consists of the current edition of the document together with any amendments, corrigenda, or errata then in effect. Every
28、IEEE standard is subjected to review at least every 10 years. When a document is more than 10 years old and has not undergone a revision process, it is reasonable to conclude that its contents, although still of some value, do not wholly reflect the present state of the art. Users are cautioned to c
29、heck to determine that they have the latest edition of any IEEE standard. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Xplore at http:/ ieeexplore .ieee .or g/ or contac
30、t IEEE at the address listed previously. For more information about the IEEE-SA or IEEEs standards development process, visit the IEEE-SA Website at http:/ standards .ieee .or g. Errata Errata, if any, for all IEEE standards can be accessed on the IEEE-SA Website at the following URL: http:/ standar
31、ds .ieee .org/ findstds/ errata/ index .html. Users are encouraged to check this URL for errata periodically. Patents Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no position i
32、s taken by the IEEE with respect to the existence or validity of any patent rights in connection therewith. If a patent holder or patent applicant has filed a statement of assurance via an Accepted Letter of Assurance, then the statement is listed on the IEEE- SA Website at http:/ standards .ieee .o
33、r g/ about/ sasb/ patcom/ patents .html. Letters of Assurance may indicate whether the Submitter is willing or unwilling to grant licenses under patent rights without compensation or under reasonable rates, with reasonable terms and conditions that are demonstrably free of any unfair discrimination
34、to applicants desiring to obtain such licenses. Essential Patent Claims may exist for which a Letter of Assurance has not been received. The IEEE is not responsible for identifying Essential Patent Claims for which a license may be required, for conducting inquiries into the legal validity or scope
35、of Patents Claims, or determining whether any licensing terms or conditions provided in connection with submission of a Letter of Assurance, if any, or in any licensing agreements are reasonable or non-discriminatory. Users of this standard are expressly advised that determination of the validity of
36、 any patent rights, and the risk of infringement of such rights, is entirely their own responsibility. Further information may be obtained from the IEEE Standards Association.6 Copyright 2018 IEEE. All rights reserved. Participants At the time this standard was completed, Working Group 3.6.6 had the
37、 following members and/or contributors to this standard: Ronald W . Hotchkiss, Chair Andrea Haa, Vice Chair Martin Guy, Secretary Robert Ashton Frank Basciano Kenneth Brown Dan Buchanon William Bush Thomas Colcombe Bryan Cole Joseph DeGregoria Doug Dorr Robert Douglass Leonard Drewes Daniel Ellis Lo
38、uis Farquhar Raymond Hill Chuck Jensen Joseph L. Koepfinger Albert Martin Michael Maytum Craig McKenzie Steve Millard James Moellmann Carey Mossop Richard Odenberg Wolfgang Oertel Thomas Phipps Paul Saa Piyush Saxena Antony Surtees Rick Syverson James Tiesi William Travis Matthew Wakeham Frank Water
39、er Mark Wingate The following members of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Saleman Alibhay Robert Ashton Thomas Barnes Frank Basciano Steven Bezner William Bloethe Kenneth Bow Roger Boyell Andrew Brown Kennet
40、h Brown Gustavo Brunello William Byrd Thomas Callsen Paul Cardinal Bryan Cole Stephen Conrad Glenn Davis Matthew Davis Joseph DeGregoria Davide De Luca Carlo Donati Gary Donner Cliff Erven Louis Farquhar Keith Flowers Rostyslaw Fostiak Jalal Gohari Stephen Grier Randall Groves Ajit Gwal Steven Hensl
41、ey Lee Herron Raymond Hill Werner Hoelzl Philip Hopkinson Ronald W. Hotchkiss Laszlo Kadar Sheldon Kennedy Yuri Khersonsky Joseph L. Koepfinger Boris Kogan Bruce Kraemer Jim Kulchisky Paul Lindemulder Albert Martin Michael Maytum Omar Mazzoni C. Michael Miller James Moellmann Jerry Mosesian Brian Mu
42、galian R. Murphy K. R. M. Nair Michael Newman Hans-Wo Oertel Lorraine Padden Bansi Patel Thomas Phipps Alvaro Portillo Robert Resuali Michael Roberts Thomas Rozek Bartien Sayogo Nikunj Shah Veselin Skendzic Jerry Smith Gary Smullin Wayne Stec K. Stump David Tepen James Tiesi Marcelo V aldes Roger V erdolin John V ergis Matthew Wakeham Lanyi Wang Daniel Ward Hung-Y u Wei Kenneth White James Wilson Jian Y u Donald Zipse
