ASTM D4608-89(2017) Standard Test Method for Citrate in Detergents.pdf
《ASTM D4608-89(2017) Standard Test Method for Citrate in Detergents.pdf》由会员分享,可在线阅读,更多相关《ASTM D4608-89(2017) Standard Test Method for Citrate in Detergents.pdf(3页珍藏版)》请在麦多课文档分享上搜索。
1、Designation: D4608 89 (Reapproved 2017)Standard Test Method forCitrate in Detergents1This standard is issued under the fixed designation D4608; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last revision. A number in
2、parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method covers a potentiometric titration pro-cedure for the determination of citrate in liquid and powderdetergents.1.2 The values stat
3、ed in SI units are to be regarded asstandard. No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and
4、 health practices and determine the applica-bility of regulatory limitations prior to use. Material SafetyData Sheets are available for reagents and materials. Reviewthem for hazards prior to usage. Specific safety precautions aregiven in Section 8.2. Referenced Documents2.1 ASTM Standards:2E70 Test
5、 Method for pH of Aqueous Solutions With theGlass ElectrodeE180 Practice for Determining the Precision of ASTMMethods for Analysis and Testing of Industrial and Spe-cialty Chemicals (Withdrawn 2009)33. Summary of Test Method3.1 The sample is titrated in an aqueous solution buffered atpH 8.5, with st
6、andard copper sulfate solution. The endpoint isdetected potentiometrically using a copper ion selective elec-trode. The citrate content is calculated from the amount ofstandard copper sulfate solution consumed.4. Significance and Use4.1 This test method is suitable in research, development,and manuf
7、acturing control to monitor the level of citrate, asequestering agent, in powder and liquid detergents.4.2 Accurate determination of sequestering agent is impor-tant in evaluating cost and performance of detergent products.5. Interferences5.1 Other complexing agents such as nitrilotriacetic acid(NTA
8、), ethylenedinitrilotetraacetic acid (EDTA), phosphates,etc. will titrate as citrate in this method. For accurate citratedeterminations, such complexing agents must be absent.6. Apparatus6.1 pH Meter, with millivolt capability.46.2 Copper Ion Selective Electrode.56.3 Calomel Reference Electrode.66.4
9、 Glass Electrode Triple Purpose.76.5 Buret, semi-micro, 25 mL capacity with 0.1 mL gradu-ations.6.6 Magnetic Stirrer, and TFE-fluorocarbon-coated mag-netic stirring bars.7. Reagents7.1 Purity of ReagentsReagent grade chemicals shall beused in all tests. Unless otherwise indicated, it is intended tha
10、tall reagents shall conform to specifications of the Committeeon Analytical Reagents of the American Chemical Society,where such specifications are available.8Other grades may beused, provided it is first ascertained that the reagent is of1This test method is under the jurisdiction of ASTM Committee
11、 D12 on Soapsand Other Detergents and is the direct responsibility of Subcommittee D12.12 onAnalysis and Specifications of Soaps, Synthetics, Detergents and their Components.Current edition approved Jan. 1, 2017. Published February 2017. Originallyapproved in 1986. Last previous edition approved in
12、2009 as D4608 89(2009).DOI: 10.1520/D4608-89R17.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3The last app
13、roved version of this historical standard is referenced onwww.astm.org.4An automatic titrator may be used.5Orion Model 94-29A or equivalent has been found suitable for this purpose.Available from Orion Inc.6Orion Model 90-22 or equivalent has been found suitable for this purpose.Available from Orion
14、 Inc.7Corning Model No. 476022 or equivalent has been found suitable for thispurpose. Available from Corning Inc.8Reagent Chemicals, American Chemical Society Specifications, AmericanChemical Society, Washington, DC. For suggestions on the testing of reagents notlisted by the American Chemical Socie
15、ty, see Analar Standards for LaboratoryChemicals, BDH Ltd., Poole, Dorset, U.K., and the United States Pharmacopeiaand National Formulary, U.S. Pharmacopeial Convention, Inc. (USPC), Rockville,MD.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. Unit
16、ed StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers
17、 to Trade (TBT) Committee.1sufficiently high purity to permit its use without lessening theaccuracy of the determination.7.2 Purity of WaterUnless otherwise indicated, referenceto water shall be understood to mean distilled water or water ofequal purity.7.3 Hydrochloric Acid Solution (1 + 1)Slowly m
18、ix 1 vol-ume of concentrated hydrochloric acid (sp gr 1.19) with 1volume of water.7.4 Sodium Hydroxide Solution (20 %)Prepare a 20 %aqueous solution of sodium hydroxide.7.5 Sodium Hydroxide Solution (0.1 N)Prepare a 0.1 Naqueous solution of sodium hydroxide.7.6 Hydrochloric Acid Solution (0.1 N)Prep
19、are a 0.1 Naqueous solution of hydrochloric acid.7.7 Borate Buffer Solution (pH 8.5)Dissolve 12.8 g ofsodium borate (Na2B4O710H2O) and 16.6 g of boric acid(H3BO3) in about 900 mL of water.Adjust pH to 8.5 with 20 %NaOH solution. Transfer quantitatively into a 1-L volumetricflask. Dilute to volume wi
20、th water. Mix well.7.8 Sodium Thiosulfate Solution, Standard (0.1 N)Dissolve 25 g of sodium thiosulfate (Na2S2O35H2O) crystals infreshly boiled and cooled water and dilute to 1 L. Add 0.01 gof sodium carbonate and 0.5 mL of chloroform. Protect thesolution at all times from direct sunlight. Standardi
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
最后一页预览完了!喜欢就下载吧,查找使用更方便
5000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ASTM D4608-892017 Standard Test Method for Citrate in Detergents D4608 89 2017

链接地址:http://www.mydoc123.com/p-363003.html