1、 A-A-50329A 9999974 0370402 770 m -1 + Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data which may improve this document should be sent to: Defense Personnel Support Center, Clothing and Textiles Directorate, Am: DPSC-FNSC, 2800 South 20th Street, Philadel
2、phia, PA 19145-5099. b pcH-pOouND I A-A-50 129A A-A-5 O 129 September 18,1987 COMMERCIAL ITEM DESCRIPTION CLOTH, FLANNEL, LIGHTWEIGHT The General Services Administration has authorized the use of this commercial item description as a replacement for CCC-C-458 for all Federal agencies. 1. SCOPE 1.1 S
3、coDe. This commercial item description covers the requirements for one type of cotton flannel cloth used to manufacture pajamas, gloves, and interlining for coats and caps. 2. SALIENT cHARAcTERIs71cs 2.1 Description. The cloth shall be manufactured from a standard commercial cotton. It shall have a
4、plain weave and a napped finish on both sides. The color and width of the cloth shall be as specified in the contract or purchase order. 2.2 Physical characteristics. The cloth shall weigh a minimum of 4.0 ounces per square yard when tested in accordance with ASTM D-3776, Option C I/. The cloth shal
5、l have a minimum of 42 ends and 40 picks per inch when tested in accordance with ASTM D-3775 I/. The cloth shall have a minimum breaking strength of 23 pounds in the warp direction and 19 pounds in the filling direction when tested in accordance with ASTM D-1682, Section 16. The cloth shall have a m
6、aximum shrinkage rate of 2.0 percent in the warp direction and 2.0 percent in the filling direction when tested in accordance with AATCC 135, Procedure IIB. The cloth shall show colorfastness to laundering, crocking, and perspiration equal to or better than the standard sample when tested according
7、to AATCC 61, Test 3A zk AATCC 8 and AATCC 15 3/ respectively. The dyed and finished cloth shall show “good“ colorfastness to laundering and perspiration and have a Munsell value for crocking not lower than 8.5. 1/ Samples shall be conditioned as directed in “ASTM D-1776, Practice for Conditioning Te
8、xtiles for Testing“ prior to testhg. DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-50 129A - 2/ The specimen must be dried after each of the three laundering cycl
9、es. The soap solution shall contain 0.5 percent by weight, P-D-245, Detergent, Laundry, and Hand Dishwashing (Granular) Type II, in water hardness not over 50 parts per million. The weight of the specimen shall be 4.0 5 0.5 grams and the rotating time shall be 30 minutes with ten stainless steel bal
10、ls in each cylinder. 3/ The test for colorfstness for acid and alkaline solution shall apply. 2.2.1 Standard samde. The nished cloth shall match the standard sample for shade and appearance, and shall be equal to or better than the standard sample with respect to all Characteristics for which the st
11、andard sample is referenced. 2.2.2 Matching. Ail color of the finished cloth shall match the standard sample when viewed under filtered tungsten lamps that approximate artificial daylight and that have a correlated color temperature of 7500 2 200 K, with illumination of 100 5 20 foot candles, and sh
12、all be a good match to the standard sample under incandescent lamplight at 2300 2 200 K. 2.3 Len objectionable odor, width not as specified; poor dye penetration; mottled; streaky; cloudy; excessive nepiness. 4.3.1.3 Examination for lenrrth. During the yard-by-yard examination, each piece in the sam
13、ple shall be examined for length. Any length found to be less than the minimum specified or more than two yards below the length marked on the ticket shall be considered a defect wih respect to length. The lot shall be unacceptable if the total of the actual lengths of pieces in the sample is less t
14、han the total of the lengths marked on the tickets. 4.3.1.4 Examination for shade. During the yard-to-yard examination, each piece in the sample shall be examined for shade. Any piece in the sample which is off shade, shaded side to side, side to center, or end to end shall be cause for rejection fo
15、r the entire lot represented by the sample. 4.3.1.5 Examination for identification of meshrinkage urocess . comuliance with Textile Fiber Products Identification Act and face marking. During the yard-to-yard examination, each piece in the sample shall be examined for the defects listed below. The lo
16、t shall be unacceptable it two or more of the following defects are present in the sample: Preshrinkage process identified by name or trademark on cloth or ticket; not labeled or ticketed in accordance with Rules and Regulations under the Textile Fiber products Identification Act; face stamping miss
17、hg from either or both ends; face stamping on wrong side. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-S012%A E 9997934 0170405 48T W A-A-50129A 5. PACKAGING 5.1 Preservation, Dackinp;. and marking. The preservation, packing, and marking shall
18、 be as specified in the contract or purchase order. 6. NOTES 6.1 Source of Govemment documents. Copies of military and Federal documents are available fim: Standardization Documents Order Desk Bldg. 4D 700 Robbins Avenue Philadelphia, PA 19 1 1 1-5094 Rules and Regulations Under the Textile Fiber Pr
19、oducts Identification Act (Copies may be obtained without charge fkom the Federal Trade Commission, Washington, DC 20580-000 1 .) 6.2 Source of non-Government documents ASTM Test Methods (Applications for copies should be addressed to American Society For Testing and Materials (ASTM), 100 Barr Harbo
20、r Drive, West Conshohocken, PA 19428-2959.) AATCC Test Methods (Applications for copies should be adbsed to American Association of Textile Chemists and Colorists (AATCC), P.O. Box 12215, Triangle Park, NC 27709-2215.) MILITARY INTERESTS: Custodians: Navy - NU AirForce-99 Army - GL Review Activities: Navy - MC Air Force - 45,32,82 CIVIL AGENCY COORDINATING ACTIVITY; GSA - FSS PREPARDIGACTIVLTY: DLA - CT (Project 8305-0513) i z 4 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
