AIA NAS 1652-1979 (Inactive)Connector Receptacle Electrical Single- Hole Mount Bayonet Coupling Superseded - August 1979 (Use MS3474) (Rev 3).pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

STAS SR ISO 1880-1994 Instruments for the measurement of surface roughness by the profile method - Contact (stylus) instruments of progressive profile transformation - Profile reco.pdf

STAS SR ISO 1925-1995 Balancing -Vocabulary《平衡．词汇 》.pdf

STAS SR ISO 1928-1995 Solid mineral fuels Determination of gross calorific value by the calorimeter bomb method and calculation of net calorific value《固体矿物燃料．热量计炸弹法对总热值和计算法对净热值的测定 .pdf

STAS SR ISO 1940-1-1986 Mechanical vibration - Balance quality requirements of rigid rotor Part 1 Determination of permissible residual unbalance《机械振动．刚性旋转器的平衡质量要求．第1部分：允许残留紊乱的测定》.pdf

STAS SR ISO 1949-1995 Aircraft Electrical connectors Design requirements《飞机．电连接器．设计要求》.pdf

STAS SR ISO 1971-1996 Aircraft - Accessory drive and mounting pads《飞行器．辅助传动装置和安装缓冲垫 》.pdf

STAS SR ISO 1984-0-1984 Test conditions for milling machines wlth table of fixed height with horizontal or vertical spindle Part 0 Genemi introduction《以固定表面高度，横向和纵向主轴的铣床测试条件．第0部分：.pdf

STAS SR ISO 1996-1-1995 Acoustics - Description and measurement of environmental noise Part 1 Basic quantities and procedures《术语．环境噪声的描述和测量．第1部分：基本数量和程序 》.pdf

STAS SR ISO 1996-2-1995 Acoustics - Description and measurement of the environmental noise -Part 2 Acquisition of data pertinent to land use《术语．环境噪声的描述和测量．第2部分：数据获取的有关土地使用情况 》.pdf