1、AMSC N/A FSC 1650 MS20813F 4 November 2011 SUPERSEDING MS20813E 26 August 1987 MILITARY SPECIFICATION SHEET CAP, PNEUMATIC VALVE, HIGH PRESSURE This specification is approved for use by all Department and Agencies of the Department of Defense. INCH-POUND Reactivated after 4 November 2011 and may be
2、used for new and existing designs and acquisitions Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS20813F 2 Notes: 1. Dimensions in inches. Unless otherwise specified, tolerances decimals .016. 2. Remove all burrs and sharp edges. 3. Material: Shel
3、l and swivel seat plate brass, specification ASTM-B16/B16M. 4. Finish: Permanent non-flaking yellow lacquer external surface of cap. Tolerances apply after application. 5. For acceptable products, see QPL-5500. 6. Reference to international standardization agreement deleted. 7. This standard takes p
4、recedence over documents referenced herein. Referenced documents shall be of the issue in effect on date of invitations for bid. Change from previous issue. Marginal notations are not use in this revision to identify changes with respect to the previous issue due to the extent of the changes. CONCLU
5、DING MATERIAL Custodians: Preparing activity: Army - AV Air Force - 71 Navy - AS Air Force - 71 (Project 1650-2009-001) Review activities Air Force - 99 DLA-GS NOTE: The activities listed above were interested in this document as of the date of this document. Since organization and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil . Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
