1、MIL-C-5 07 4 3 (AR) AMENDMENT 3 30 April 1991 SUPERSEDING AMENDMENT 2 17 November 1976 MILITARY SPECIFICATION CONTROL, POWER SUPPLY, LASER: C9135( ) WG-1: 11738831 This amendment forms a part of MIL-C-50743 (AR) , dated 8 August 1973, and is approved for use by the U.S. Army Armament, Munitions, and
2、 Chemical Command, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 3 3.2.1, at end of paragraph, add: “Soldering of printed wiring assemblies in accordance with MIL-S- 46844 is the preferred method.“ PAGE 10 Figure 4: Delete “1.8 f 0.8 rnsecll and substitu
3、te Il1.8 f 1.0 msecll. PAGE 12 * Figure 6: Delete “*0.6 f 0.3 sec! and substitute “*0.8 f 0.6 secf1 Delete note It* At the temperature extremes - shall be 0.6 f 0.5 sec.“ in its entirety and substitute: t*At the temperature extremes of 3.3.2.2 the pulse width shall be 100 k 60 msec, and the pulse sp
4、acing shall be 0.8 f 0.4 sec.It NOTE: The margins of this amendment are marked with an asterisk or vertical lines to indicate where changes (additions, modifications, corrections, deletions) from the previous amendment were made, This was done as a convenience only, and the Government assumes no lia
5、bility whatsoever for any inaccuracies in these notations. .Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous amendment. Custodian: Preparing Activity: Army - AR Army - AR e (Project 1240-AB16) AMSC N/A 1 OF 1 FSC 1240 Distribution Statement A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
