1、t- 3 /35-0s MIL-1-55538 (3) bb 99999Ob 0343995 4 M MIL-I-55538(ER) AMENDMENT 1 14 September 1981 MILITARY SPECIFICATION INFLATION-LAUNCHING DEVICE, BALLOON, METEOROLOGICAL ML-594( )/U This amendment forms a part of Military Specification MIL-I-55538(EL), dated 8 April 1968, and is approved for use b
2、y the Electronics Research and Development Command, Department of the Army and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 2.1 Delete and substitute: “2.1 Issues of documents. The effective issue or revision of the following documents shall be that liste
3、d in the epartment of Defense Index of Specifications and Standards (DODISC) and supplements thereto, unless (i) specific issues are set forth therefor in the cited specifications or (ii) different issues than those specified in the cited specifications are set forth in the solicitation. The date of
4、 the applicable DoDISS and supplements thereto shall be as specified in the solicitation or contract.11 Add the following “Beneficial Commentst1 note on the bottom center of the first page: Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in impr
5、oving this document should be addressed to: Commander, US Army Electronics Research and Development Command, ATTN: DELCS-PE, Fort Monmouth, NJ 07703, by using the self-addressed, Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.“ *US. GO
6、VERNMENT PRINTING OFFICE: 1981-703-023/7130 1 of 4 -. , L FSC 6660 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-I MIL-1-55538 (3) 66 7977706 0343776 6 - MIL-I-55538(ER) SPECIFI
7、CATIONS, FEDERAL: Delete the following documents: “PPP-B-636 Boxes; Fiberboard “PPP-B-640 . Box Fiberboard, Corrugated, Triple-wall “PPP-F-320 Fiberboard, Corrugated “PPP-S-760 Strapping, Nonmetallic, and Connectors “PPP-T-97 Tape, Pressure-Sensitive Adhesive, Filament Reinforced11 PAGE 2 SPECIFICAT
8、IONS, MILITARY: Delete llMIL-P-43291 Box, Fiberboard, Corrugated, Double-wall, Weather Resistantt1 and add 11MIL-P-11268 Parts, Materials and Processes Used in Electronic Equipmentt1 STANDARDS, MILITARY: Add “MIL-STD-726 Packaging Requirements Codeq1 PAGE 3 2.2 Delete and substitute the following: 1
9、12.2 Other publications. The effective issue or revision of the following documents shall be that listed in the Department of Defense Index of Specifications and Standards (DoDISS) and supplements thereto, unless (i) specific issues are set forth therefor in the cited specifications or (ii) differen
10、t issues than those specified in the cited specifications are set forth in the solicitation. The date of the applicable DoDISS and supplements thereto shall be as specified in the solicitation or contract.ll 3.1 Delete and substitute the following: ll3.1 First article. When specified, the contractor
11、 shall furnish sample units for first article inspection and approval (see 4.3 and 6.2e).11 Add the following paragraph after 3.3: “3.3.1 Additional requirements. In addition to the requirements of this specification, the following shall apply: “a. Requirements of MIL-P-11268, including selection re
12、quirements therein. “b. Recycled, virgin and reclaimed materials. Without jeopardizing the intended use of equipment furnished . to this specification, selection of materials will be governed by the following: “(1) There is not exclusion to the use of recovered materials. %!) There is no requirement
13、 that equipment be manufactured from virgin materials. “(3) Reclaimed materials are required to the maximum extent possible.11 2 Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MI
14、L-I-5553 (I) 66 9977706 OII777 PAGE 7 4.1 Delete and substitute: 114.1 Responsibility for inspection. Unless otherwise specified in the contract, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract, the c
15、ontractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the government. The government resrves the right to perform any of the inspections set forth in the specification where such inspections are deemed ne
16、cessary to assure supplies and services conform to prescribed requirements.11 Q.Z(a): Delete and substitute IIFirst article inspection (see 4.3).11 PAGE 8 4.2(c)(l): Delete llpreparation for deliveryt1 and substitute “packaging.“ 4.2(c)(2): Delete llpreparation for deliveryf1 and substitute llpackag
17、ing.ll 4.3, line 1: Delete llPreproductionll and substitute “First article.11 4.4: Delete “preparation for deliveryf1 and substitute “packaging.“ 4.5, line 1: Delete “preparation for delivery“ and substitute “packaging.“ PAGE 10 4.5.3.1(a): Delete llpreproductionll and substitute “first article.“ 4.
18、5.3.2, line 4: Delete llpreposedll and substitute PAGE 15 4.19: Delete and substitute the following: 114.19 Quality conformance inspection of ackaginq. Quality conformance inspection of packaging shall be in accordance with !he group A, group B, and when required (see 6.2d), the group C (rough handl
19、ing) requirements of MIL-P-116. Inspection lots shall be in accordance with MIL-P-116.I1 5. through 5.1.1.1: Delete and substitute the following: “5. PACKAGING “5.1 Preservation. Preservation shall be as specified in MIL-STD-726, coded as follows: 3 Copyright Communications - Electronics Command Pro
20、vided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-15.1.1 Level A. JR-l-l-OO-NS-X-F2-OO-A. 51.2 Level B. JR-l-l-OO-NS-X-F3-OO-B. “5.2 Packinq. Not required. Unit container shall serve as the exterior container. 53 Markinq. In additi
21、on to any special marking required by the contract or order, interior packs and exterior shipping containers shall be marked in accordance with MIL -CTD-129.“ PAGE 16 Delete 5.1.1.2 through 5.2.2. PAGE 17 Delete 5.2.3 and 5.3. 6.2(c): Delete and substitute “(c) Level A or B preservation and packing
22、(see section 51.“ 6.2(d): Delete and substitute: “When rough handling test is required (see section 41.“ 6.2(e): Delete !preproduction“ and substitute “first article.ll PAGE 18 Add new paragraph: 6.5 Environmental. Environmental pollution prevention measures are contained in the packaging material s
23、pecif ications referenced herein. Refer to material specifications or preparing activity for recommended disposability methods.“ Custodian: Army - ER 4 Preparing activity: (Project 6660-A058) Army - ER Copyright Communications - Electronics Command Provided by IHS under license with CRAINot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
