1、2016 ASHRAE. All rights reserved. ERRATA SHEET FOR ANSI/ASHRAE STANDARD 103-2007 Methods of Testing for Annual Fuel Utilization Efficiency of Residential Central Furnaces and Boilers August 26, 2016 The corrections listed in this errata sheet apply to ANSI/ASHRAE Standard 103-2007. The first printin
2、g is identified on the outside back cover as “86318 6/08”, the second printing as “Product code: 86318 8/13” and the third printing as “Product code 86318 7/15 Errata Dated June 20, 2016 has been corrected.” The shaded item has been added since the previously published errata sheet dated June 20, 20
3、15 was distributed. The erratum identified with an asterisk “*” applies only to the second printing. Only the shaded erratum applies to the third printing. Page Erratum 28* Table 8 Fuel Characteristics and Parameters for Calculating Steady-State Sensible Heat Loss (LS,SS) and Steady-State Efficiency
4、 (EffSS). In the equation at the top of Table 8 change “,S,SS = ” to “LS,SS= ”. 28 Table 8 Fuel Characteristics and Parameters for Calculating Steady-State Sensible Heat Loss (LS,SS) and Steady-State Efficiency (EffSS). Under CF (5) for No. 2 Fuel Oil replace “1.5029209 x 10-16” with “1.5029209 x 10
5、-16”. 50 Informative Appendix C Calculation of Furnace and Boiler Comparative Average Annual Cost. Replace the current equation for burner operating hours (BOHSS) and add a new variable K4as shown below. Replace the current equation for BODSS BOHSS = 2080(0.77)(A)(QOUT/(1 + ) 2080(B) with the corrected equation BODSS = 2080(0.77)(A)(QOUT/K4)/(1 + ) 2080(B) Add the new variable K4 as defined below. where K4 = Conversion factor, 1000 Btu/kBtu or 1000 Btu per hr/kBtu per hour
