ASTM D7197-2006 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《2-22岁女性身体测量的标准表》.pdf

上传人:sofeeling205 文档编号:524786 上传时间:2018-12-04 格式:PDF 页数:4 大小:72.17KB
下载 相关 举报
ASTM D7197-2006 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《2-22岁女性身体测量的标准表》.pdf_第1页
第1页 / 共4页
ASTM D7197-2006 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《2-22岁女性身体测量的标准表》.pdf_第2页
第2页 / 共4页
ASTM D7197-2006 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《2-22岁女性身体测量的标准表》.pdf_第3页
第3页 / 共4页
ASTM D7197-2006 Standard Table of Body Measurements for Misses Maternity Sizes Two to Twenty-Two (2-22)《2-22岁女性身体测量的标准表》.pdf_第4页
第4页 / 共4页
亲,该文档总共4页,全部预览完了,如果喜欢就下载吧!
资源描述

1、Designation: D 7197 06Standard Table ofBody Measurements for Misses Maternity Sizes Two toTwenty-Two (2-22)1This standard is issued under the fixed designation D 7197; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of las

2、t revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 This standard table lists the body measurements ofpregnant women from misses size two to twenty-two.Althoughthese are bo

3、dy measurements, they can be used in designingapparel for women in this size range when such factors asfabric type, ease of body movement, styling, and fit are takeninto account.1.2 The values stated in either SI units or in inch-poundunits shall be regarded separately as standard. The values stated

4、in each system may not be exact equivalents; therefore, eachsystem must be used independently of the other, withoutcombining values in any way.2. Referenced Documents2.1 ASTM Standards:2D 123 Terminology Relating to TextilesD 5219 Terminology Relating to Body Dimensions forApparel Sizing2.2 ISO Stan

5、dard:Size Designation of Clothes, Definitions and Body Mea-surements Procedures for Apparel Sizes33. Terminology3.1 Definitions:3.1.1 Refer to Terminologies D 123 and D 5219.4. Significance and Use4.1 The use of the body measurement information in Table1 will assist manufacturers in the development

6、of patterns andgarments that are consistent with the current anthropometriccharacteristics of the population of interest. This practice inturn should reduce or minimize consumer confusion anddissatisfaction related to apparel sizing. (Also refer to ISO SizeDesignation standards.)5. Apparatus5.1 All

7、apparatus are calibrated for accuracy.5.2 Tape Measure, dimensionally stable and approximately1.5 cm (12 in.) wide and graduated accurately in centimetres(116 in.).5.3 Scale (Calibrated for Standard Body Weight).6. Procedures Used for Taking Measurements6.1 General Procedure:6.1.1 For all vertical a

8、nd most horizontal measurements,subject is to be standing erect without shoes and with feetapproximately 15 cm (6 in.) apart.6.1.2 Take measurements over basic undergarments nor-mally worn.6.1.3 For consistency, take all measurements except torsocircumferences, height, and weight on the same side of

9、 thebody.6.1.4 Refer to Terminology D 5219 for the location of allpoints to be measured (see Section 2).6.2 Body Measurements:6.2.1 Across Back Shoulder WidthMeasure the horizontaldistance across the back from the top of one shoulder joint tothe top of the other shoulder joint taken with the arms ha

10、ngingdown.6.2.2 Ankle GirthMeasure the maximum horizontal cir-cumference of the ankle taken over the greatest prominence ofthe ankle bones.6.2.3 Ankle HeightMeasure the vertical distance from theprominence of the outer ankle bone to the floor taken with thesubject standing and without shoes.6.2.4 Ar

11、m Length (Cervicale to Wrist)Measure from thedistance from the cervicale over the top of the shoulder joint,along the outside of the arm over the elbow to the prominentwrist bone taken with the arm bent 1.57 radius (at 90) and thehand placed on the hip.6.2.5 Arm Length (Shoulder to Elbow)Measure fro

12、m thetop of the shoulder to the elbow.1This table is under the jurisdiction of ASTM Committee D13 on Textiles andis the direct responsibility of Subcommittee D13.55 on Body Measurement forApparel Sizing.Current edition approved Jan. 1, 2006. Published February 2006.2For referenced ASTM standards, vi

13、sit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3Available from American National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New Yor

14、k, NY 10036.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.TABLE1NewASTMMaternityMeasurementTableMISSESMATERNITY(SIZES222)GIRTHMEASUREMENTS(CENTIMETERS)SIZESVARIATIONFROMMISSESREG246810121416182022CHEST/BUST7.6286.9091.4493.9896.529

15、8.06102.87106.68110.48115.57120.65125.23WAIST22.8683.8288.3689.9091.4493.9897.79101.60105.41110.49115.57120.85HIGHHIP(APPROX4IN.BELOWWAIST)21.59101.60104.14106.65109.22111.78116.57119.36125.19128.27133.35138.43SEAT(HIP)10.1697.79100.33102.87105.41107.95111.78115.57119.38124.48129.54134.62MID-NECK0.0

16、030.6233.6834.2934.6835.5836.5137.4738.4239.6940.9842.29NECKBASE0.0034.2934.9335.5836.2036.8337.7838.7439.6940.9642.2348.50ARMSCYE1.9138.1039.8540.0140.9641.9143.8045.0946.8748.5650.4851.12UPPERARM4.1329.5330.1630.3931.4332.0733.6233.9734.9836.5138.1039.05ELBOW1.9125.7228.0426.3626.6726.9927.5228.28

17、29.0929.8530.8031.12WRIST0.0014.6114.9215.2415.5615.9816.1916.5116.8317.1517.4817.76THIGH-MAX4.4553.9856.5259.0561.6064.1468.6869.2272.8975.2578.1181.26THIGH-MIN3.1846.2650.8953.3455.8856.4259.0563.5066.6869.2272.3075.57KNEE0.0033.0234.2935.8636.5338.1039.3740.8441.9143.1344.4545.72CALF0.9531.7533.0

18、234.2935.5836.8338.1039.3740.8441.9143.1644.45ANKLE0.6421.9122.5423.5923.8124.4525.0825.7226.3526.9927.6228.26TRUNK(TOTALTRUNK,TORSO)12.70157.48161.29165.10168.91170.13176.53180.34184.15187.09191.77195.58TOTALCROTCH11.4378.1180.0181.9283.5285.7387.8889.5491.4493.3595.2597.16VERTICALMEASUREMENTS(CENT

19、IMETERS)SIZESVARIATIONFROMMISSESREG246810121416182022CERVICALEHEIGHT0.00136.43138.70140.97142.24143.51144.78146.06147.32148.59149.80151.13WAISTHEIGHT2.54102.24102.87103.51104.14104.78105.41106.05106.88107.22107.95108.59HIPHEIGHT0.0079.3880.0180.6581.2881.9282.5583.1983.6284.4685.0986.73CROTCHHEIGHT(

20、INSEAM)0.0074.9374.9374.9374.9374.9374.9374.9374.9374.9374.9374.93KNEEHEIGHT0.0044.7745.0945.4045.7246.0446.3646.6746.9947.3147.8347.94ANKLEHEIGHT0.006.996.996.996.996.996.996.996.996.996.996.99CENTERFRONTWAISTLENGTH0.6434.5935.5638.2038.6337.4738.1038.7439.3740.0140.6441.38CENTERBACKWAISTLENGTH0.64

21、40.0140.6441.2541.9142.6543.1843.8244.4846.0946.7246.95TRUERISE0.0024.7725.4026.0426.8727.3127.9428.5629.2129.5530.4831.12WIDTHgarment sizes; maternity apparelASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this stand

22、ard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be review

23、ed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible

24、 technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org).D7197064

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 标准规范 > 国际标准 > ASTM

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1