1、BS EN 16836-2:2016Communication systems for meters Wireless mesh networking for meter data exchangePart 2: Networking layer and stack specificationBSI Standards PublicationWB11885_BSI_StandardCovs_2013_AW.indd 1 15/05/2013 15:06BS EN 16836-2:2016 BRITISH STANDARDNational forewordThis British Standar
2、d is the UK implementation of EN 16836-2:2016. The UK participation in its preparation was entrusted to TechnicalCommittee PEL/894, Remote Meter Reading.A list of organizations represented on this committee can be obtained on request to its secretary.This publication does not purport to include all
3、the necessary provisions of a contract. Users are responsible for its correct application. The British Standards Institution 2016.Published by BSI Standards Limited 2016ISBN 978 0 580 85159 9 ICS 33.200; 35.100.10; 35.100.30 Compliance with a British Standard cannot confer immunity from legal obliga
4、tions.This British Standard was published under the authority of the Standards Policy and Strategy Committee on 30 November 2016.Amendments/corrigenda issued since publicationDate T e x t a f f e c t e dBS EN 16836-2:2016EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 16836-2 November 2016 ICS
5、33.200; 35.100.10; 35.100.30 English Version Communication systems for meters - Wireless mesh networking for meter data exchange - Part 2: Networking layer and stack specification Systmes de communication des compteurs - Rseau maill sans fil pour lchange de donnes de compteurs - Partie 2 : Spcificat
6、ions des couches rseau et de la pile de protocoles Kommunikationssysteme fr Zhler - Drahtloses Mesh-Netzwerk fr den Zhlerdatenaustausch - Teil 2: Vermittlungsschicht und Stapel-Spezifikation This European Standard was approved by CEN on 3 September 2016. CEN members are bound to comply with the CEN/
7、CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Cent
8、re or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the
9、 official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherl
10、ands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey andUnited Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels 2016 CEN All rights
11、 of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 16836-2:2016 EBS EN 16836-2:2016EN 16836-2:2016 (E) 2 Contents Page European foreword . 3 Introduction 4 1 Scope 5 2 Normative references 5 3 Terms, definitions, acronyms and abbreviations 5 4 Requ
12、irements . 5 Bibliography 6 BS EN 16836-2:2016EN 16836-2:2016 (E) 3 European foreword This document (EN 16836-2:2016) has been prepared by Technical Committee CEN/TC 294 “Communication systems for meters”, the secretariat of which is held by DIN. This European Standard shall be given the status of a
13、 national standard, either by publication of an identical text or by endorsement, at the latest by May 2017, and conflicting national standards shall be withdrawn at the latest by May 2017. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
14、rights. CEN shall not be held responsible for identifying any or all such patent rights. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association. According to the CEN-CENELEC Internal Regulations, the national standards organisa
15、tions of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Mal
16、ta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom. BS EN 16836-2:2016EN 16836-2:2016 (E) 4 Introduction The EN 16836 series of standards details requirements for gas meters, water meters and heat meters that can interope
17、rate with products in a mesh network that conform to this standard through a smart energy profile application layer. This standard refers to documents made freely available by the ZigBee Alliance, an organization that manages a mesh network specification (see www.zigbee.org/about/centc294). This ser
18、ies of standards specifies how a mesh networking radio specification applies within the scope of European standards at the application layer, networking layer and also medium access control/physical layer (MAC/PHY). EN 16836 consists of the following parts: EN 16836-1, Communication systems for mete
19、rs Wireless mesh networking for meter data exchange Part 1: Introduction and standardization framework EN 16836-2, Communication systems for meters Wireless mesh networking for meter data exchange Part 2: Networking layer and stack specification EN 16836-3, Communication systems for meters Wireless
20、mesh networking for meter data exchange Part 3: Energy profile specification dedicated application layer This standard series is created in compliance with the terms of a memorandum of understanding (MOU) between CEN/CELELEC and the ZigBee Alliance. The principles underpinning the relationship betwe
21、en CEN/CENELEC and the ZigBee Alliance are described in the Consortium Bridge procedure. A copy of the MOU and the Consortium Bridge can be obtained from CEN/CENELEC. NOTE The term ZigBee and the ZigBee Logo are registered trademarks of the ZigBee Alliance and their use is subject to the conditions
22、of membership. BS EN 16836-2:2016EN 16836-2:2016 (E) 5 1 Scope This European Standard specifies the requirements for the medium access control/physical layer (MAC/PHY) and networking layer of a communication protocol for the exchange of data from metering devices to other devices within a mesh netwo
23、rk. This standard makes reference to a number of documents whereby core requirements are specified. This referencing is in compliance with the Bridge Consortium and additionally the Memorandum of Understanding between the ZigBee Alliance and CEN/CENELEC. 2 Normative references The following document
24、s, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 16836-1:2016, Communicatio
25、n systems for meters and remote reading of meters Wireless mesh networking for meter data exchange Part 1: Introduction and standardization framework ZigBee Specification 05-3474 Rev 20, September 7, 2012 ZigBee Pro Stack Profile 07-4855 Rev 05, January 2008 NOTE The above ZigBee documents can be ob
26、tained from www.zigbee.org/about/centc294. 3 Terms, definitions, acronyms and abbreviations For the purposes of this document, the terms, definitions, acronyms and abbreviations given in ZigBee Specification 05-3474 Rev 20 and ZigBee Pro Stack Profile 07-4855 Rev 05 apply. 4 Requirements The MAC/PHY
27、 and networking layer of the communication protocol for the exchange of data from metering devices to other devices within a mesh network shall conform to the requirements given in the following: EN 16836-1:2016, Communication systems for meters and remote reading of meters Wireless mesh networking
28、for meter data exchange Part 1: Introduction and standardization framework ZigBee Specification 05-3474 Rev 20, September 7, 2012 ZigBee Pro Stack Profile 07-4855 Rev 05, January 2008 BS EN 16836-2:2016EN 16836-2:2016 (E) 6 Bibliography 1 IEEE 802.15.4:2003, IEEE Standard for Information technology
29、Telecommunications and information exchange between systems Local and metropolitan area networks Specific requirements Part 15.4: Wireless Medium Access Control (MAC) and Physical Layer (PHY) Specifications for Low Rate Wireless Personal Area Networks (LR-WPANs) This page deliberately left blankBSI
30、is the national body responsible for preparing British Standards and other standards-related publications, information and services.BSI is incorporated by Royal Charter. British Standards and other standardization products are published by BSI Standards Limited.British Standards Institution (BSI)Abo
31、ut usWe bring together business, industry, government, consumers, innovators and others to shape their combined experience and expertise into standards -based solutions.The knowledge embodied in our standards has been carefully assembled in a dependable format and refined through our open consultati
32、on process. Organizations of all sizes and across all sectors choose standards to help them achieve their goals.Information on standardsWe can provide you with the knowledge that your organization needs to succeed. Find out more about British Standards by visiting our website at or contacting our C
33、ustomer Services team or Knowledge Centre.Buying standardsYou can buy and download PDF versions of BSI publications, including British and adopted European and international standards, through our website at where hard copies can also be purchased. If you need international and foreign standards fr
34、om other Standards Development Organizations, hard copies can be ordered from our Customer Services team.Copyright in BSI publicationsAll the content in BSI publications, including British Standards, is the property of and copyrighted by BSI or some person or entity that owns copyright in the inform
35、ation used (such as the international standardization bodies) and has formally licensed such information to BSI for commercial publication and use.Save for the provisions below, you may not transfer, share or disseminate any portion of the standard to any other person. You may not adapt, distribute,
36、 commercially exploit, or publicly display the standard or any portion thereof in any manner whatsoever without BSIs prior written consent.Storing and using standardsStandards purchased in soft copy format: A British Standard purchased in soft copy format is licensed to a sole named user for persona
37、l or internal company use only. The standard may be stored on more than 1 device provided that it is accessible by the sole named user only and that only 1 copy is accessed at any one time. A single paper copy may be printed for personal or internal company use only.Standards purchased in hard copy
38、format: A British Standard purchased in hard copy format is for personal or internal company use only. It may not be further reproduced in any format to create an additional copy. This includes scanning of the document.If you need more than 1 copy of the document, or if you wish to share the documen
39、t on an internal network, you can save money by choosing a subscription product (see Subscriptions).Reproducing extractsFor permission to reproduce content from BSI publications contact the BSI Copyright & Licensing team.SubscriptionsOur range of subscription services are designed to make using stan
40、dards easier for you. For further information on our subscription products go to British Standards Online (BSOL) youll have instant access to over 55,000 British and adopted European and international standards from your desktop. Its available 24/7 and is refreshed daily so youll always be up to da
41、te. You can keep in touch with standards developments and receive substantial discounts on the purchase price of standards, both in single copy and subscription format, by becoming a BSI Subscribing Member. PLUS is an updating service exclusive to BSI Subscribing Members. You will automatically rece
42、ive the latest hard copy of your standards when theyre revised or replaced. To find out more about becoming a BSI Subscribing Member and the benefits of membership, please visit a Multi-User Network Licence (MUNL) you are able to host standards publications on your intranet. Licences can cover as f
43、ew or as many users as you wish. With updates supplied as soon as theyre available, you can be sure your documentation is current. For further information, email .RevisionsOur British Standards and other publications are updated by amendment or revision. We continually improve the quality of our pro
44、ducts and services to benefit your business. If you find an inaccuracy or ambiguity within a British Standard or other BSI publication please inform the Knowledge Centre.Useful ContactsCustomer ServicesTel: +44 345 086 9001Email (orders): Email (enquiries): SubscriptionsTel: +44 345 086 9001Email: Knowledge CentreTel: +44 20 8996 7004Email: Copyright & LicensingTel: +44 20 8996 7070Email: NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Group Headquarters389 Chiswick High Road London W4 4AL UKBSI Back Cover.indd 1 27/01/2016 14:20
