1、BRITISH STANDARD BS EN 61009-2-1:1995 Incorporating Amendment No. 1 Specification for Residual current operated circuit-breakers with integral overcurrent protection for household and similar uses (RCBOS) Part 2-1: Applicability of the general rules to RCBOs functionally independent of line voltage
2、The European Standard EN 61009-2-1:1994, with the incorporation of amendment A11:1998, has the status of a British Standard ICS 29.120.50 BS EN 61009-2-1:1995 This British Standard, having been prepared under the direction of the Electrotechnical Sector Board, was published under the authority of th
3、e Standards Board and comes into effect on 15 March 1995 BSI 18 March 2005 The following BSI references relate to the work on this British Standard: Committee reference PEL/23 Draft for comment 88/22488 DC ISBN 0 580 23558 0 Cooperating organizations The European Committee for Electrotechnical Stand
4、ardization (CENELEC), under whose supervision this European Standard was prepared, comprises the national committees of the following countries: Austria Italy Belgium Luxembourg Denmark Netherlands Finland Norway France Portugal Germany Spain Greece Sweden Iceland Switzerland Ireland United Kingdom
5、Amendments issued since publication Amd. No. Date Comments Amd 15549 18 March 2005 Revision to EN foreword and Clause 9BS EN 61009-2-1:1995 BSI 18 March 2005 i Contents Page Cooperating organizations Inside front cover National foreword ii Foreword 2 Text of EN 61009-2-1 3 National annex NA (informa
6、tive) Committees responsible 5BS EN 61009-2-1:1995 ii BSI 18 March 2005 National foreword This British Standard has been prepared under the direction of the Electrotechnical Sector Board and is the English language version of EN 61009-2-1 Residual current operated circuit-breakers with integral over
7、current protection for household and similar uses (RCBOs), Part 2-1, Applicability of the general rules to RCBOs functionally independent of line voltage, including amendment A11:1998, published by the European Committee for Electrotechnical Standardization (CENELEC). It is identical with IEC 61009-
8、2-1:1991 published by the International Electrotechnical Commission (IEC). This British Standard is one of a series in which the other publications are as follows: BS EN 61009-1:1995, Residual current operated circuit-breakers with integral overcurrent protection for household and similar uses (RCBO
9、s) Part 1: General rules BS IEC 1009-2-2:1991 Residual current operated current-breakers with integral overcurrent protection for household and similar uses (RCBOs) Part 2-2: Applicability of the general rules to RCBOs functionally dependent on line voltage Cross-references The British Standards whi
10、ch implement international or European publications referred to in this document may be found in the BSI Catalogue under the section entitled “International Standards Correspondence Index”, or by using the “Search” facility of the BSI Electronic Catalogue or of British Standards Online. This publica
11、tion does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover,
12、 pages i and ii, the EN title page, pages 2 to 5 and a back cover. The BSI copyright notice displayed in this document indicates when the document was last issued.EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 61009-2-1 August 1994 + A11 April 1998 UDC 621.316.573:621.316.9:620.1 ICS 29.120.50
13、 Descriptors: Electrical household accessory, low voltage equipment, residual current operated circuit-breakers, overcurrent protection, definition, characteristics, construction, tests English version Residual current operated circuit-breakers with integral overcurrent protection for household and
14、similar uses (RCBOs) Part 2-1: Applicability of the general rules to RCBOs functionally independent of line voltage (IEC 1009-2-1:1991) (includes amendment A11:1998) Interrupteurs automatiques courant diffrentiel rsiduel avec protection contre les surintensits incorpore pour installations domestique
15、s et analogues (DD) Partie 2-1: Applicabilit des rgles gnrales aux DD fonctionnellement indpendants de la tension dalimentation (inclut lamendement A11:1998) (CEI 1009-2-1:1991) Fehlerstrom-Schutzschalter mit berstromauslser (RCBOs) fr Hausinstallationen und fr hnliche Anwendungen Teil 2-1: Anwendba
16、rkeit der Festlegungen fr die Funktion des RCBOs unabhngig von der Netzspannung (enthlt nderung A11:1998) (IEC 1009-2-1:1991) This European Standard was approved by CENELEC on 1994-03-08, amendment A11 was approved by CENELEC on 1998-04-01. CENELEC members are bound to comply with the CEN/CENELEC In
17、ternal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC
18、 member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions. CE
19、NELEC members are the national electrotechnical committees of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CENELEC European Committee for Electrotechnical Standardizatio
20、n Comit Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: rue de Stassart 35, B-1050 Brussels 1994 Copyright reserved to CENELEC members Ref. No. EN 61009-2-1:1994 + A11:1998 EEN 61000-2-1:1994 BSI 18 March 2005 2 Foreword The text of the
21、 International Standard IEC 61009-2-1:1990, which makes reference to and finds application with IEC 61009-1:1990, was submitted to the Unique Acceptance Procedure (UAP) for acceptance as a European Standard simultaneously with the UAP on prEN 61009-1. As the UAP on prEN 61009-1, for which common mod
22、ifications had been prepared by Technical Committee CENELEC TC 23E, Circuit-breakers and similar equipment for household and similar use, did not obtain a sufficient number of positive votes, neither document was accepted. On the basis of the common modifications added in the revised prEN 61009-1, n
23、o changes to IEC 61009-2-1 were necessary and the document was submitted to the formal vote. The new draft was approved by CENELEC as EN 61009-2-1 on 1994-03-08. The following dates were fixed: For products which have complied with the relevant national standard before 2000-07-01, as shown by the ma
24、nufacturer or by a certification body, this previous standard may continue to apply for production until 2005-07-01. Conformity of products with the requirements of this standard ensures conformity with the essential requirements of Directive 73/23/EEC (Low Voltage Directive) and its amendment 93/68
25、/EEC. There are no special national conditions or A-deviations to this European Standard other than those listed in EN 61009-1:1994. Foreword to amendment A1 This amendment was prepared by the Technical Committee CENELEC TC 23E, Circuit breakers and similar devices for household and similar applicat
26、ions. The text of the draft was submitted to the Unique Acceptance Procedure and was approved by CENELEC as amendment A11 to EN 61009-2-1:1994 on 1998-04-01 The following dates were fixed: Contents Page Foreword 2 Introduction 3 1S c o p e 3 2 Normative references 3 3 Definitions 3 4 Classification
27、3 5 Characteristics of RCBOs 3 6 Marking and other product information 3 7 Standard conditions for operation in service and for installation 3 8 Requirements for construction and operation 3 9T e s t s 4 latest date of publication of an identical national standard (dop) 1996-07-01 latest date of wit
28、hdrawal of conflicting national standards (dow) 2000-07-01 latest date by which the amendment has to be implemented at national level by publication of an identical national standard or by endorsement (dop) 1998-11-01 latest date by which the national standards conflicting with the amendment have to
29、 be withdrawn (dow) 2003-03-01EN 61000-2-1:1994 BSI 18 March 2005 3 Introduction This Part of IEC 61009 supplements or modifies the corresponding clauses in IEC 61009-1 to cover its applicability to RCBOs functionally independent of line voltage. 1 Scope This clause of Part 1 is applicable, except a
30、s follows: Replace the first paragraph by the following: This International Standard applies to residual current operated circuit-breakers with integral overcurrent protection (RCBOs) functionally independent of line voltage, for household and similar uses incorporating overcurrent protection having
31、 rated voltages not exceeding 440 V a.c., rated currents not exceeding 125 A and rated short-circuit capacities not exceeding 25 000 A, for operation at 50 Hz or 60 Hz. 2 Normative references This clause of Part 1 is applicable. 3 Definitions This clause of Part 1 is applicable except that definitio
32、ns 3.3.9, 3.4.22, 3.4.22.1 and 3.4.22.2 do not apply. 4 Classification This clause of Part 1 is applicable except 4.1.2. 5 Characteristics of RCBOs This clause of Part 1 is applicable except that the last two lines of 5.1 do not apply. 6 Marking and other product information This clause of Part 1 is
33、 applicable except that letter o) does not apply. 7 Standard conditions for operation in service and for installation This clause of Part 1 is applicable. 8 Requirements for construction and operation This clause of Part 1 is applicable except that 8.12 does not apply.EN 61000-2-1:1994 4 BSI 18 Marc
34、h 2005 9 Tests This clause of Part 1 is applicable except as follows: In case there are no electronic components connected between phase poles and/or between phase poles and the neutral pole, the RCBO is loaded with rated current at any convenient voltage. In Table 7 of 9.1.1 the 15th dashed text (r
35、eferring to the test of 9.17) does not apply. Note 3 of 9.7.4 does not apply. 9.9.1.5 does not apply. The last but one paragraph of 9.12.2 and the last paragraph of 9.12.13.2 do not apply. 9.17 does not apply. The last paragraph of 9.18 does not apply. Figures The figures of Part 1 are applicable. A
36、nnexes The annexes of Part 1 are applicable except that, in Table A.1 of Annex A, the text “9.17 Behaviour in the case of failure of the line voltage” (referred to test sequence D1) does not apply and that, in Annex IB, the last two symbols do not apply.BS EN 61009-2-1:1995 BSI 18 March 2005 5 Natio
37、nal annex NA (informative) Committees responsible The United Kingdom participation in the preparation of this European Standard was entrusted by the Electrotechnical Sector Board to Technical Committee PEL/23 upon which the following bodies were represented: ASTA Certification Services Association o
38、f Consulting Engineers Association of Control Manufacturers TACMA (BEAMA Ltd.) British Lawnmower Manufacturers Federation Consumer Policy Committee of BSI Consumers Association Department of Trade and Industry (Consumer Safety Unit) ERA Technology Ltd. Electrical Installation Equipment Manufacturers
39、 Association (BEAMA Ltd.) Electricity Association Federation of the Electronics Industry Institution of Electrical Engineers Institution of Mechanical Engineers National Inspection Council for Electrical Installation Contracting National Quality Assurance Portable Electric Tool Manufacturers Associa
40、tionBS EN 61009-2-1:1995 BSI 389 Chiswick High Road London W4 4AL BSI British Standards Institution BSI is the independent national body responsible for preparing British Standards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Re
41、visions British Standards are updated by amendment or revision. Users of British Standards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or
42、ambiguity while using this British Standard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel: +44 (0)20 8996 9000. Fax: +44 (0)20 8996 7400. BSI offers members an individual updating service called PLUS which ensures
43、 that subscribers automatically receive the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel: +44 (0)20 8996 9001. Fax: +44 (0)20 8996 7001. Email: ordersbsi-. Standards are also availabl
44、e from the BSI website at http:/www.bsi-. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as British Standards, unless otherwise requested. Information on standards BSI provides a wide range of information on nati
45、onal, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel: +44 (0)20 8996 7111. Fax: +44 (0)20 899
46、6 7048. Email: infobsi-. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership Administration. Tel: +44 (0)20 8996 7002. Fax: +44 (0)20 8996 7001. Ema
47、il: membershipbsi-. Information regarding online access to British Standards via British Standards Online can be found at http:/www.bsi- Further information about BSI is available on the BSI website at http:/www.bsi-. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright
48、, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise w
49、ithout prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and size, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. Details and advice can be obtaine
