1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationBS ISO 16000-6:2011Indoor airPart 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TAsorbent, thermal desorption and gas
2、chromatography using MS or MS-FIDBS ISO 16000-6:2011 BRITISH STANDARDNational forewordThis British Standard is the UK implementation of ISO 16000-6:2011. The UK participation in its preparation was entrusted to T e c h n i c a l Committee EH/2/3, Ambient atmospheres.A list of organizations represent
3、ed on this committee can be obtained on request to its secretary.This publication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. The British Standards Institution 2012Published by BSI Standards Limited 2012ISBN 978 0 580 689
4、97 0 ICS 13.040.20 Compliance with a British Standard cannot confer immunity from legal obligations.This British Standard was published under the authority of the Standards Policy and Strategy Committee on 31 March 2012.Amendments issued since publicationDate T e x t a f f e c t e dBS ISO 16000-6:20
5、11Reference numberISO 16000-6:2011(E)ISO 2011INTERNATIONAL STANDARD ISO16000-6Second edition2011-12-01Indoor air Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TAsorbent, thermal desorption and gas chromatography using MS or MS-FID Air
6、intrieur Partie 6: Dosage des composs organiques volatils dans lair intrieur des locaux et chambres dessai par chantillonnage actif sur le sorbant Tenax TA, dsorption thermique et chromatographie en phase gazeuse utilisant MS ou MS-FID BS ISO 16000-6:2011ISO 16000-6:2011(E) COPYRIGHT PROTECTED DOCUM
7、ENT ISO 2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body
8、in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2011 All rights reservedBS ISO 16000-6:2011ISO 16000-6:2011(E) ISO 2011 All rights reserved iii
9、Contents Page Foreword iv Introduction vi 1 Scope 1 2 Normative references 1 3 Terms and definitions . 1 4 Principle . 2 5 Reagents and materials 2 6 Apparatus . 4 7 Conditioning and storage of sorbent tubes 6 7.1 Conditioning 6 7.2 Storage of conditioned sorbent tubes before sampling . 6 8 Sampling
10、 6 8.1 Indoor air sampling . 6 8.2 Test chamber air sampling . 6 8.3 Sampling volumes . 7 8.4 Storage of loaded samples . 7 8.5 Field blanks 7 9 Analysis 7 9.1 General . 7 9.2 Thermal desorption . 8 9.3 Temperature programme 8 9.4 Analysis of the samples 8 10 Identification of single VOCs . 8 11 Con
11、centration of analytes in the sampled air 9 11.1 General . 9 11.2 Volatile organic compounds 9 11.3 Total volatile organic compounds . 10 11.4 VVOC and SVOC compounds observed outside the TVOC range . 10 12 Performance characteristics 11 13 Test report 12 14 Quality control . 12 Annex A (informative
12、) Examples of compounds detected in indoor air and from building products in test chambers 13 Annex B (informative) Safe sampling volumes for selected organic vapours sampled on Tenax TA19 Annex C (informative) Storage recovery of solvents on Tenax TAsorbent tubes . 21 Annex D (informative) Determin
13、ation of very volatile and semi-volatile organic compounds in conjunction with volatile organic compounds . 23 Bibliography 28 BS ISO 16000-6:2011ISO 16000-6:2011(E) iv ISO 2011 All rights reservedForeword ISO (the International Organization for Standardization) is a worldwide federation of national
14、 standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. Internationa
15、l organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules
16、given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at lea
17、st 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 16000-6 was prepared by Technical Committee ISO/TC 1
18、46, Air quality, Subcommittee SC 6, Indoor air. This second edition cancels and replaces the first edition (ISO 16000-6:2004), which has been technically revised. ISO 16000 consists of the following parts, under the general title Indoor air: Part 1: General aspects of sampling strategy Part 2: Sampl
19、ing strategy for formaldehyde Part 3: Determination of formaldehyde and other carbonyl compounds in indoor air and test chamber air Active sampling method Part 4: Determination of formaldehyde Diffusive sampling method Part 5: Sampling strategy for volatile organic compounds (VOCs) Part 6: Determina
20、tion of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TAsorbent, thermal desorption and gas chromatography using MS or MS-FID Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations Part 8: Determination of local mean ages of air
21、in buildings for characterizing ventilation conditions Part 9: Determination of the emission of volatile organic compounds from building products and furnishing Emission test chamber method Part 10: Determination of the emission of volatile organic compounds from building products and furnishing Emi
22、ssion test cell method Part 11: Determination of the emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test specimens Part 12: Sampling strategy for polychlorinated biphenyls (PCBs), polychlorinated dibenzo-p-dioxins (PCDDs),
23、 polychlorinated dibenzofurans (PCDFs) and polycyclic aromatic hydrocarbons (PAHs) BS ISO 16000-6:2011ISO 16000-6:2011(E) ISO 2011 All rights reserved v Part 13: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins/dibenzo
24、furans (PCDDs/PCDFs) Collection on sorbent-backed filters Part 14: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDDs/PCDFs) Extraction, clean-up and analysis by high-resolution gas chromatography an
25、d mass spectrometry Part 15: Sampling strategy for nitrogen dioxide (NO2) Part 16: Detection and enumeration of moulds Sampling by filtration Part 17: Detection and enumeration of moulds Culture-based method Part 18: Detection and enumeration of moulds Sampling by impaction Part 19: Sampling strateg
26、y for moulds Part 23: Performance test for evaluating the reduction of formaldehyde concentrations by sorptive building materials Part 24: Performance test for evaluating the reduction of volatile organic compound (except formaldehyde) concentrations by sorptive building materials Part 25: Determina
27、tion of the emission of semi-volatile organic compounds by building products Micro-chamber method Part 26: Sampling strategy for carbon dioxide (CO2) Part 28: Determination of odour emissions from building products using test chambers The following parts are under preparation: Part 21: Detection and
28、 enumeration of moulds Sampling from materials Part 27: Determination of settled fibrous dust on surfaces by SEM (scanning electron microscopy) (direct method) Part 29: Test methods for VOC detectors Part 30: Sensory testing of indoor air Part 31: Measurement of flame retardants and plasticizers bas
29、ed on organophosphorus compounds Phosphoric acid ester Part 32: Investigation of constructions on pollutants and other injurious factors Inspections BS ISO 16000-6:2011ISO 16000-6:2011(E) vi ISO 2011 All rights reservedIntroduction ISO 16000-1 establishes general requirements relating to the measure
30、ment of indoor air pollutants and the important conditions to be observed before or during the sampling of individual pollutants or groups of pollutants. Aspects of the determination (sampling and analysis) and the sampling strategy of specific pollutants or groups of pollutants are specified in the
31、 subsequent parts of ISO 16000 (see Foreword). ISO 16000-5 (dealing with VOC sampling strategy) is a link between ISO 16000-1 (a generic standard establishing the principles) and this part of ISO 16000, which deals with sampling and analytical measurements. ISO 16017 (see Clause 2 and Reference 8) a
32、nd ISO 1221937also focus on volatile organic compound (VOC) measurements. BS ISO 16000-6:2011INTERNATIONAL STANDARD ISO 16000-6:2011(E) ISO 2011 All rights reserved 1Indoor air Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TAsorbent, t
33、hermal desorption and gas chromatography using MS or MS-FID 1 Scope This part of ISO 16000 specifies a method for determination of volatile organic compounds (VOCs) in indoor air and in air sampled for the determination of the emission of VOCs from building products or materials and other products u
34、sed in indoor environments using test chambers and test cells. The method uses Tenax TA1)sorbent with subsequent thermal desorption (TD) and gas chromatographic (GC) analysis13employing a capillary column or columns and a flame ionization detector (FID) and/or a mass spectrometric (MS) detector. The
35、 method is applicable to the measurement of non-polar and slightly polar VOCs at concentrations ranging from sub-micrograms per cubic metre to several milligrams per cubic metre. Using the principles specified in this method, some very volatile compounds (VVOC) and semi-volatile organic compounds (S
36、VOC) can also be analysed (see Annex D). 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendm
37、ents) applies. ISO 16000-1, Indoor air Part 1: General aspects of sampling strategy ISO 16017-1:2000, Indoor, ambient and workplace air Sampling and analysis of volatile organic compounds by sorbent tube/thermal desorption/capillary gas chromatography Part 1: Pumped sampling 3 Terms and definitions
38、For the purposes of this document, the following terms and definitions apply. 3.1 semi-volatile organic compound SVOC organic compound whose boiling point is in the range from (240 C to 260 C) to (380 C to 400 C) NOTE 1 This classification has been defined by the World Health Organization14. 1) Tena
39、x TAis the trade name of a product supplied by Buchem. This information is given for the convenience of users of this document and does not constitute an endorsement by ISO of the product named. Equivalent products may be used if they can be shown to lead to the same results. BS ISO 16000-6:2011ISO
40、16000-6:2011(E) 2 ISO 2011 All rights reservedNOTE 2 Boiling points of some compounds are difficult or impossible to determine because they decompose before they boil at atmospheric pressure. Vapour pressure is another criterion for classification of compound volatility that may be used for classifi
41、cation of organic chemicals15. 3.2 volatile organic compound VOC organic compound whose boiling point is in the range from (50 C to 100 C) to (240 C to 260 C) NOTE 1 This classification has been defined by the World Health Organization14. NOTE 2 Boiling points of some compounds are difficult or impo
42、ssible to determine because they decompose before they boil at atmospheric pressure. Vapour pressure is another criterion for classification of compound volatility that may be used for classification of organic chemicals15. 3.3 very volatile organic compound VVOC organic compound whose boiling point
43、 is in the range from 0 C to (50 C to 100 C) NOTE 1 This classification has been defined by the World Health Organization14. NOTE 2 Boiling points of some compounds are difficult or impossible to determine because they decompose before they boil at atmospheric pressure. Vapour pressure is another cr
44、iterion for classification of compound volatility that may be used for classification of organic chemicals15. 3.4 total volatile organic compounds TVOCs sum of volatile organic compounds, sampled on Tenax TA, which elute between and including n-hexane and n-hexadecane on a non-polar capillary column
45、, detected with a flame ionization detector (TVOC-FID) or mass spectrometric detector (TVOC-MS), and quantified by converting the total area of the chromatogram in that analytical window to a nominal mass using the chromatographic response factor for toluene (toluene equivalents) NOTE While this par
46、t of ISO 16000 specifies the determination of individual VOCs, it is common in practice to generate a single concentration value to characterize the total amount of VOCs present in the air. This value is called the TVOC value (see 11.3 and Clause 13). It should be emphasized that the TVOC value so o
47、btained depends on the sampling and analytical methods used, and therefore should be interpreted taking into account the full description of these methods. 4 Principle A measured volume of sample air is collected from room air, an emission test chamber (see ISO 16000-9) or an emission test cell (see
48、 ISO 16000-10) by drawing through one (or more) sorbent tube containing Tenax TAsorbent. Volatile organic compounds (VOCs) are retained by the sorbent tube, and the compounds are subsequently analysed in the laboratory. The collected VOCs are desorbed by heat and transferred under inert carrier gas
49、via a cold trap or sorbent trap into a gas chromatograph equipped with a capillary column or columns and a flame ionization detector and/or a mass spectrometric detector. 5 Reagents and materials 5.1 Volatile organic compounds for calibration, of chromatographic quality. 5.2 Dilution solvent, for preparing calibration blend solution for liquid spiking, of chromatographic quality, free from compounds co-eluting
