CSN 42 0647 Cast 13-1989 Chemical analysis of non-ferrous metals and alloys Tungsten Determination of mechanical impurities by the gravimetric method《钨 重量法测定机械杂质》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ASTM C1672-17 Standard Test Method for Determination of Uranium or Plutonium Isotopic Composition or Concentration by the Total Evaporation Method Using a Thermal Ionization Mass Spectrometer.pdf

ASTM D6090-17 Standard Test Method for Softening Point Resins (Mettler Cup and Ball Method).pdf

ASTM C203-05a(2017) Standard Test Methods for Breaking Load and Flexural Properties of Block-Type Thermal Insulation.pdf

ASTM D7750-12(2017) Standard Test Method for Cure Behavior of Thermosetting Resins by Dynamic Mechanical Procedures using an Encapsulated Specimen Rheometer.pdf

ASTM A553 A553M-17 Standard Specification for Pressure Vessel Plates, Alloy Steel, Quenched and Tempered 7, 8, and 9 % Nickel.pdf

ASTM D4185-17 Standard Test Method for Measurement of Metals in Workplace Atmospheres by Flame Atomic Absorption Spectrophotometry.pdf

ASTM C1701 C1701M-17a Standard Test Method for Infiltration Rate of In Place Pervious Concrete.pdf

ASTM D6144-17 Standard Test Method for Analysis of AMS (α-Methylstyrene) by Capillary Gas Chromatography.pdf

ASTM B624-07(2017) Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application.pdf