CSN ISO 7252-1994 Paints and varnishes Determination of total mercury Flameless atomic absorption spectrometric method《油漆和清漆 汞总量测定 无焰原子吸收分光光度法》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS 4G 178-2-1986 Crimped joints for aircraft electrical cables and wires - Specification for control of crimping (including user control tests)《飞机电缆电线压接头 第2部分 压接检验规范(包括用户检验试验)》.pdf

BS 4G 198-1-1997 Sleeves for aircraft electric cables and equipment wires - Specification for elastomeric sleeves for binding and identification《飞机电器电缆和设备导线用套管 第1部分 连接和识别用橡胶套管规范》.pdf

BS 4G 198-3-1999 Sleeves and moulded components for aircraft electric cables and equipment wires Specification for heat-shrinkable sleeving for binding insulation and identificatio.pdf

BS 4G 229-1996 Schedule for environmental conditions and test procedures for airborne equipment《机载设备环境条件和试验规程一览表》.pdf

BS 4HR 601-2010 Specification for nickel-chromium-titanium-aluminium heat-resisting alloy bar and wire (maximum diameter or minor sectional dimension of 30 mm) for the manufacture .pdf

BS 4J 10-1991 Specification for pressure-sensitive adhesive water resistant PVC tape《耐水压敏PVC胶粘带规范》.pdf

BS 4J 11-1991 Specification for pressure-sensitive adhesive paper masking tape《压敏胶粘纸带规范》.pdf

BS 4L 54-1986 Specification for tube of 99% aluminium (cold drawn seamless tested hydraulically) (not exceeding 12 mm wall thickness)《99%铝管规范(冷拔 无缝 液压试验)(壁厚不超过12mm)》.pdf

BS 4L 56-1986 Specification for tube of aluminium-21 4% magnesium alloy (temper designation-O) (seamless tested hydraulically) (not exceeding 12 mm wall thickness)《铝-2%镁合金管规范(强度符号-.pdf