CNS 10880-17-1996 Method of Test for Paint Components-Quantitative Test of Phosphoric Acid《涂料成分检验法–磷酸之定量》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ANSI ASTM F1386-1992 Standard Guide for Construction of Sounding Tube and Striker Plate for Tank Sounding.pdf

ANSI ASTM F1387-1999 Standard Specification for Performance of Piping and Tubing Mechanically Attached Fittings《机械连接配件性能规范》.pdf

ANSI ASTM F1409-2016 Standard Test Method for Straight Line Movement of Vacuum Cleaners While Cleaning Carpets.pdf

ANSI ASTM F1410-1998 Standard Test Method for Measuring Maximum Functional Wet Volume of Utility Vacuum Cleaners《测量通用真空吸尘器的最大功能性湿容量的试验方法》.pdf

ANSI ASTM F1411-2011 Standard Practice for Presenting Selected Information on Vacuum Cleaners for Consumer Use.pdf

ANSI ASTM F1412-2016 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems.pdf

ANSI ASTM F1417 REV A-2011 Standard Practice for Installation Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure Air.pdf

ANSI ASTM F1429-1999 Standard Test Method for Assembly Force of Plastic Underground Conduit Joints That Use Flexible Elastomeric Seals Located in the Bell《用柔性合成橡胶密封件固定在套桶中的塑料地下管道接头.pdf

ANSI ASTM F1431-1992 Standard Specification for Water Trap for Diesel Exhaust《内燃机排气用水密封器规范》.pdf