CNS 5939-1980 Standard Scale for Medical Bougie and Catheter《医疗用探针及导管用标准计测板》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

AGMA 14FTM20-2014 Influence of Central Members Radial Support Stiffness on Load Sharing Characteristics of Compound Planetary Gearsets.pdf

AGMA 14FTM21-2014 On the Correlation of Specific Film Thickness and Gear Pitting Life.pdf

AGMA 16FTM14-2016 Impact of Surface Condition and Lubricant on Effective Gear Tooth Friction Coefficient.pdf

AGMA 2000FTM1-2000 Minimization of In-Process Corrosion of Aerospace Gears《航空航天齿轮加工中腐蚀的最小化》.pdf

AGMA 2000FTM10-2000 Bending Fatigue Investigation under Variable Load Conditions on Case Carburized Gears《可变负荷条件下渗碳齿轮的弯曲疲劳调查》.pdf

AGMA 2000FTM11-2000 UltraSafe Gear Systems - Single Tooth Bending Fatigue Test Results《超安全齿轮系统.单齿弯曲疲劳测试结果》.pdf

AGMA 2000FTM12-2000 Finite Strips Methods as an Alternative to the Finite Elements in Gear Tooth Stress and Strain Analysis《在轮齿应力和张力分析中作为有限元替代方法的有限条法》.pdf

AGMA 2000FTM2-2000 Calculation of Optimum Surface Carbon Content for Carburized Case Hardened Gears《渗碳层硬化齿轮最佳表面碳含量的计算》.pdf

AGMA 2000FTM3-2000 Comparison of New Gear Metallurgy Documents ISO 6336-5 and AGMA 923 with Gear Rating Standards AGMA 2001 and 2003《新齿轮冶金文件的对比 ISO 6336-5和AGMA 923 带齿轮分级标准AGMA 2001.pdf