CNS 8799-1990 Electric Bell《电铃》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS ISO 254-2011 Belt drives Pulleys Quality finish and balance《皮带传动 皮带轮 质量、精整和平衡》.pdf

BS ISO 2540-2016 Centre drills for centre holes with protecting chamfer Type B《带护锥的中心孔用中心钻 B型》.pdf

BS ISO 2541-2016 Centre drills for centre holes with radius form Type R《弧形中心孔用中心钻 R型》.pdf

BS ISO 25518-2009 Single-use rubber gloves for general applications - Specification《一般用途一次性使用橡胶手套 规范》.pdf

BS ISO 25577-2013 Information and documentation MarcXchange《信息与文献 Marc交换》.pdf

BS ISO 2558-2010 Textile glass chopped-strand mats for reinforcement of plastics Determination of time of dissolution of the binder in styrene《增强塑料用玻璃纤维短切原丝毡 粘合剂在苯乙烯中溶解时间的测定》.pdf

BS ISO 2559-2011 Textile glass Mats (made from chopped or continuous strands) Designation and basis for specifications《纺织玻璃纤维 垫(由短线或连续的绞捻线制) 名称和基本规范》.pdf

BS ISO 25597-2013 Stationary source emissions Test method for determining PM2 5 and PM10 mass in stack gases using cyclone samplers and sample dilution《固定排放源 利用气旋取样器和样本稀释法测定废气中PM2 .pdf

BS ISO 2561-2012 Plastics Determination of residual styrene monomer in polystyrene (PS) and impact-resistant polystyrene (PSI) by gas chromatography《塑料 用气相色谱法测定聚苯乙烯(PS)和抗冲击聚苯乙烯(PS-.pdf