1、 A-A-55272 9999974 01ib7480 bT3 A-A-5 5 2 7 2 30 MAY 1995 COMMERCIAL ITEM DESCRIPTION CLOTH, PLAIN WEAVE (BASKET VARIATION) POLYESTER AND COTTON (CREASE RESISTANT FINISH) The General Services Administration has authorized the use of this commercial item description as a replacement for MIL-C-29140 f
2、or all Federal agencies. 1. SCOPE. This commercial item description covers the requirements for a polyester and cotton blend fabric treated with a crease resistant finish. The cloth is intended for use in the blue utility shirt worn by Coast Guard personnel. 2. SALIENT CHARACTERISTICS 2.1 General de
3、scriDtion. The material shall be a polyester and cotton blend. The polyester fiber shall be polyethylene glycol terephthalate, semi-dull. The cotton fiber shall be carded and combed. The warp and filling yarns shall be a blend of 65 (+ 5) percent polyester and the remaining percentage cotton, based
4、on the dry weight of the desized and definished specimens. The weave shall be a modified plain weave as shown in Figure 1. The fibers shall be spun into singles yarn for both the warp and filling. be desized, scoured, dyed, heat set, treated with an approved resin, and cured to provide an approved c
5、rease resistant finish and hand equal in characteristic to that of the standard sample. The width of the finished cloth shall be the minimum acceptable width as specified in the contract or purchase order. The color shall be Blue 3362 and The cloth shall Beneficial comments, recommendations, additio
6、ns, deletions, clarifications, etc. and any data which may improve this document should be addressed to: Defense Personnel Support Center, Clothing and Textiles Directorate, Attn: DPSC-FQSD, 2800 South 20th Street, Philadelphia, PA 19145-5099. b FSC 8305 AMSC N/A DISTRIBUTION STATEMENT A. Approved f
7、or public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55272 9999974 0367483 53T A-A-552 7 2 shall match the standard sample. containing elementary sulfur capable of oxidation to sulfuric acid is prohibited.
8、 The finished cloth shall match the standard sample when viewed under filtered tungsten lamps which approximateoartific$al daylight having a correlated color temperature of 7500 +. 200 K, with the illumination of 100 width less than specified; characteristics of finish, hand and shade not equal to t
9、he standard sample; poor dye penetration, mottled, streaky, or cloudy; excessive neppiness. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- A-A-55272 D 9999974 0367484 249 A-A-55272 4.4.1.2 Examination for lenath. During the yard-by-yard examination
10、, each roll in the sample shall be examined for length. Any length found to be less than the minimum specified, or more than two yards less than the length marked on the ticket shall be considered a defect with respect to length. rolls in the sample are defective in respect to length. The lot shall
11、sample is less than the total of the lengths marked on the ticket. The rolls examined shall be those selected for the examination of individual rolls. The lot shall be unacceptable if two or more 0 be unacceptable if the total of the actual length of rolls in the 4.4.1.3 Examination for shade variat
12、ion. During the yard-by-yard examination, each roll in the sample shall be examined for shade variation. Any roll in the sample exhibiting uneven shade, shaded variation side to side, side to center or end to end shall be cause for rejection of the entire lot represented by the sample. 4.4.1.4 Exami
13、nation for face identification, identification of preshrinkase mrocess and non-conformance with the Textile Fiber Products Identification Act. During the yard-by-yard examination, each roll in the sample shall be examined for these defects. The lot shall be unacceptable if two or more rolls in the s
14、ample have face identification missing from either or both ends, two or more rolls in the sample contain identification of the preshrinkage process by name or trademark on the cloth or ticket or two or more rolls in the sample are not labeled or ticketed in accordance with the Textile Fiber Products
15、 Identification Act. 5. PACKAGING 5.1 Preservation, nackina, and markinq. The preservation, packing, and marking shall be as specified in the contract or purchase order. 6. NOTES 6.1 Acceptance criteria. Acceptance criteria shall be as specified in the contract or purchase order. 6.2 Source of Gover
16、nment documents. Copies of military and Federal documents are available from: Department of the Navy Defense Printing Service Detachment Office 700 Robbins Avenue, BLDG 4D Philadelphia, PA 19111-5093 , Rules and Regulations Under the Textile Fiber Products Identification Act - Applications for copie
17、s should be addressed to: Federal Trade Commission Washington, DC 20580 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-6.2.1 A-A-5 5 2 7 2 Source of non-Government documents ASTM Test Methods - Applications for copies should be addressed to: Ameri
18、can Society For Testing and Materials 1916 Race Street Philadelphia, PA 19103-1187 AATCC Test Methods - Applications for copies should be addressed to: American Association of Textile Chemists and Colorists P.O. Box 12215 Triangle Park, NC 2770902215 Sears Fabric Defect Scales and Fabric Defect Repl
19、ica Kits are available from: Sears, Roebuck and Company Department 817, ATTN: BSC 23-29 Sears Tower Chicago, IL 60684 MILITARY INTERESTS: Custodian Coast Guard - CT CIVIL AGENCY COORDINATION ACTIVITY : GSA - FSS PREPARING ACTIVITY: DLA - CT Project 8305-0537 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-FTGURE 1. MODIFIED PLAIN WEAVE Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
